GE 19208 - Manual

GE 19208 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 3 – Setting The House Security Code
Page 4 – To change the house code, add or remove jumpers as needed. It is
Page 5 – Push Button Mounting Instructions; Avoid mounting on metal surfaces, as it may result in a reduced; a. Removing the back cover
Page 7 – Test Operations, if chime does not work, see TROUBLESHOOTING.; Chime Unit Mounting Instructions; Select chime mounting location.
Page 8 – Operation
Page 9 – is a trademark of

Loading the manual

GE Model 19208

www.jascoproducts.com

Wireless Door Chime Kit

Installation Instructions for Battery Operated
Wireless Door Chime Kit

Prior to Installation the Try-Me feature must be removed.

1. Remove the battery cover on the chime.
2. Remove the white Styrofoam block
3. Unplug the red and black wires inside the battery compartment.
4. Remove the battery pack and discard appropriately.

Chime components

Required Tools: Small flat blade screwdriver, drill, 1/16” and 5/32” drill bits,
and phillips screwdriver.

Included Hardware:

(2) Plastic screw anchors
(2) 4x20mm screws
(2) 3x20mm screws
(2) Double sided adhesive pads

Styrofoam
Block

House Code
Door

Try-Me Wires

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand: GE
Model: 19208
Document type: Manual
Language(s): English
Pages: 9
File size: 517.5 KB
Format: PDF

Summary

Page 3 - Setting The House Security Code

Pushbutton Dip Switches and Jumpers Setting The House Security Code Each chime component has 4 jumpers for setting the house security code. In most cases you will not need to change the factory settings for the house security code. If your chime activates intermittently or does not work at all, you ...

Page 4 - To change the house code, add or remove jumpers as needed. It is

3. Locate the House Security Code door and screw located on the back of the chime (See the chime components picture above). Remove the screw and take off the door. 4. Locate the chime and pushbutton jumpers shown below. Chime and Pushbutton Jumpers 5. To change the house code, add or remove jumpers ...

Page 5 - Push Button Mounting Instructions; Avoid mounting on metal surfaces, as it may result in a reduced; a. Removing the back cover

Push Button Mounting Instructions Note: Avoid mounting on metal surfaces, as it may result in a reduced range of transmission. Do not mount in an area where exposed to direct rain. a. Removing the back cover b. Replacing the back cover 1. Push buttons are typically mounted at the same height as the ...