Fisher & Paykel DD60ST4NX9 - User Manual

Page 3 - Electric Shock Hazard; Failure to follow this advice may result in; Cut Hazard; Failure to use caution could result in injury.; SAFETY AND WARNINGS; Servicing; SAVE THESE INSTRUCTIONS

3 ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electrical shock or death. • Before installing the DishDrawer, remove the house fuse or open the circuit breaker. • This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the ris...

Page 4 - TOOLS AND COMPONENTS; Keep all packing materials until the unit has been inspected.; PARTS SUPPLIED; To access installation videos; INSTALL VIDEO

4 TOOLS AND COMPONENTS z Keep all packing materials until the unit has been inspected. z Inspect the product to ensure there is no shipping damage. If any damage is detected contact the dealer or retailer you bought the product from to report the damage. z Fisher & Paykel is not responsible for ...

Page 5 - PRODUCT DIMENSIONS — DD60SC MODELS; PRODUCT DIMENSIONS; PLAN

5 PRODUCT DIMENSIONS — DD60SC MODELS Actual product dimensions may vary by ± 2 mm PRODUCT DIMENSIONS DD60SC/SA DD60SCT MM MM A Overall height 410 454 B Overall width 599 599 C Overall depth 573 573 D Depth of chassis 553 553 E Height of door panel 394 438 F Depth of door panel 20 20 G Ventilation ga...

Page 6 - PRODUCT DIMENSIONS — DD60SD MODELS

6 PRODUCT DIMENSIONS — DD60SD MODELS PRODUCT DIMENSIONS DD60SD DD60SDT MM MM A Overall height 410 478 B Overall width 599 599 C Overall depth* 573 573 D Depth of chassis 553 553 E Height of door panel 398 470 F Depth of door panel 20 20 G Ventilation gap below door panel 8 8 H Height from top of dra...

Page 7 - PRODUCT DIMENSIONS — DD60STN MODELS

7 PRODUCT DIMENSIONS — DD60STN MODELS PLAN ISOMETRIC PROFILE FRONT b g f c a E d Actual product dimensions may vary by ± 2 mm PRODUCT DIMENSIONS DD60ST MM A Overall height 454 B Overall width 599 C Overall depth 573 D Depth of chassis 553 E Height of door panel 442 F Depth of door panel 20 G Ventila...

Page 8 - CABINETRY; CABINETRY DIMENSIONS; Minimum inside height; CABINETRY CLEARANCES; Minimum clearance to adjacent cupboard door; DIMENSIONS; ISOMETRIC

8 CABINETRY CABINETRY DIMENSIONS DD60SA, DD60SC, DD60SD MODELS DD60SCT, DD60STN, DD60STZ MODELS DD60SDT MODELS MM MM MM A Minimum inside height min. 412 min. 456 min. 480 B Inside width* 600 – 610 600 – 610 600 – 610 C Minimum inside depth 579 579 579 *including 19mm door panels on adjacent cabinetr...

Page 9 - PLUMBING & ELECTRICAL CONSIDERATIONS; SERVICE DIMENSION; Hose and cord lengths; either; Water connection

9 PLUMBING & ELECTRICAL CONSIDERATIONS SERVICE DIMENSION LEFT SIDE* RIGHT SIDE* MM MM A Length of drain hoses 2000 1800 B Length of power cord** 1650 1650 C Length of inlet hose 1650 1250 D Distance from floor to top of hose support 750 – 883 750 – 883 E Minimum distance from floor to end of dra...

Page 10 - PROFILE; SERVICE HOLE DIMENSIONS; Maximum distance between rear of cavity and service hole; SIDE PARTITION; METHOD A; Secure to cabinetry via brackets; METHOD B; Secure via drawer removal

10 CABINETRY PREPARATION SERVICE ACCESS MOISTURE PROTECTION REAR WALL SHELF PROFILE SERVICE HOLE DIMENSIONS MM A Maximum distance between rear of cavity and service hole 5 B Maximum distance between shelf and service hole 10 C Minimum diameter of service hole 57 A B C z We recommend locating the ser...

Page 11 - SECURE TO CABINETRY VIA BRACKETS (METHOD A); Push the product in the positions

11 SECURE TO CABINETRY VIA BRACKETS (METHOD A) Partially open the drawer and remove the first screw cover from the trim moulding. Secure to cabinetry via the brackets. Pre-drilling a pilot hole may be required depending on the cabinetry material. 1 3 4 5 2 Replace the trim cover and repeat for the r...

Page 12 - SECURE TO CABINETRY VIA DRAWER REMOVAL (METHOD B); Ensure sound insulation is

12 Push the product into the cavity, pulling the hoses through as you push to avoid crushing or twisting them. Push the product in the positions illustrated to avoid denting the door. SECURE TO CABINETRY VIA DRAWER REMOVAL (METHOD B) 4 2 3 5 1 Open the drawer and press both locking tabs back to rele...

Page 14 - TO BE COMPLETED BY THE INSTALLER; Electrical; turned off to prevent flooding.; Test operation; INSTALLER CHECKLIST

14 TO BE COMPLETED BY THE INSTALLER Check all parts are installed correctly and are secure. Ensure DishDrawer™ Dishwasher is securely fastened to the cabinetry and drawer opens and closes freely with no resistance. Ensure any packaging or tape securing the racks and spray arm is removed. Che...

Page 15 - TROUBLESHOOTING

15 TROUBLESHOOTING The DishDrawer is beeping continuously z Refer to the ‘Fault codes’ section of your User guide No program indicator lights up when the drawer is opened z Ensure power is connected and is switched on. z AUTO POWER-ON may need to be activated. Refer to your User guide for details. D...

Page 16 - F I S H E R PAY K E L .CO M

4 3 1 3 75 B 03 . 2 3 F I S H E R PAY K E L .CO M © Fisher & Paykel Appliances 2023. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models d...

Fisher & Paykel DD60ST4NX9 - User Manual

Table of Contents:

Summary

Other Fisher & Paykel Dishwashers Models