GE PEB7227DL1WW - Installation Manual

GE PEB7227DL1WW – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – CUTOUT DIMENSIONS; Installation Instructions; GROUNDING INSTRUCTIONS; WARNING; ELECTRICAL REQUIREMENTS
Page 3 – LOCATE AND INSTALL
Page 4 – INSTALL THE TRIM FRAME
Page 5 – visite nuestro sitio web en:; CONSERVE ESTAS INSTRUCCIONES.; Instrucciones; Kits Ajustables para Empotrar; de Instalación; ANTES DE COMENZAR; IMPORTANTE –; Nota para el Instalador –; HERRAMIENTAS QUE; PIEZAS INCLUIDAS
Page 6 – Instrucciones de Instalación; DIMENSIONES DEL RECORTE; PRECAUCIÓN; REQUISITOS ELÉCTRICOS

Loading the manual

Part

Quantity

Trim Frame

Screw Covers

Base Pan

Upper Bracket

Rail

Bottom

Bracket

Phillips Round-

Head Screws

(19 required

for installation)

Phillips Round-

Head Flat-

tipped Screws

(4 required for

installation)

PARTS INCLUDED

Questions?

Call GE Answer Center at 800.626.2000

Visit our Website at:

www.GEAppliances.com

READ CAREFULLY.
KEEP THESE INSTRUCTIONS

Installation

Built-In Trim Kits

Instructions

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•

IMPORTANT –

Save these

instructions for local inspector’s use.

•

IMPORTANT –

Observe all

governing codes and ordinances.

•

Note to Installer –

Be sure to leave these

instructions with the Consumer.

•

Note to Consumer –

Keep these instructions

for future reference.

• For easier installation and personal safety, we

recommend that two people install this microwave oven.

• Unplug the microwave oven before attempting

installation of this kit.

•

Skill level

– Installation of this appliance requires

basic mechanical and electrical skills.

•

Completion time

– 1-3 hours

• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not

covered under the Warranty.

•

This kit and microwave are approved for installation

alone or above any single electric wall oven. Do not

mount adjacent (within 2 feet) to any range, cooktop,

gas oven, or other microwave.

TOOLS YOU WILL NEED

#2 Phillips

screwdriver

Pencil

Tape measure

Level

Small flathead

screwdriver

Drill with

” bit or #35

FOR YOUR SAFETY

WARNING

Before beginning the installation,

switch power off at service panel and lock the

service disconnecting means to prevent power from

being switched on accidentally. When the service

disconnecting means cannot be locked, securely

fasten a prominent warning device, such as a tag, to

the service panel.

WARNING

This oven must be plugged into a

properly grounded 3-hole, 120 volt receptacle as

required by the National Electric Code.

MODELS

30” Profile Kit:

JX7230DLWW, JX7230DLBB,

JX7230ELES, JX7230SLSS, JX7230BLTS

27” Profile Kit:

JX7227DLWW, JX7227DLBB,

JX7227ELES, JX7227SLSS, JX7227BLTS

Monogram Kit:

ZX2130SLSS, ZX2127SLSS

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand: GE
Model: PEB7227DL1WW
Document type: Installation Manual
Language(s): English
Pages: 8
File size: 328.6 KB
Format: PDF

Summary

Page 2 - CUTOUT DIMENSIONS; Installation Instructions; GROUNDING INSTRUCTIONS; WARNING; ELECTRICAL REQUIREMENTS

2 CUTOUT DIMENSIONS * Min. depth with receptacle outside cabinet 19 1 » 2 ” Min. depth with receptacle inside cabinet 22” Installation Instructions Models 27 ” 30 ” Height 16 3 » 4 ” 16 3 » 4 ” Width 25 1 » 2 ” 25 1 » 2 ” Depth (min.)* 19 1 » 2 ” or 22 ” 19 1 » 2 ” or 22 ” On 27 ” models, allow 1 1 ...

Page 3 - LOCATE AND INSTALL

3 Installation Instructions 1 LOCATE AND INSTALL BASE PAN Set Base Pan into the front cabinet microwave oven cutout and center it right and left. Push back until the front flange is against the cabinet front wall. Mount the Base Pan using 3 short screws. 2 INSTALL BOTTOM BRACKETS Set the two bottom ...

Page 4 - INSTALL THE TRIM FRAME

Installation Instructions Printed in China 8 INSTALL THE TRIM FRAME Using a small flat-head screwdriver, remove the 4 screw covers that are installed in the trim frame. Place the trim frame over the microwave oven. Open the microwave oven door. Secure the trim frame using four flat-tipped screws (tw...