GE GDT695SFL4DS - Installation Manual

GE GDT695SFL4DS

GE GDT695SFL4DS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
Page: / 48

Table of Contents:

  • Page 2 – For New Installations Only:; MATERIALS YOU WILL NEED:; Materials For New Installations Only:; or; Installation Preparation
  • Page 3 – PREPARE DISHWASHER ENCLOSURE; DRAIN REQUIREMENTS; DETERMINE DRAIN METHOD; Method 1 – Air Gap with Waste Tee or Disposer; Figure B; WARNING; Method 2 – “High Drain Loop” with Waste Tee or Disposer
  • Page 4 – For models equipped with power cord:; Cabinet Preparation & Wire Routing; PREPARE ELECTRICAL WIRING; Electrical Requirements
  • Page 5 – Water Line Connection; • If using a flexible braided supply hose, label; • Water connection is on the left side of the; PREPARE HOT WATER LINE; GE Appliances recommends copper tubing for; CAUTION
  • Page 6 – REMOVE TOEKICK; Locate the items in the installation package:; Dishwasher Installation; STEP 3 REMOVE WOOD BASE,; IMPORTANT –; CHECK DOOR BALANCE; Tip: Make sure door opens and closes smoothly.
  • Page 7 – Figure N; STEP 7; STEP 5; Figure M
  • Page 8 – INSTALL TRIM PIECES; In this step you will need the trim pieces set aside in Step 1.; SLIDE DISHWASHER; Do not push against front panel with; Top View
  • Page 9 – Install mounting brackets on top; if the; Top Mounting; STEP 13 PUSH DISHWASHER INTO; IMPORTANT; Before opening the dishwasher door,; INSTALL MOUNTING; Install mounting brackets on sides; if the; Side Mounting
  • Page 10 – • If your model has rear; LEVEL DISHWASHER
  • Page 11 – Brackets; Figure X; Solid Surface Countertop; Figure Y; POSITION DISHWASHER,
  • Page 12 – Method 1 – Air gap with waste tee or disposer; Figure AC; CONNECT DRAIN LINE; • DRAIN CONNECTION HEIGHT IS NOT TO EXCEED; Figure Z
  • Page 13 – CONNECT POWER SUPPLY; Figure AD; PRETEST CHECKLIST
  • Page 14 – DISHWASHER WET TEST; START; REPLACE FLOOR
  • Page 15 – attachment screw holes.; LITERATURE; Figure AJ; Attachment; CHECK THE FOLLOWING; POSITION SOUND
  • Page 17 – Directives d’installation; Lave-vaisselle encastré; POUR VOTRE SÉCURITÉ; VEUILLEZ LIRE ATTENTIVEMENT; AVERTISSEMENT; ATTENTION
  • Page 18 – MATÉRIAUX NÉCESSAIRES:; Pour une nouvelle installation:; Préparation pour l’installation
  • Page 19 – CHOIX DE LA MÉTHODE DE VIDANGE; Conseil: Pour éviter des frais de réparation inutiles
  • Page 22 – Installation du lave-vaisselle; PRÉPARATION; REMARQUE; ÉTAPE 2
  • Page 24 – INSERTION AUX TROIS; Do not push against
  • Page 25 – Montage sur le dessus; INSTLLATION DU; INSTALLATION DES; Montage latéral
  • Page 26 – • Ouvrez et fermez la porte du lave-vaisselle pour vous; MISE DE NIVEAU DU
  • Page 27 – RACCORDEMENT DE; Supports; Comptoir de surface solide
  • Page 28 – RACCORDEMENT DU
  • Page 30 – INSTALLATION DU PAN
  • Page 33 – Instrucciones de Instalación; Lavavajillas Incorporado; PARA SU SEGURIDAD; LEA DETENIDAMENTE; ALTO; GHVFDUJDHOpFWULFD&RQVXOWHDXQHOHFWULFLVWDFDOL¿FDGR; PRECAUCIÓN
  • Page 34 – HERRAMIENTAS NECESARIAS:; Sólo para Instalaciones Nuevas:; MATERIALES NECESARIAS:; Preparación de la Instalación
  • Page 35 – REQUISITOS PARA EL DESAGÜE; DETERMINE EL MÉTODO DE DESAGÜE; PREPARACIÓN DEL GABINETE; ADVERTENCIA
  • Page 36 – Requisitos Eléctricos; Este electrodoméstico deberá ser provisto con 120V,; GHVFDUJDHOpFWULFD&RQVXOWHDXQHOHFWULFLVWDFDOL¿FDGRR; Preparación del Gabinete y Enrutador del Cable; Figura E
  • Page 37 – Conexión de la Línea de Agua
  • Page 38 – IMPORTANTE –; To; Zócalo; Instalación del Lavavajillas
  • Page 40 – DEL GABINETE
  • Page 41 – Instale los soportes de montaje en la parte superior; Montaje superior; COLOQUE EL; IMPORTANTE; INSTALE LOS SOPORTES; Instale los soportes de montaje a los costados; Montaje lateral
  • Page 42 – Figura U; NIVELE EL LAVAVAJILLAS; Alineación
  • Page 43 – CONEXIÓN AL; Si usará una conexión a una tubería de cobre:; Método 1; Mesada con superficie sólida; Soportes; POSICIONE EL; ‡&RQ¿UPHTXHWRGDVODVSDWDVQLYHODGRUDVWHQJDQ
  • Page 44 – • Conecte la línea de desagüe a la brecha de aire, la T de; Al conectar la línea de desagüe al; Retire el; CONECTE LA LÍNEA DE; • Si se requiere una manguera de desagüe más larga y; LA LONGITUD TOTAL DE LA MANGUERA DE; Cutting Line; Línea de corte; No corte la parte
  • Page 45 – CONECTE EL SUMINISTRO; OFF
  • Page 46 – REEMPLACE LA PAN
  • Page 47 – REEMPLACE EL ZÓCALO; TEXTOS; CONTROLE LO SIGUIENTE; ‡(OERUGHGHODWLQDQRLQWHU¿HUHFRQODSXHUWD; POSICIONE LA PIEZA DE
Loading the manual

