Frigidaire FFGH2422US - Installation Manual

Frigidaire FFGH2422US

A freestanding gas range installation manual outlines essential safety protocols and technical requirements for professional setup, emphasizing compliance with local regulations like those in Massachusetts. The document covers critical topics such as safety precautions, including tip-over hazards, proper ventilation, and childproofing measures, alongside detailed installation guidelines. It specifies required tools (e.g., wrenches, levels) and materials (gas shut-off valves, flexible conduit), along with precise clearance dimensions for walls, cabinets, and electrical outlets. Safety warnings highlight the need for qualified professionals, correct gas line connections, proper grounding, and adherence to local building codes. Additionally, it addresses maintenance procedures, such as locating identification plates and ensuring burner functionality, while stressing that all work must comply with strict safety standards.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 1 – Installation and Safety Warnings for Gas Range
  • Page 2 – Safety Precautions for Installation and Operation
  • Page 3 – Tools and Materials Required for Installation
  • Page 4 – Installation Clearance Requirements
  • Page 5 – Mounting Instructions for Anti-Tip Bracket
  • Page 6 – Gas Supply Connection Procedures
  • Page 7 – Checking Gas Connections and Pressure Settings
  • Page 8 – Electrical Safety and Burner Cap Installation
  • Page 9 – Ignition and Burner Valve Adjustment
  • Page 10 – Leveling, Maintenance, and Identification
  • Page 11 – Regional Installation Regulations and Tipping Safety
  • Page 12 – General Safety Requirements for Use
  • Page 13 – Installation Materials and Component Warnings
  • Page 14 – Required Clearances and Dimensional Layout
  • Page 15 – Detailed Anti-Tip Bracket Installation Steps
  • Page 16 – Gas Line Connection Procedures
  • Page 17 – Gas Line Leak Checking and Pressure Verification
  • Page 18 – Electrical Connection and Burner Cap Placement
  • Page 19 – Burner Ignition and Flow Rate Adjustment
  • Page 20 – Model Identification and Final Service Procedures
Loading the manual
Page 1

1

INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE

INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY:

— Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

— WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not

use any phone in your building.

• Immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach your gas supplier, call

the fire department.

— Installation and service must be performed

by a qualified installer, service agency or

the gas supplier.

Provide proper fuel type

Before proceeding:

Your range is factory preset to oper-

ate on natural gas. If L.P. conversion is needed, contact

your local L.P. Gas provider for assistance.

Important notes to the installer

• Read all instructions contained in these installation

instructions before installing range.

• Remove all packing material from the oven

compartments before connecting the gas and electrical

supply to the range.

• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.

Important notes to the consumer

• Keep these instructions with your

Use & Care Guide

for future reference.

• Be sure your range is installed and grounded properly

by a qualified installer or service technician.

Special instructions for appliances installed in the State of

Massachusetts:
This appliance can only be installed in the State of

Massachusetts by a Massachusetts licensed plumber or

gas fitter. When using a flexible gas connector, it must

not exceed 3 feet (36 inches) in length. A “T” handle type

manual gas valve must be installed in the gas supply line

to this appliance.

809019203 Rev B (1901)

Ensure the anti-tip device is re-engaged when the

range is moved to floor or wall.

Do not operate the range without the anti-tip device in

place and engaged.

Failure to follow these instructions can result in death

or serious burns to children and adults.

A child or adult can tip the range

and be killed.

Verify the anti-tip device has been

installed to floor or wall.

Tip Over Hazard

To check if the anti-tip bracket is installed properly,

use both arms and grasp the rear edge of range back.

Carefully attempt to tilt range forward. When properly

installed, the range should not tilt forward.
Refer to the anti-tip bracket

installation instructions

supplied with your range for proper installation.

Range

leveling leg

Anti-Tip

bracket

Refer to your serial plate for applicable agency

certifications

If the information in this manual

is not followed exactly, a fire or explosion may

result causing property damage, personal

injury or death.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand
Frigidaire
Model
FFGH2422US
Document type
Installation Manual
Category
Range
Language(s)
English, Spanish
Pages
20
File size
4.4 MB
Format
PDF

Other Manuals for Frigidaire FFGH2422US

Summary

Page 1 - Installation and Safety Warnings for Gas Range

Installation instructions and safety warnings for freestanding gas ranges, emphasizing professional installation, tip-over hazards, fuel type, and specific regional requirements.

Page 2 - Safety Precautions for Installation and Operation

Important safety instructions covering compliance with codes, proper grounding, safe installation over flooring, ventilation needs, and precautions against unattended use and flammable materials.

Page 3 - Tools and Materials Required for Installation

List of tools such as wrenches and levels, and necessary materials including pipe sealant, gas shut-off valves, flexible conduit, and supplied components like anti-tip brackets.

Ask a question

Up to 3 photos. Max 5 MB each. Formats: JPG, JPEG, PNG, WebP.