Furman PST-10D - Manual - manualsarea.com

Page 2 - Warning

2 Introduction Thank you for purchasing the Furman Power Station-10D Power Conditioner. For over 30 years, Furman has pioneered the development of AC power products for the most demanding audio, video, and broadcast professionals. Furman’s Series Mode Protection Plus (SMP+), Linear Filtering Technol...

Page 3 - Important Safety Instructions

3 enclosure. Do not remove the covers. There are no user serviceable parts inside. Refer servicing to qualiﬁed personnel only. Important Safety Instructions 1. Please read and observe all safety and operating instructions before installing your Power Station-10D (PST-10D). Retain these instructions ...

Page 4 - Operation –; Digital – Video Outlets:

4 7. Your PST-10D should be serviced by qualiﬁed service personnel when:• The power supply cord or the plug has been frayed, kinked, or cut.• Objects have fallen or liquid has spilled into the unit.• The unit has been exposed to rain or other moisture.• The unit does not appear to operate normally, ...

Page 5 - Delayed AC Outlets – Trigger Switch and 12VDC inlet:; normal

5 contaminating an adjacent unit. For example, a television plugged into the digital – video ﬁltered outlets will not affect an audio receiver-controller connected to one of the PST-10D’s standard or delayed outlets. Delayed AC Outlets – Trigger Switch and 12VDC inlet: The PST-10D features (3) delay...

Page 6 - Telco – Satellite – Cable Transient Voltage Surge Suppressors:

6 Telco – Satellite – Cable Transient Voltage Surge Suppressors: The PST-10D features transient voltage surge suppression for both standard telephone lines, as well as cable and satellite lines utilizing standard coaxial connectors. As these surge suppressors are in- line , they will require an addi...

Page 7 - Circuit Breaker; Indicators; Extreme Voltage Shutdown Indicator

7 and out going cable from the PST-10D. Connect the incoming connector to the component that formerly received the out going connector, thus by-passing the in-line protection. If the signal is present (but not when used with the PST-10D’s) then the protection circuit is damaged (assuming it worked p...

Page 8 - Protection OK Indicator; Mounting

8 voltage in excess of 137VAC is sensed, either on initial power-up or during normal operation, the PST-10D will shut off power and this indicator will light. NOTE: If the mains power is above the high cutoff voltage and has caused the unit to remove power from its outlets, it can not restore power ...

Page 9 - Warranty

9 distance from the two mounting hole drilled into your wall, rack or cabinet surface. Once the screw is fastened ﬂush with the surface, back it out approximately ½” . The screw head should push through the crossed cutout on the bottom surface of the Power Station. Next, simply allow the Power Stati...

Page 12 - Service

12 STATEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by purchaser, and are not a part of the contract for sale or this limited warranty. This Limited Warranty states the entire obligation of Furman with respect to the product. If any part of this Limited Warranty is determined to be ...

Furman PST-10D - Manual

Table of Contents:

Summary

Other Furman Models