Extron SM 26 - Manual
Extron SM 26 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Install the mounting plate.; Adapter; Quick Connect Contacts; Loop-through Connection; umber of Wires; Wire Gauge Table
- Page 3 – Product Category; If surface mounting, route the wires through; Attaching a Secondary Support Cable; unlocked; Using the Security Key to Lock and Unlock the Speaker; on the next; Catch Tab; Good
- Page 4 – Remove the security key.; Twist to; Unlocked; 013 Extron Electronics All rights reserved.
1
Product Category
SM 26 • Setup Guide
NOTE:
Unless otherwise stated, mounting hardware is not included.
This setup guide contains installation information about the Extron SpeedMount
®
SM 26 speaker.
NOTE:
Installation and service must be performed by authorized personnel only.
Installing the Speaker Mounting Plate
The SM 26 speaker comes with a flat mounting plate and an adapter for positioning the speaker 10° up, down, left, or right.
•
0° mounting plate
— The flat (0°) mounting plate allows the speaker to be mounted flat on a suitable surface.
•
10° mounting adapter
— The 10° mounting adapter allows the speaker to be installed at a 10 degree angle so that the
speaker can be pointed up, down, left, or right from an elevated position by rotating the adapter.
The mounting plate can be installed vertically or
horizontally as shown below right.
NOTES:
•
Observe all applicable building codes and local ordinances when installing the speaker.
•
If mounting the SM 26 with the yoke mount, see the
Yoke Mount Setup Guide
.
Mounting to a Wall Stud
1.
Locate the wall stud where the mounting plate will be installed.
2.
If using the 10° mounting adapter, position the adapter over the wall stud according to how the speaker will be angled and
mark the positions of the pilot holes. See the figure below right for mounting hole locations.
If not using the adapter, position the mounting plate against the wall. The #26 arrow molded into the mounting plate indicates
the vertical midpoint of the SM 26 speaker when it is mounted on a wall stud. While positioning the mounting plate on the
wall, mark the location of two pilot holes using the holes indicated below.
Horizontal Mounting
Catch Tab
Vertical Mounting
Mounting
Holes
33-0000-01 Rev.
Ax1
IN
–
LOOP
–
IN
+
LOOP
+
SM26 Speaker
Stud
Mounting
Holes
0° Mounting Plate
10° Mounting Adapter
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 SM 26 • Setup Guide (Continued) NOTE: A speaker wire access hole (see the following figures) must also be cut in the wall. Mark that hole location now with the mounting plate positioned on the wall while ensuring that the wall stud does not interfere with the wire routing and that the mounting pla...
3 Product Category NOTE: If surface mounting, route the wires through alternate access points as shown at right. ATTENTION: Use the appropriate mounting screws. The screw heads must not protrude more than 0.27 inch (7 mm) above the screw holes in the mounting plate (see the figure on the right). If ...
4 68-2164-50 Rev. B 09 13 Extron Headquarters +1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.863.1794 +1.714.491.1517 FAX +1.919.863.1797 FAX Extron Europe +800.3987.6673 (Inside Europe Only) +31.33.453.4040 +31.33.453.4050 FAX Extron Asia +800.733...
