Fisher-Price P9043 - Manual

Page 2 - WARNING; • Only use for a child capable of sitting; When attached to adult chair:; • Use restraint belts until child is able to; Consumer Information

2 WARNING Prevent serious injury or death from falls or sliding out: • Only use for a child capable of sitting upright unassisted. • NEVER leave child unattended. High Chair Use: • ALWAYS secure child with restraint belts adjusted to fi t your child snugly. The tray is not designed to hold child in ...

Page 3 - Assembled Parts

3 Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. FASTENERS SHOWN ACTUAL SIZE #8 x ¾" Screw with Plastic Retainer – 4 #8 x ¾" Screw – 4 Seat Support Assembled Parts Front Base Rear Base Footrest 2 Frames IMPORTANT! Please remove all parts from...

Page 4 - CAUTION; This package contains small parts; Assembly

4 • Fit a #8 x ¾" screw with retainer into the rear base and tighten. • Repeat steps 1 and 2 to assemble the other frame to the rear base. • With the Fisher-Price ® logo facing out, fit the tapered frame tube into the rear base. IMPORTANT! Before assembly and each use, inspect this product for d...

Page 6 - “snap”

6 • Unbuckle the lower restraint. 9 • Pull the waist restraint ends through the slots in the seat pad.• Fit the elastic loops on the seat pad down through the slots in the seat. • Turn the seat upside down.• Pull the elastic straps through the slots in the seat and fit the elastic straps to the pegs...

Page 7 - Larger Baby; Smaller Baby

7 • To adjust the restraint height for baby, push to remove the shoulder restraints from the seat back. 13 • Press to fasten the straps to secure the seat back pad. 12 Straps Larger Baby • Insert the ends of the shoulder belts through the upper slots in the pad and seat back. 15 Lower Shoulder Belt ...

Page 8 - completely closed; Securing Your Child

8 • Fit the "T" end of each shoulder belt through the slots in the lower restraint. 16 Slots Assembly Seat Assembly • Place the seat assembly on the frame assembly and push to lock in place. You should hear a "click" . Note: The seat assembly will only fit on the frame assembly if th...

Page 9 - To tighten the waist straps:; TIGHTEN; To loosen the waist straps:; LOOSEN

9 Securing Your Child • Tighten each waist belt/shoulder belt so that the restraint system is snug against your child. Please refer to the next section for instructions to tighten the waist belts/shoulder belts. 2 • To tighten the waist straps: Feed the anchored end of the waist strap up through the...

Page 10 - Using the Tray; ALWAYS secure

10 Using the Tray • Fit the tray onto the seat armrests. Push down until the tray "snaps" into place. Hint: Before use, thoroughly wash all parts (the tray) that may contact food. The tray is not dishwasher or microwave safe. 1 Tray Armrest • While pushing the release bar on the front of the...

Page 11 - To adjust the seat height:

11 Adjusting the Seat Attaching To An Adult Chair WARNING Prevent serious injury or death from falls or sliding out: • Only use for a child capable of sitting upright unassisted. • NEVER leave child unattended. • Use restraint belts until child is able to get in and out of the product without help (...

Page 12 - Attaching To An Adult Chair

12 • While sliding the switch A pull the latch towards you B . Attaching To An Adult Chair • Lift the seat off the base. 2 • Match the buckle on each strap to the matching buckle icon near each slot in the seat. Feed each strap through the matching slot on the seat. 4 Openings Openings • Turn the se...

Page 14 - Attaching the Seat To the Frame

14 Attaching the Seat To the Frame Door Chair Attachment Straps • Turn the seat over and open the door. Carefully fit the chair attachment straps into the compartment. 1 IMPORTANT! Close the door completely. If you do not close the door, the seat will not fit on the high chair base. 2 • Fit the seat...

Fisher-Price P9043 - Manual

Table of Contents:

Summary

Other Fisher-Price Models