Ford 2007 Exepdition - Manual

Folding the 20% Middle Seat (iF

equipped) to a load Floor poSition

To fold the seat, pull the lever (lever 3)

located on the seat back to release the

folding seat latch. With the latch released,

the seat back can be lowered into the

load floor position. A moderate force may

be required to move the seat forward

and down.

returning the 20% Middle Seat to

the upright poSition FroM the FullY-loWered Floor poSition

To return the seat to the upright position, lift and pull the seat back until the seat latch is

fully engaged.

quick reference guide

EXPEDITION

07

QUICK REFERENCE GUIDE

EssENTIal

INfOrmaTION

Fuel tank CapaCitY

Your vehicle’s fuel tank can accommodate 28 gallons (106L) of gasoline.

(expedition eL accomodates 33.5 gallons (126.8L) of gasoline.) Your vehicle is designed to use

“regular” unleaded gasoline with a pump (r+M)/2 octane rating of 87 for optimum performance.

The use of gasoline with lower octane ratings may degrade performance.

tire preSSure

Your tire pressure is properly set at the dealership according to the recommended

specifications found on the certification Label located on the front door latch pillar on the driver’s

side. Please check your tire pressure during routine maintenance and seasonal changes and when

the Tire Pressure Monitoring System warning indicator (if equipped) is illuminated. Warning: im-

properly inflated tires can affect vehicle handling and tire performance. See “Additional features” on

the reverse side for more information.

FuSeS

if electrical components in the vehicle are not working, a fuse may have blown. for more infor-

mation about changing a fuse, please consult your Owner’s guide.

Fuel puMp Shut-oFF SWitCh

After a collision, if the engine cranks but does not start, the fuel pump

shut-off switch may have to be reset. The switch is located in the left rear quarter trim panel, near

the liftgate, behind an access panel. for complete details on resetting the switch, please consult your

Owner’s guide.

Changing the tireS

if you get a flat tire while driving, do not apply the brake heavily. instead, gradu-

ally decrease your speed. Hold the steering wheel firmly and slowly move to a safe place on the side

of the road. Prior to jacking, hoisting or towing your vehicle, be sure to turn Off the running boards (if

equipped), and the air suspension switch. Your vehicle may be equipped with a conventional spare tire

that is different in one or more of the following: type, brand, size, speed rating and tread design. Your

vehicle may be equipped with a spare wheel that may not match the road wheels and is not equipped

with a Tire Pressure Monitor System (TPMS) Sensor.

Location of the Spare tire and tooLS

item

Location

Spare Tire

under the vehicle, just forward of the rear bumper

Jack Tools and

under the access panel, located in the floor compartment behind the

Jacking instructions

third row seat

roadSide eMergenCieS

To fully assist you if you should have a vehicle concern, ford Motor com-

pany offers a complimentary roadside assistance program. This program is separate from the new

Vehicle Limited Warranty. The service is available 24 hours a day, seven days a week for the new Ve-

hicle Limited Warranty period (u.S.) or Basic Warranty period (canada) of three years or 36,000 miles

(60,000 km). roadside assistance will cover:

q

changing a flat tire

q

Jump-starts

q

Limited fuel delivery

q

Lockout assistance

q

Towing of your vehicle

q

Winch Out

roadSide aSSiStance centerS

country

Phone number

united States

1-800-241-3673

canada

1-800-665-2006

for complete details on any roadside assistance concern, please consult the roadside emergencies

chapter, or the customer Assistance chapter in your Owner’s guide.

ford Motor company customer relationship center

P.O. Box 6248

dearborn, Mi 48121

1-800-392-3673 (fOrd)

(Tdd for the hearing impaired: 1-800-232-5952)

7 L 1 J - 19 g 217 - A A

7L1J19G217AA

June 2006

first Printing

quick reference guide

expedition

Litho in u.S.A.

1

4

7

aUDIO sYsTEm

PreMiuM/AudiOPHiLe AM/fM STereO in-dASH Six cd/MP3 SOund SYSTeM (if equipped)

sECOND rOW sEaTs

sECOND rOW sEaTs

(cOnTinued)

This quick reference guide is not intended
to replace your vehicle Owner’s guide which
contains more detailed information concerning
the features of your vehicle, as well as important
safety warnings designed to help reduce the risk
of injury to you and your occupants. Please read
your entire Owner’s guide carefully as you begin
learning about your new vehicle and refer to the
appropriate chapters when questions arise.

All information contained in this quick reference
guide was accurate at the time of duplication. We
reserve the right to change features, operation
and/or functionality of any vehicle specification
at any time. Your ford dealer is the best source
for the most current information. for detailed
operating and safety information, please consult
your Owner’s guide.

iMPOrTAnT: Before folding the second row seats, ensure that the head restraints are fully flipped

down by pulling on the strap and that all items have been removed from the floor and off the seats.