Installation Instructions

Built-In Dishwasher

If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our website
at: GEAppliances.com. In Canada, please call 1.800.561.3344 or visit www.geappliances.ca

READ CAREFULLY

KEEP THESE INSTRUCTIONS

FOR YOUR SAFETY

Read and observe all WARNINGS and CAUTIONS
shown throughout these instructions.

While performing installations described in this booklet,
gloves, safety glasses or goggles should be worn.

IMPORTANT –

Observe all governing codes and ordinances.

•

Note to Installer

– Be sure to leave these instructions for

the consumer’s and local inspector’s use.

•

Note to Consumer

– Keep these instructions with your

Owner’s Manual for future reference.

•

Skill Level

– Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills.

Proper

installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliances Warranty. See warranty information.

•

Completion Time – 1 to 3 Hours

. New installations

require more time than replacement installations.

IMPORTANT –

The dishwasher MUST be installed to allow

for future removal from the enclosure if service is required.

Care should be exercised when the appliance is installed or
removed, to reduce the likelihood of damage to the power
supply cord.

If you received a damaged dishwasher, you should
immediately contact your dealer or builder.

Optional Accessories – See the Owner’s Manual for
available custom panel kits.

Your dishwasher is a water heating appliance.

BEFORE YOU BEGIN

Read these instructions completely and
carefully.

31-31560-1 09-16 GEA

• To reduce the risk of electric shock, fire, or injury to

persons, the installer must ensure that the dishwasher
is completely enclosed at the time of installation.

• FOR PERSONAL SAFETY: Remove house fuse or open

circuit breaker before beginning installation. Do not use
an extension cord or adapter plug with this appliance.

• The improper connection of the equipment grounding

conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative if
you are in doubt that the appliance is properly grounded.

• If house wiring is not 2-wire with ground, a ground

must be provided by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.

Do not remove wood base until you are ready to install
the dishwasher. The dishwasher will tip over when the
door is opened if base is removed.

CHECK THE FOLLOWING

ˆ

Tub trim does not interfere with the door

ˆ

Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door

ˆ

All 4 legs of the dishwasher are firmly in contact with the
floor

ˆ

Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls

ˆ

Tub trim is fully seated on the tub flange

WARNING

CAUTION

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for GE GDT695SFL4DS

Summary

Page 2 - For New Installations Only:; MATERIALS YOU WILL NEED:; Materials For New Installations Only:; or; Installation Preparation

PARTS SUPPLIED IN INSTALLATION PACKAGE: • Junction box cover and #10 hex-head screw• Hose clamp• Drain hose (approximately 58” long)• Drain hose hanger• 2 #8-18 hex head screws to secure brackets to washer tub frame • 1 top trim piece (on some models)• 2 side trim pieces • 2 mounting brackets for wo...

Page 3 - PREPARE DISHWASHER ENCLOSURE; DRAIN REQUIREMENTS; DETERMINE DRAIN METHOD; Method 1 – Air Gap with Waste Tee or Disposer; Figure B; WARNING; Method 2 – “High Drain Loop” with Waste Tee or Disposer

PREPARE DISHWASHER ENCLOSURE • The rough cabinet opening must be at least 24” deep, 24” wide and approximately 34-1/2” high from floor to underside of the countertop. • The dishwasher must be installed so that drain hose is no more than 12’ in length for proper drainage. • The dishwasher must be ful...

Page 4 - For models equipped with power cord:; Cabinet Preparation & Wire Routing; PREPARE ELECTRICAL WIRING; Electrical Requirements

Installation Preparation For models equipped with power cord: Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified technician. Cabinet Preparation & Wire Routing • The wiring may enter the opening from either side, rear ...

Other GE Models