Frigidaire IMKFD28A - Installation Manual

Frigidaire IMKFD28A

Frigidaire IMKFD28A – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – Removing Freezer; NOTE; Figure 1; Figure 4; Figure 2; Ice Maker Installation Instructions
  • Page 3 – ff; To Connect Water Supply Line To Ice Maker Inlet Valve; IMPORTANT; To Avoid Property Damage:; WARNING; Connecting Ice Maker to Water Supply
  • Page 4 – Automatic Ice Maker Tips
Loading the manual

B. Ice Maker (x1)

C. Ice Bucket (x1)

E. Shoulder Screws (x2)

F. Screw (x1)

Cobra FRZ IM Numbers:

• CD: IMKFD23A
• SD: IMKFD28A

AUTOMATIC ICE MAKER

INSTALLATION INSTRUCTIONS

We recommend an authorized service technician to install the ice maker kit.

Tools Needed:

• Phillips Screwdriver
• Flat-head Screwdriver

• ¼

-inch Socket Wrench or Nut Driver

• Adjustable Wrench

Kit Components

WARNING

• To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from

electrical power before connecting a water supply line to the refrigerator.

• Connect the ice maker to a potable water supply only.

NSF/ANSI/CAN 61: Q

1

P/N A23057902

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Frigidaire IMKFD28A

Summary

Page 2 - Removing Freezer; NOTE; Figure 1; Figure 4; Figure 2; Ice Maker Installation Instructions

2 2. Use a Phillips screwdriver to install 2 shoulder screws (E) in the upper rear holes. Turn until the shoulder screws are in firm contact with the freezer wall. (See Figure 1). 7. Insert and tighten screw (F) in the outermost hole on the bracket to fasten it to the upper side of the freezer wall....

Page 3 - ff; To Connect Water Supply Line To Ice Maker Inlet Valve; IMPORTANT; To Avoid Property Damage:; WARNING; Connecting Ice Maker to Water Supply

3 Before Installing The Water Supply Line, You Will Need: • Basic Tools : adjustable wrench, flat-head screwdriver, and Phillips screwdriver • Access to a household cold water line with water pressure between 30 and 100 psi. • A water supply line made of ¼ inch (6.4mm) OD, copper or stainless steel ...

Page 4 - Automatic Ice Maker Tips

4 • Wash the ice bin in warm water with mild detergent. Rinse well and dry. • Turn OFF ice maker when cleaning the freezer or for short vacations. • If you will turn the ice maker off for a long period of time, turn the water supply valve to the closed position. • Remember water quality determines y...

Other Frigidaire Models