GE JV338HWW - User Manual - manualsarea.com

Page 2 - READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

Operating Instructions Safety Instructions Consumer Support Installation Instructions READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. READ AND SAVE THESE INSTRUCTIONS SAFETY PRECAUTIONS IMPORTANT SAFETY INFORMATION.READ ALL INSTRUCTIONS BEFORE USING. WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC...

Page 3 - LISEZ ET SUIVEZ ATTENTIVEMENT CES INSTRUCTIONS.

Installation Instructions Consumer Support Safety Instructions Operating Instructions LISEZ ET SUIVEZ ATTENTIVEMENT CES INSTRUCTIONS. LISEZ ET CONSERVEZ CES INSTRUCTIONS PRÉCAUTIONS EN MATIÈRE DE SÉCURITÉ INSTRUCTIONS DE SÉCURITÉ IMPORTANTES.LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER. AVERTISSEM...

Page 4 - Using the hood controls.

Operating Instructions Safety Instructions Consumer Support Installation Instructions Using the hood controls. Throughout this manual, features and appearance may vary from your model. FAN Control Turn to HI , MED or LO as needed. Continuous use of the fan system while cooking helps keep the kitchen...

Page 5 - Painted Surfaces; Hood Light; Stainless Steel Surfaces

Installation Instructions Consumer Support Safety Instructions Operating Instructions Do not use steel-wool pads or otherabrasive cleaners. They will scratch the surface. Clean grease-laden surfaces of thehood frequently. To clean the hoodsurface, use a hot, damp cloth with amild detergent suitable ...

Page 6 - BEFORE YOU BEGIN; Installation; IMPORTANT –; Note to Installer –; Maximum duct length:; DUCTWORK REQUIREMENTS; WARNING –; OPTIONAL POWER CORD KIT JXHC1

BEFORE YOU BEGIN 6 Installation Range Hood Instructions Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. • IMPORTANT – Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Cons...

Page 7 - WORKSHEET—CALCULATE TOTAL EQUIVALENT DUCTWORK LENGTH; Installation Instructions; MAXIMUM DUCT LENGTH:; should

7 DUCT EQUIVALENT NUMBER PIECES LENGTH x USED = TOTAL 3 1 ⁄ 4 ″ x 10 ″ 1 Ft. x ( ) = Ft. Rect., straight 7 ″ Round, 1 Ft. x ( ) = Ft. straight 6 ″ Round, 1 Ft. x ( ) = Ft. straight 3 1 ⁄ 4 ″ x 10 ″ 14 Ft. x ( ) = Ft. Rect. 90°elbow 3 1 ⁄ 4 ″ x 10 ″ 8 Ft. x ( ) = Ft. Rect. 45°elbow 3 1 ⁄ 4 ″ x 10 ″ 3...

Page 8 - If the unit is damaged in shipment,; If the unit is damaged by the customer,; If the unit is damaged by the installer; DAMAGE – SHIPMENT/INSTALLATION

PART QUANTITY Grease Filter only (JV338) 1 Charcoal Filter only 1 (JN327 and RN328) Grease Filter and Charcoal 2 Filter (JV347, JV348 and JV367) Mounting Screws 4 (8 - 18 x 3/4 ″ Phillips pan head) Exhaust Adaptor 1 (for 3 1 ⁄ 4 ″ x 10 ″ rect. venting) Exhaust Adaptor Screw 1 (8 - 18 x 3/8 Phillips ...

Page 9 - CHOOSE VENT OPTION

9 Outside top exhaust(Vertical duct–3 1 ⁄ 4 ″ x 10 ″ Rectangular) Outside rear exhaust (Horizontal duct–3 1 ⁄ 4 ″ x 10 ″ Rectangular) Outside top exhaust(Vertical duct–7 ″ Round) A C B Recirculating(non-vented/ductless) D Installation Instructions CHOOSE VENT OPTION Determine the vent option that yo...

Page 10 - REMOVE DUCT KNOCKOUT

10 REMOVE EXHAUST ADAPTOR If exhausting/venting using the 3 1 ⁄ 4 ″ x 10 ″ rectangular duct—optional for JV338, JV347, JV348 and JV367models only: Remove the exhaust adaptor from the inside of thehood. Set it aside along with its mounting screws. 3 1 ⁄ 4 ″ x 10 ″ rectangularexhaustadaptorand screws ...

Page 11 - RECTANGULAR; exhaust adaptor/damper; ROUND VERTICAL

11 FOR 3 1 ⁄ 4 ″ X 10 ″ RECTANGULAR DUCTED DISCHARGEINSTALLATIONS ONLY: Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal,depending on installation) with two exhaust adaptorscrews. Make sure damper pivot is nearest to top/back edge of hood. Remove tape f...

Page 12 - C. Outside rear exhaust; RUN WIRES; A. Outside top exhaust

12 D. Recirculating (non-vented ductless– JN327 and RN328, and optional onJV347, JV348 and JV367 models only) • Use the hood as a template and mark the locations on the cabinet for the electrical wiring and keyholescrew slots. • Since the hood is to be recirculated (not to be vented outside), do not...

Page 13 - SCREW IN PARTWAY; FEED IN WIRES; duct tape

13 Installation Instructions SCREW IN PARTWAY Drive a mounting screw (from the hardware packet)partway into each center of the narrow neck of thekeyhole slots marked on the cabinet bottom. OPTIONAL POWER CORDKIT JXHC1 An optional Power Cord Connection Kit, modelJXHC1, is available at extra cost from...

Page 14 - FOLLOW ELECTRICAL CODE; house wiring; INSTALL LIGHT BULB; not more; TROUBLESHOOTING CHECKLIST; green ground screw; REPLACE FILTER

14 FOLLOW ELECTRICAL CODE Complete the electrical wiring according toNational Electrical Code and local codes. NOTE: This hood must be permanently grounded. Connect house wiring (120 VAC) to hood wiring. 20 INSTALL LIGHT BULB NOTE: A light bulb is not shipped with the hood. Obtain one locally. Purch...

Page 15 - GE Range Hood Warranty.; Improper installation, delivery or maintenance.; What GE Will Not Cover:

GE Range Hood Warranty. For The Period Of: GE Will Replace: One Year Any part of the range hood which fails due to a defect in materials or workmanship. From the date of the During this limited one-year warranty, GE will also provide, free of charge, all labor and original purchase in-home service t...

Page 16 - Register your new appliance on-line—at your convenience!

Printed in China Consumer Support. GE Appliances Website ge.com Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals,order parts or even schedule ser...

GE JV338HWW - User Manual

Table of Contents:

Summary

Other GE Range Hoods Models