GE PSA29VGXCSS - User Manual

Water Filter Cartridge The water filter cartridge is located in the back upper right corner of the refrigeratorcompartment. When to Replace the Filter There is a replacement indicator light for the water filter cartridge on the temperaturedisplay. This light will turn orange to tell youthat you need...

7 Rearranging the Shelves To remove: Remove all items from the shelf. Tilt the shelf up at the front. Lift the shelf up at the back and bring the shelf out. To replace: While tilting the shelf up, insert the top hook at the back of the shelf in a slot on the track. Lower the front of the shelf until...

Non-Adjustable Bins on the Door To remove: Lift the bin straight up, then pull out. To replace: Engage the bin in the molded supports on the door and push down. It will lockin place. Adjustable Bins on the Door Adjustable bins can easily be carried fromrefrigerator to work area. To remove: Lift bin ...

9 About the crispers and pans. Not all features are on all models. Fruit and Vegetable Crisper Excess water that may accumulate in thebottom of the drawers or under the drawersshould be wiped dry. Adjustable Humidity Crisper (on some models) Slide the control all the way to the HIGH setting to provi...

10 Freezer Shelves and Baskets A shelf above the ice storage bin A half-width basket A shallow full-width basket A deep full-width basket An ice storage bin can be used to store other food items. Basket Removal To remove the shallow full-width basket: Pull the basket out to the stop location. Lift t...

11 Loading the Freezer Compartment Load so that at least 15 mm of space remainsclear between stacks of packages and 15 mm to25 mm of space between the top of any stackand any shelf or basket above it. Packages mayhang over the front of shelves but must remain15 mm from doors. ■ Food to be frozen mus...

12 About the automatic icemaker. Automatic Icemaker (on some models) The icemaker will produce seven cubes per cycle—approximately 100–130 cubes in a 24-hour period, depending on freezercompartment temperature, room temperature,number of door openings and other useconditions. See below for how to ac...

Care and cleaning of the refrigerator. Cleaning the Outside The door handles and trim. Clean with a cloth dampened with soapy water. Dry with a soft cloth.Do not use wax on the door handles and trim. Keep the outside clean. Wipe with a clean cloth lightly dampened with kitchen appliance wax ormild l...

14 Refrigerator Lights CAUTION: Light bulbs may be hot. Unplug the refrigerator. To remove the light shield, grasp the shield at the back and pull out to release the tabs at the back. Rotate the shield down and then forward to release the tabs at the front of the shield. After replacing with an appl...

15 Trim kits and decorator panels. Read these instructions completely and carefully. Before You Begin Some models are equipped with trim kits that allow you to install door panels. Panels less than 6.3 mm thick When installing wood panels less than 6.3 mm thick, you need to create a filler panel, su...

16 Trim kits and decorator panels. 19.1 mm or Raised Panel A raised panel design screwed or glued to a 6.3 mm thick backing, or a 19.1 mm routed board can be used.The raised portion of the panel must be fabricated to permit clearances of at least 5.1 cm from the handleside for fingertip clearance. P...

Installation Refrigerator Instructions Models 21 and 25 BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT — Save these instructions for local inspector’s use. • IMPORTANT — Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructi...

LOCATING THE ANTI-TIP FLOOR BRACKET Place the anti-tip floor bracket locatortemplate (included inside the anti-tip kit)onto the floor up against the rear wall,within W, and in line with the desiredlocation of the RH side of the refrigerator(see Figure 1). Place the anti-tip floor bracket onto theloc...

Installation Instructions LOCATING THE ANTI-TIP FLOOR BRACKET (cont.) 2 Preferred Installation – Wood Preferred Installation – Concrete Minimum Acceptable #1 – Wall Plate Stud Minimum Acceptable #2 – Wood Floor Minimum Acceptable #3 – Concrete Floor Figure 2 – Acceptable Screw Placement Locations CO...

Installation Instructions INSTALLING THE REFRIGERATOR REFRIGERATOR LOCATION • Do not install the refrigerator where thetemperature will go below 16°C because it will notrun often enough to maintain proper temperatures. • Do not install the refrigerator where thetemperature will go above 37°C because...

INSTALLING THE REFRIGERATOR (cont.) Installation Instructions 22 PUT THE REFRIGERATOR IN PLACE Move the refrigerator to its final location. Makesure the back side of the refrigerator engages theanti-tip bracket properly. The anti-tip floor bracketshould line up with the cutout in the back bottomof t...

Installation Instructions REMOVE THE FRESH FOOD DOOR HANDLE (For placement in the installation location orreversal of the handles – on some models) Stainless steel (on some models): REMOVING THE DOORHANDLE: Loosenthe set screwswith the 3/32 ″ Allen wrench and remove the handle. NOTE: For Double Door...

INSTALLING THE REFRIGERATOR (cont.) ATTACH THE FREEZER DOORHANDLE Stainless steel and plastic handles: Attach the handle firmly to the mountingfasteners and tighten the set screws on thebottom of the handle with a 1/8 ″ Allen wrench. A Installation Instructions 24 ATTACH THE FRESH FOOD DOOR HANDLE S...

