Extron MTP 1500RL 15HD RS SEQ - Manual
Extron MTP 1500RL 15HD RS SEQ – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Precautions/Safety Instructions; Precautions; Safety Instructions • English; Achtung; Vorsicht; Instrucciones de seguridad • Español; 安全须知; 注意
- Page 3 – FCC Class A Notice; This device may not cause harmful interference.; NOTE; the unit to ensure compliance with FCC emissions limits.; click here; Information
- Page 4 – Conventions Used in this Guide; CE; Variables are written in slanted form as shown here:; ping; File; Copyright; © 2012 Extron Electronics. All rights reserved.; Trademarks
- Page 5 – Contents; Introduction; Power Supply Wiring; Operation; SEQ receiver skew compensation; Reference Information; Specifications; Mounting; UL Guidelines for Rack Mounting
- Page 7 – efers specifically to the MTP transmitter; Features; Compatible with HDTV component video, bi-level or tri-level sync
- Page 8 – Transmission Distance; Video Format; Maximum Transmission Distances; e that they comply with Category 5 specifications.
- Page 9 – Extron; Extron; Application Diagram; Typical MTP 1500RL 15HD RS SEQ Application
- Page 10 – Rear Panel Features; MTP 1500RL RS SEQ Receiver Rear Panel Features; — Plug the included external 12 VDC, 1 A, power supply into this; Power Supply Wiring” section; Always use a power supply supplied or specified by Extron. Use of an; Input connector; MTP 1500RL 15HD RS SEQ• Installation and Setup
- Page 11 – resolution video device to this 15-pin HD connector for RGB output.; End unit switch; MTP 1500RL 15HD RS SEQ • Installation and Setup
- Page 12 – Wire the supplied male power connector (plug) as in shown below.; Power Connector Wiring; The two power cord wires must be kept separate while the power
- Page 13 – TP Cable Termination; standards for all connections.
- Page 14 – This section describes the operation details for the; Front Panel Controls and Indicators; Front panel features are shown below.; MTP 1500RL 15HD RS SEQ Receiver Front Panel; — