Fisher-Price H4790 - Manual

5 5 Assembly 4 Insert Screws Here Footrest • Insert two #10 x 2.2 cm black screws through the footrest and into the seat bottom. Tighten the screws. #10 x 2.2 cm Black Screw - 2 5 • Turn the seat bottom assembly upright.• Fit the seat back pins into the openings in the top side of the seat bottom as...

6 6 6 Assembly 8 • Identify the back and front base. The front base has tapered leg tubes. You will use the back base for the next assembly step. Tapered Leg Tube Back Base Front Base 9 Screw Retainer - 2 #10 x 2.2 cm Black Screw - 2 • Position a frame so that the decorated side is outward.• Insert ...

8 8 8 Assembly Back and Bottom View Seat Bottom Tube Ends 14 Seat Height Adjusters • From the back and bottom of the assembly, insert a #8 x 1.9 cm screw through both seat height adjusters and the ends of theseat bottom tube. Tighten the screws. #8 x 1.9 cm Screw - 2 15 Back and Bottom View Hole Pad...

9 Assembly Shoulder Portion 16 • Insert the crotch belt through the slot in the pad. Make sure the crotch belt is not twisted. • Fold the top of the pad down. • Remove the shoulder portion of the waist/shoulder belts by feeding them through the slots in the seat back. 17 • Lift the top of the pad. •...

10 Assembly • Fit the strap on the top of the headrest through the handle.• Fit the pad strap through the handle and press it to the small fastener on the back of the seat. • Fit the headrest strap through the handle and press it to the large fastener on the back of the seat. 19 Handle Pad Strap Hea...

11 11 Securing Your Child IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT useif any parts are missing or broken. Contact Mattel for replace-ment parts and instructions if needed. Never substitute parts.Place the high chair on ...

12 12 Securing Your Child 4 • To tighten the shoulder belts: Hold the adjuster and pull the front shoulder strap down. • To loosen the shoulder belts: Slide the adjuster down. Note: After adjusting the restraint system to fit your child, make sure you pull on it to be sure it is securely fastened. S...

13 Prevent serious injury or death fromfalls or sliding out. The child should at all times wear a safety harness correctly fittedand adjusted. The tray is not designed tohold the child in the chair. WARNING 7 • Fit the base tray onto the seat armrests. Push down until the base tray "snaps" i...

14 11 Release Bar Base Tray • While pushing the release bar on the front of the base tray, pull the tray base towards you and remove. Base Tray 12 • Fit the food tray into the base tray, as shown. Hint: Before use, thorougly wash all parts (the trays) that may contact food. Food Tray Slot Toy 13 • I...

15 Adjusting the Seat Prevent serious injury or death fromfalls or sliding out. It is recommended that the high chair be used in the uprightposition only by children capable of sittingupright unassisted. WARNING Hint: Adjust the seat height to any of seven positions! 14 To adjust the seat height: • ...

Storage 16 Base Tray • Fit the holes on the base tray latches onto the pegs on the back of the high chair frame. Peg Hole 17 Pull Frame Release Latch • With the legs all the way open, lower the seat to position 7 the lowest position). • Pull the frame release latches forward and push the rear legs t...