Frigidaire PLRU1778ES0 - Installation Manual

Frigidaire PLRU1778ES0

A stainless steel refrigerator or freezer installation manual covers critical setup requirements, emphasizing electrical safety with dedicated circuits, grounding, and GFCI compliance. The guide also addresses structural needs–such as level floors, water access for ice makers, and precise clearances–to ensure stability, proper door alignment, and safe operation. Leveling procedures focus on adjusting legs to maintain unit parallelism and door balance.

1 Page 1
2 Page 2
3 Page 3
Page: / 3

Table of Contents:

  • Page 1 – Electrical Requirements and Installation Location
  • Page 2 – Leveling and Base Removal Procedure
  • Page 3 – Refrigerator Mounting Preparation
Loading the manual
Page 1

Merchandise Information Sheet

MIS 46-Freezers rev 0

October 20, 2004

Installation and Leveling of Stainless Steel

All Refrigerator, All Freezer

Division: 46

Installation

All Refrigerator and All Freezer

Topic:

Instructions for installing and leveling.

Electrical Information:

1. Each unit must be plugged into its own dedicated 115 Volt, 60 Hz.,

AC circuit.

2. The power cord of each unit is equipped with a three-prong grounding

plug for protection against shock hazards. It must be plugged directly
into a properly grounded three-prong receptacle, protected with a 15
amp time delay fuse or circuit breaker.

3.

Do Not

connect units to a Ground Fault Circuit Interrupter (GFCI)

circuit.

Location:

1. The units must be installed on a floor that is level and strong enough

to support a fully loaded refrigerator and freezer.

2. Consider water supply availability for models equipped with an

automatic ice maker.


Clearances:

1. Allow the following clearances for ease of installation, proper air

circulation, plumbing and electrical connections.

Sides -------------- 3/8”

Top & Back ------ 1”

Between units ---------- 3/16”

2.

Do Not

block toe grille on the lower front of the units. Sufficient air

circulation is essential for the proper operation of the units.


Page 1 of 3 PN: 297078900

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand
Frigidaire
Model
PLRU1778ES0
Document type
Installation Manual
Language(s)
English
Pages
3
File size
36.9 KB
Format
PDF

Other Manuals for Frigidaire PLRU1778ES0

Summary

Page 1 - Electrical Requirements and Installation Location

Guidelines for installing stainless steel refrigerators and freezers, covering electrical safety, grounding, GFCI restrictions, installation placement, and necessary clearances.

Page 2 - Leveling and Base Removal Procedure

Instructions for removing the wood base and adjusting leveling legs to ensure doors are level, parallel, and properly aligned, referencing visual guidance figures.

Page 3 - Refrigerator Mounting Preparation

Steps for preparing a refrigerator unit for mounting, including loosening leg levelers, removing crating bolts and the wood base, and specifying minimum clearance dimensions for door alignment.

Ask a question

Up to 3 photos. Max 5 MB each. Formats: JPG, JPEG, PNG, WebP.