LEVEL THE REFRIGERATOR The leveling legs have 2 purposes:1) Leveling legs adjust so the refrigeratoris firmly positioned on the floor anddoes not wobble. 2) Leveling legs serve as a stabilizingbrake to hold the refrigerator securelyin position during operation andcleaning. The leveling legs also pre...

26 Installation Instructions REMOVING THE FREEZER DRAWER (on some models) REMOVE THE BASKET Open the freezer drawer until it stops.Cut the 2 wire ties off of the basket withwire cutters.The freezer basket rests inside 4 tabs onthe freezer slides. Lift the basket up andout of the 4 tabs.Tilt the fron...

27 Installation Instructions REPLACING THE FREEZER DRAWER (on some models) ATTACH AND SECURE THEDRAWER FRONT TO THE SLIDES Pull out the rail assemblies to the fulllength on each side of the cabinet. Drive the top screw into the door on eachside until it is 1/2 way in. Hang the drawer front onto open...

TOOLS YOU WILL NEED Installation Instructions REVERSING THE DOOR SWING (Single Door Refrigerator Models only) IMPORTANT NOTES When reversing the door swing: NOTE: Door swing is not reversible on stainless steel models. • Read the instructions all the way throughbefore starting. • Parts are included ...

Installation Instructions REMOVE CENTER HINGE Using a 5/16 ″ socket ratchet/driver, remove the bolts securing the centerhinge to the cabinet. Set the hinge and bolts aside. 2 29 INSTALL CENTER HINGE Transfer the plug button and screw holecover in the hinge holes on the left side tothe right side. In...

REHANG REFRIGERATOR DOOR Lower the refrigerator door onto thecenter hinge pin. Ensure that the plastichinge pin thimble is on the center hingepin or inside door hinge pin hole locatedin the bottom of the door. Insert the top hinge pin into the hinge holeon top of the refrigerator door. Make surethe ...

Installation Instructions REMOVING THE DOORS (Double Door Refrigerator Models only) IMPORTANT NOTES NOTE: Door swing is not reversible. • Read the instructions all the way throughbefore starting. • Handle parts carefully to avoid scratchingpaint. • Set screws down by their related parts toavoid usin...

REMOVE THEREFRIGERATOR DOORS (cont.) Remove the hinge cover on top of therefrigerator door by removing the Phillipshead screws and pulling it up.Using a 5/16 ″ socket ratchet/driver, remove the bolts securing the top hinge tothe cabinet. Then lift the hinge straight upto free the hinge pin from the ...

Installation Instructions REPLACING THE DOORS (Double Door Refrigerator Models only) INSTALL CENTER HINGE Install the center hinge on each side. REHANG REFRIGERATOR DOORS Lower the refrigerator door onto thecenter hinge pin. Ensure that the plastichinge pin thimble is on the center hingepin or insid...

34 Normal operating sounds. Before you call for service… Troubleshooting Tips Save time and money! Review the charts on the followingpages first and you may not need to call for service. Newer refrigerators sound different from older refrigerators. Modern refrigerators have more features and use new...

36 Before you call for service… Troubleshooting Tips Problem Possible Causes What To Do Ice cubes have Food transmitting odor/taste • Wrap foods well. odor/taste to ice cubes. Interior of refrigerator • See Care and cleaning. needs cleaning. • Keep an open box of baking soda in the refrigerator; rep...

39 Special Safety Instructions for Australia and New Zealand. (in addition to other information in Owner’s Manual) IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of personal injury or damage to property, follow basic safety precautions when using thisrefrigerator, including the following: When usi...

40 Special Installation Instructions for Australia and New Zealand. Installing the Water Line For Australian and New Zealand installation, read these instructions completely and carefully. ■ ■ IMPORTANT: Government legislation and Codes in most States and Territories of Australia require installatio...

41 Attach the fitting with the male thread suppliedwith the water supply kit to the shutoff valve (orpressure limiting valve, if fitted), and tighten. NOTE: PTFE tape should be used for a water tight seal when assembling all the above fittings. Route the tubing through a hole drilled in the sideof t...

42 Special Installation Instructions for Australia and New Zealand. Turn the water On at the shutoff valve. Tighten any connection that leaks. Replace the access cover and tighten all screws (on some models). Turn the Water On Plug in the refrigerator to the Power Outlet andturn On . IMPORTANT: Alwa...

43 Manufactured for: General Electric Company, Louisville, KY 40225 Performance Data Sheet SmartWater Filtration System GSWF Cartridge This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.The concentration of the indicated substances in water entering ...

44 State of California Department of Health Services Water Treatment Device Certificate Number Date Issued: April 28, 2003 Trademark/Model Designation Replacement Elements 1559 03 - GE GSWF GSWF Manufacturer: General Electric Consumer Products The water treatment device(s) listed on this certificate...