Fluke PN 643657 - Manual
Fluke PN 643657 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Press button to switch between modes.; Battery Saver
- Page 3 – Also refer to V; DC; Resistance and Continuity; eR; Turn off circuit power before testing. Also refer to V; Low Impedance; Short; Detects shorts and opens
- Page 4 – Warning; or; Meter puts 2 k; Disable and re-enable V•Check; For , and
- Page 5 – Thermocouple; Note correct connector polarity.
- Page 6 – Note correct probe polarity for polarized capacitors.
- Page 7 – Flame; μA AC
- Page 8 – Good Diode; Single beep; Forward Bias; Bad Diode; Shorted
- Page 9 – (Records the lowest and highest measurements); are disabled. Put the meter
- Page 12 – Replacement Parts
- Page 13 – C to
- Page 14 – MIN MAX Recording Accuracy and Response Time
- Page 15 – MIN MAX Recording with Elapsed Time; Elapsed Time; minute; Operating Temperature:; C or
- Page 16 – LIMITED WARRANTY & LIMITATION OF LIABILITY
Model 16 English Instruction Sheet
Page
1
®
16
Multimeter with Temperature
Instruction Sheet
P
Read First: Safety Information
To ensure that the meter is used safely, follow these instructions:
•
Do not use the meter if the meter or test leads appear damaged, or if
you suspect that the meter is not operating properly.
•
Disconnect the live test lead before disconnecting the common test
lead.
•
When using the probes, keep your fingers behind the finger guards on
the probes.
•
Do not use the V
•
Check
mode to measure voltages in circuits that
could be damaged by this mode’s low input impedance
(
≅
2 k
Ω
).
•
Turn off power to the circuit under test before cutting, desoldering, or
breaking the circuit. Small amounts of current can be dangerous.
•
Do not apply more than 600V rms between a meter terminal and earth
ground.
•
Use caution when working with voltages above 60V dc or 30V ac rms.
Such voltages pose a shock hazard.
PN 643657 June 1997 Rev.2, 3/98
1997, 1998 Fluke Corporation. All rights reserved. Printed in U.S.A.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Model 16 English Instruction Sheet Page 2 Symbols Press button. Press button to switch between modes. Double insulation. Manual ranging mode. ip14i.eps Automatic Range Selection The meter defaults to autoranging when you turn it on. The 4000 mVrange can be entered only with manual range selection. M...
Model 16 English Instruction Sheet Page 3 AC and DC Voltage Also refer to V • Check. Volts AC Volts DC Input Impedance ≅ 5 M Ω Input Impedance ≅ 10 M Ω 50 Hz to 400 Hz 16 MULTIMETER OFF V 600V COM CAT + AC / DC DC AC 4000 mV 4V 40V 400V 600V 16 MULTIMETER OFF V 600V COM CAT + AC / DC ip01i.eps Resis...
Model 16 English Instruction Sheet Page 4 W V • Check If a dc or ac voltage greater than about 4.5V is present across the inputswhen the meter is set to R , G , or e , the meter switches automatically to dc or ac voltage mode (V • Check mode). W Warning Repetitive transients on a dc bus will cause V...
