GE GFD45GSPK0DG - Installation Manual
GE GFD45GSPK0DG – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; Tilt the dryer sideways and remove the foam; UNPACKING YOUR DRYER; Side View
- Page 3 – Keep flammable materials and vapors, such as; WARNING
- Page 4 – WATER SUPPLY REQUIREMENTS; washer’s; CONNECTING INLET HOSES
- Page 5 – MATERIALS YOU WILL NEED
- Page 6 – GAS REQUIREMENTS; DOES NOT
- Page 7 – CONNECTING THE DRYER TO
- Page 9 – Before making the electrical connection, turn off; NEVER LEAVE
- Page 10 – CONNECTING AN ELECTRIC DRYER
- Page 11 – CONNECTING DRYER USING; CONNECTING DRYER USING 4-WIRE; NEVER LEAVE THE COVER OFF OF THE; If required, by local code, install external ground
- Page 12 – TOOLS AND MATERIALS YOU WILL; transition duct to connect the dryer to the; PARTS AVAILABLE FROM
- Page 13 – EXHAUST LENGTH
- Page 14 – BEFORE YOU BEGIN; HOOD OR WALL CAP
- Page 15 – SIDE OR BOTTOM VENTING; Disconnect dryer from electrical supply.; ADDING A NEW DUCT; Be sure not to pull or damage the electrical; TAB LOCATION
- Page 16 – ADDING ELBOW AND DUCT FOR; FINAL SETUP; LEVEL THE DRYER; NEVER LEAVE THE BACK OPENING WITHOUT; Service personnel – DO NOT
- Page 17 – Instrucciones; Secadora; Advertencias de la Proposición 65 del Estado de California; SECADORAS A GAS ÚNICAMENTE; Lea estas instrucciones por completo y con; IMPORTANTE; ADVERTENCIA
- Page 18 – Instrucciones de instalación; CÓMO DESEMPACAR LA SECADORA; Visión lateral
- Page 19 – Mantenga cualquier material y vapores inflamables,; - Riesgo de explosión
- Page 20 – lavadora; CÓMO CONECTAR MANGUERAS
- Page 21 – MATERIALES NECESARIOS
- Page 22 – REQUERIMIENTOS DE GAS; PARA USO EXCLUSIVAMENTE CON GAS
- Page 23 – CÓMO CONECTAR LA SECADORA
- Page 24 – NO UTILICE; GUARDE ESTAS INSTRUCCIONES
- Page 26 – Para una secadora conectada con cable; CÓMO CONECTAR SECADORA ELECTRICA
- Page 27 – Conexión de 3 cables; NUNCA OLVIDE DE VOLVER A COLOCAR
- Page 28 – HERRAMIENTAS Y MATERIALES; PARTES DISPONIBLES DESDE
- Page 29 – LONGITUD DE SALIDA; NO
- Page 30 – CAMPANA O CUBIERTA DE PARED; AISLACIÓN
- Page 31 – VENTILACIÓN LATERAL O POR LA; incendio, descarga eléctrica o laceraciones.; CÓMO AGREGAR UN CONDUCTO NUEVO; Asegúrese de no tirar o dañar los cables
- Page 32 – VENTILACIÓN LATERAL O POR; CONFIGURACIÓN FINAL; INICIO DE LA SECADORA; SALIDA AL EXTERIOR DE
Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
In Canada, call 800.561.3344 or visit www.GEAppliances.ca
- Fire Hazard
WARNING
• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these instructions
and local codes.
•
DO NOT
install a clothes dryer with flexible plastic venting
materials. If flexible metal (semi-rigid or foil-type) duct is
installed, it must be UL-listed and installed in accordance
with the instructions found in “Connecting the Dryer
to House Vent” later in this manual. Flexible venting
materials are known to collapse, be easily crushed and
trap lint. These conditions will obstruct dryer airflow and
increase the risk of fire.
•
DO NOT
install or store this appliance in any location
where it could be exposed to water or weather.
• To reduce the risk of severe injury or death, follow all
installation instructions.
• Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
In the Commonwealth of Massachusetts,
the following installation instructions apply:
• Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not
exceed 4 feet.
FOR GAS DRYERS ONLY
State of California Proposition 65 Warnings
This product contains one or more chemicals known to the State of California to cause cancer, and birth
defects or other reproductive harm.
Gas appliances can cause low-level exposure to some of these substances, including benzene, carbon monoxide,
formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Exposure to these
substances can be minimized by properly venting the dryer to the outdoors.
Dryers
04
Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
–
Save these instructions for local electrical
inspector’s use.
IMPORTANT
–
Observe all governing codes and
ordinances.
• Install the clothes dryer according to the manufacturer’s
instructions and local codes.
• Note to Installer –
Be sure to leave these instructions
with the Consumer.
• Note to Consumer –
Keep these instructions for future
reference.
• Clothes dryer installation must be performed by a qualified
installer.
• This dryer
must
be exhausted to the outdoors.
• Before the old dryer is removed from service or discarded,
remove the dryer door.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above 50°F for
satisfactory operation of the dryer control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
• Service information and the wiring diagram are located
in the control console.
FOR GAS DRYERS ONLY
WARNING
31-16769-4
11-17 GEA
234D2274P004
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- GE
- Model
- GFD45GSPK0DG
- Document type
- Installation Manual
- Language(s)
- English, Spanish
- Pages
- 32
- File size
- 1.7 MB
- Format
Summary
Installation Instructions 2 Tilt the dryer sideways and remove the foam shipping pads by pulling at the sides and breaking them away from the dryer legs. Be sure to remove all of the foam pieces around the legs.Remove the bag containing the literature. UNPACKING YOUR DRYER ROUGH-IN DIMENSIONS With P...
Installation Instructions MOBILE OR MANUFACTURED HOME INSTALLATION • Installation MUST conform to the MANUFACTURED HOME CONSTRUCTION AND SAFETY STANDARD, TITLE 24, PART 3280 or STANDARD FOR MOBILE HOMES CAN/CSA-Z240 MH, or, when such standards are not applicable, with AMERICAN NATIONAL STANDARD FOR ...
Installation Instructions 4 CONNECTING INLET HOSES (for steam dryer models only) CONNECTING INLET HOSES (cont.) 7 . Using pliers, tighten all the couplings with an additional two–thirds turn. NOTE: Do not overtighten. Damage to the couplings may result. 8. Turn the water faucet on. 9 . Check for lea...