Extron MTP - Manual

Table of Contents:

• Page 2 – Precautions; Safety Instructions • English; Extron’s Warranty
• Page 3 – FCC Class A Notice
• Page 4 – Chapter 1 • Introduction; UL requirements; Chapter 3 • Operation; Table of Contents
• Page 5 – Table of Contents, cont’d; VersaTools; Chapter One; Introduction; About the MTP Transmitters and Receivers
• Page 6 – The MTPs are a part of the Extron VersaTools; TP Cable Advantages; Transmission Distance
• Page 7 – Chapter Two; Installation; Signal Jumpers for Generational Comparibility
• Page 8 – Figure 2-1 — Removing the MTP cover; For the receiver; , slide the cover slightly forward to clear; If the transmitter or receiver is an audio unit; Figure 2-2 — Removing the audio board; CAUTION; Signal Jumpers for Generational Compatibility; Shift the new transmitter ’s and/or receiver ’s jumpers if:; You want the units to transmit stereo audio.; Setting the jumpers on non AAP models
• Page 9 – Figure 2-3 — Video board jumper locations; If the receiver is an audio unit; , locate the jumper block on; Replace the cover and the four screws removed in step 1.
• Page 10 – Setting the jumpers on AAP transmitters; Figure 2-5 — Removing the MTP cover; Figure 2-6 — Removing the audio board; Figure 2-7 — Video board jumper locations
• Page 11 – Mounting Options
• Page 12 – For projector mounting; Figure 2-11 — AAP mounting an MTP transmitter; Rack mounting instructions; Remove the feet from the bottom of the MTP, if installed.; Figure 2-10 — Desk and projector mounting the MTPs; For furniture mounting
• Page 13 – — Connect an S-video input to; Composite video connector (CV and AV models); — Connect a; . Longer bare wires can short; Panel Features and Connections; Transmitter input connections; Some transmitters do not have audio connections.; Figure 2-12 — Video and audio input connections
• Page 14 – mm Stereo Plug Connector; Audio input RCA connectors (RCA and AAP models); Figure 2-15 — RCA audio connectors; Transmitter/receiver throughput connections; Figure 2-16 — Throughput connections; Transmitter output and receiver input connector —; Connect
• Page 15 – TP cable termination; Side; Figure 2-17 — TP cable termination; Figure 2-18 — Power connections and indicators; Power connector —; Plug the external 12 VDC power supply; SECTION A–A; Figure 2-19 — Power connector wiring
• Page 16 – Power LED —; Indicates power is applied to the MTP.; Receiver output connections; Figure 2-20 — Output connector wiring; Composite video connector (CV and AV models) —; Connect a
• Page 17 – Chapter Three; Operation; Front Panel Features; Unbalanced Stereo Output; Some receivers do not have audio connections.
• Page 18 – Appendix A; Reference Information; Specifications; Figure 3-1 — MTP receiver front panels; All control knobs are removable to limit access if desired.; Troubleshooting — Skew Delay Compensation
• Page 19 – Specifications, Part Numbers, and Accessories; Sync; Video
• Page 20 – Rack mount; Specifications are subject to change without notice.; Connectors; General
• Page 21 – Skew compensation solutions; Part Numbers; MTP transmitters