Ford 839 - Manual
Ford 839 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – , reinstall bolt and tighten to vehicle; Do not tighten at this time.
- Page 5 – rear bumper; CAUTION
- Page 6 – SE 3000 Steering extension
1999 FORD SUPER DUTY TRUCK
INSTALLATION INSTRUCTIONS
KIT #893
WARNING
Installation of a Performance Accessories
body lift will change the center of gravity and
the handling characteristics of the vehicle.
Because of the higher center of gravity and
larger tires, the vehicle will handle and react
differently both on and off road. You must
drive it safely! Extreme care must be taken to
prevent vehicle rollover or loss of control,
which could result in serious injury or death.
Avoid sudden sharp turns or abrupt
maneuvers and always make sure all vehicle
occupants have their seat belts fastened.
WARNING
Read and understand all instructions,
warnings, cautions, and notes in this sheet
and in your owner's manual before you begin
the installation of this body lift kit.
CAUTION
Proper installation of a Performance
Accessories body lift kit requires knowledge of
the factory recommended procedures for
disassembly an assembly of original
equipment components. It is recommended
that the factory shop manual and any special
tools necessary to your vehicle be on hand
during the installation. Installation of this body
lift kit without proper knowledge of the factory
recommended procedures might affect the
performance of these components and the
safety of your vehicle. It is strongly
recommended that a certified mechanic who is
familiar with the installation of similar
components install this body lift kit.
WARNING
This body lift kit should only be installed on
vehicles that are in good working condition.
Before the installation begins, the vehicle
should be thoroughly inspected for evidence of
corrosion or deformation of the sheet metal
around the factory body mounts. This body lift
kit should not be installed on any vehicle that
is suspected to have been in a collision, or
misused. Off road use of your vehicle with this
body lift installed may increase the stress
applied to the factory body mounts. It is not
recommended that any vehicle, with a body lift
installed, be involved in any extreme off road
maneuvers. Failure to follow this warning may
result in serious personal injury and/or serious
damage to your vehicle.
WARNING
Performance Accessories strongly
discourages the use of a suspension lift kit or
any other lift device in addition to a body lift kit.
A vehicle that uses a combination of lift
devices not originally engineered to be used
together may result in unexpected and unsafe
handling characteristics. Many states now
have laws restricting bumper heights and
vehicle lifts. Local laws should be consulted to
determine if the changes you intend to make
to your vehicle complies with state laws.
WARNING
The installation of larger wheel and tire
combinations may reduce the effectiveness of
the Anti-lock Braking System.
NOTE
Performance Accessories recommends using
the Loctite® supplied in the kit, on all
hardware unless noted in the instructions.
WARNING
Always wear eye protection when operating
power tools.
1. Read all warnings and instructions
completely and carefully before you begin.
Check the kit for proper contents (refer to the
part’s list and the picture diagrams). Only
attempt to install this kit on the vehicle
described above. This kit is not designed to fit
vehicles equipped with diesel engines. If
anytime during the installation you encounter
something different from what is outlined in the
instructions, call technical support. (928) 636-
0979 or contact us on the Internet at
www.PerformanceAccessories.com
.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
container. Remove the upper and lower radiator hoses from the radiator. Remove the upper radiator mounting bolts. Remove the radiator from the vehicle. Remove the fan shroud from the vehicle. 12. Pull down the air flap between the bumper and the bottom of the core support to reach the front bumper m...
relocating brackets to the frame using four 7/16" x 1 1/2" bolts, 7/16" washers and 7/16" nylock nuts. Tighten all rear bumper mounting hardware securely. Reconnect the license plate lights to the rear bumper 32. Place the warning sticker on the vehicle dash in plain sight of all veh...
1999 Ford Super Duty Kit # 893 Parts List KIT 16 3x3 blocks 4 3x2 overload blocks 2 Front bumper brackets 2 Rear bumper brackets 1 4wd shifter extension bracket 1 1 1/2" x 5" fuel-filler extension 1 3/4" x 18" fuel vent hose 1 Warning to driver sticker 1 Logo label 1 10ml bottle Loct...