.

exiting the third roW Seat

fold head restraint forward

(Pos. 4)

. Pull up on the strap located at the back of the second row seat

by the outboard side shield

(Pull Strap)

. The seat back will fold forward to the cushion

(Pos. 5)

.

continue pulling up on the pull strap and the seat will flip forward

(Pos. 6)

. To return the seat to the

upright position, push the seat down until it is latched to the floor strikers. Then, lift the seat back to

the upright position and flip the head restraint to the upright position.

Folding the outboard Seat baCkS

to a load Floor poSition – (reFer

to the iMportant note above)

To fold the seats to a load floor position,

lift the lever

(Lever 1)

located on the

outboard side of the seat to release the

seat back. To lower the seat further to

the fully-lowered position for maximum

cargo capacity, locate

(Lever 2)

on the

seat back. releasing the lever releases

the seat into the kneel-down floor

position. A moderate force may be required to move the seat forward and down.

POWEr lIfTGaTE OPEraTION

returning the SeatS to the upright poSition FroM the

FullY-loWered Floor poSition

The seat back cannot be returned to the upright position until the seat

is returned from the kneel-down position. To return the seat to the

upright position, lift and pull the seat rearward until the latch is fully

engaged. do not attempt to unlatch the rear floor hooks while the seat

is in the kneel-down position.
With the seat back in the folded down position, lift up on the seat back.

This will allow the seat back to be lifted to the upright locked position.

To open the optional power liftgate, push the button on the

instrument panel

(Figure A)

, or press and release the con-

trol located in the left rear quarter panel

(Figure B)

. keep

clear of the liftgate when operating the rear switch.
To open the liftgate manually, place your hand on top of the

liftgate handle

(Figure C)

and pull. do not pull the handle

from the bottom. To close, make certain the liftgate glass

is closed, and then push the liftgate closed until it latches

securely.
To unlatch the liftgate glass, push the button

(Figure D)

under the center of the license plate lamp shield. Pressing

on your keyfob will also unlatch the liftgate glass.

do not open the liftgate or the liftgate glass in a garage or

other enclosed area with a low ceiling.

A

c

1

Cd eJeCt

Press and a

memory preset 1-6 to eject a

cd from a specific slot. Press

and hold to auto eject all cds

present in the system.

2

load

Press LOAd and a

memory preset to load a

specific slot. Press and hold to

autoload up to six cds.

3

aM/FM

Press to select AM/

fM1/fM2 frequency band.

4

Seek

Press to access the

previous or next strong station,

cd track, previous/next chan-

nel (if equipped with satellite

radio), previous/additional

display text or category.

5

text/SCan

Press and hold

to hear a brief sampling of ra-

dio stations or cd tracks. Press

again to stop. in cd/MP3

mode, press and release to

display track title, artist name

and disc title.

6

Folder

in folder mode,

press to access previous or

next folder on MP3 discs,

if available.

Satellite radio FeatureS

and ControlS (if equipped)

7

aux

Press repeatedly to cycle

through feS/dVd (if equipped),

SAT1, SAT2, SAT3 (satellite

radio mode if equipped),

Line in (auxiliary audio mode

if equipped) or feS/dVd (if

equipped). Once Satellite radio

mode is activated you may use

the following functions:
Press Menu until cATegOrY

MOde appears in the display.

Press / to scroll through

the list of SiriuS channel cat-

egories. Press Seek to select.

Press ScAn to hear a brief

sampling of channels in the

selected category.
Press Seek to access the previ-

ous/next channels. Press and

release TexT/ScAn to display

the current song title. Press

again to scroll through current

song title, artist, channel

category and the SiriuS long

channel name. Press and hold

for a brief sampling of the next

channels. Press again to stop.

8

tune/diSC SeleCtor

in radio mode, press to go

up/down the frequency band in

individual increments.

9

Menu

Press repeatedly to

cycle through the following

modes: category (if equipped

with satellite radio), Setting the

clock, Autoset, rBdS On/Off,

Treble, Bass, Balance, fade,

SPeedVOL (Speed Sensitive

Volume, if equipped), ALL

SeATS (Occupancy Mode),

Track/folder, and compres-

sion. for more information,

please consult your Owner’s

guide.

10

Setting MeMorY pre-

SetS

Select AM, fM1 or fM2

band, then tune to a station.

next, press and hold a num-

bered preset button until the

sound returns.

Setting the CloCk

Press

Menu until SeLecT HOur or

SeLecT MinS is displayed.

Press up/down arrows/<Seek>

to adjust the hours/minutes.

2

3

6

5

8 9 10

d

B

entering the third roW Seat

fold head restraint forward

(Pos. 1)

. Pull up on the lever

(Lever 1)

located on the side of either out-

board second row seat until the seat back folds forward to the cushion

(Pos. 2)

. Pull lever fully upward

(Lever 1)

. The seat will then flip forward

(Pos. 3)

.

Pos. 1

Lever 1

Pos. 2

Pos. 3

Pos. 4

Pull Strap

Pos. 5

Pos. 6