Fisher-Price T0250 - Manual

Page 2 - WARNING; When attached to adult chair:; Consumer Information

2 WARNING Prevent serious injury or death from falls or sliding out: • Only use for a child capable of sitting upright unassisted. • NEVER leave child unattended. High Chair Use: • ALWAYS secure child with restraint belts adjusted to fi t your child snugly. The tray is not designed to hold child in ...

Page 3 - Parts

3 Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. FASTENERS SHOWN ACTUAL SIZE #8 x ¾" Screw with Plastic Retainer – 4 #8 x ¾" Blunt Screw – 4 #8 x ¾" Pointed Screw – 2 Seat Support Parts Front Base Rear Base Footrest 2 Frames IMPORTANT! Pl...

Page 4 - Assembly; CAUTION; This package contains small parts

4 • Fit a #8 x ¾" screw with retainer into the rear base and tighten. • Repeat steps 1 and 2 to assemble the other frame to the rear base. With the Fisher-Price ® logo facing out, fit the tapered frame tube into the rear base. IMPORTANT! Before assembly and each use, inspect this product for dam...

Page 7 - “snap”

7 • Unbuckle the lower restraint. 13 Tab Tab Slot Slot Assembly • At an angle, fit the tabs on the seat back into the slots in the seat. • Push the seat back to “snap” in place. • Pull on the seat back to be sure it is secure to the seat bottom. 12 • Pull the ends of the waist belts and crotch belt ...

Page 8 - Smaller Baby

8 Assembly • Pull the ends of the shoulder belts through the slots in the seat pad. • Fit the straps on the back of the seat back pad into the slots in the seat back pad. • Press to fasten the straps to secure the seat back pad. Smaller Baby • Insert the ends of the shoulder belts through the lower ...

Page 9 - completely closed; Securing Your Child; • Only use for a child capable of sitting; • Use restraint belts until child is able to

9 Assembly • Fit the "T" end of each shoulder belt through the slots in the lower restraint. 19 Slots Seat Assembly • Place the seat assembly on the frame assembly and push to lock in place. You should hear a "click" . Note: The seat assembly will only fit on the frame assembly if th...

Page 10 - To tighten the waist belts:; TIGHTEN; To loosen the waist belts:; LOOSEN

10 Securing Your Child • Tighten each waist belt/shoulder belt so that the restraint system is snug against your child. Please refer to the next section for instructions to tighten the waist belts/shoulder belts. 2 • To tighten the waist belts: Feed the anchored end of the waist belt up through the ...

Page 11 - Using the Tray; • ALWAYS secure child with restraint

11 Using the Tray • Fit the tray onto the seat armrests. Push down until the tray "snaps" into place. Hint: Before use, thoroughly wash all parts (the tray) that may contact food. The tray is not dishwasher or microwave safe. 1 Tray Armrest • While pushing the release bar on the front of the...

Page 12 - To adjust the seat height:

12 Adjusting the Seat Attaching To An Adult Chair WARNING Prevent serious injury or death from falls or sliding out: • Only use for a child capable of sitting upright unassisted. • NEVER leave child unattended. • Use restraint belts until child is able to get in and out of the product without help (...

Page 13 - Attaching To An Adult Chair

13 A B • While sliding the switch A pull the latch towards you B . Attaching To An Adult Chair • Lift the seat off the base. 2 • Match the buckle on each strap to the matching buckle icon near each slot in the seat. Feed each strap through the matching slot on the seat. 4 Openings Openings • Turn th...

Page 15 - Attaching the Seat To the Frame; Storage; Care

15 Attaching the Seat To the Frame Door Chair Attachment Straps • Turn the seat over and open the door. Carefully fit the chair attachment straps into the compartment. 1 IMPORTANT! Close the door completely. If you do not close the door, the seat will not fit on the high chair base. 2 • Fit the seat...

Fisher-Price T0250 - Manual

Table of Contents:

Summary

Other Fisher-Price Models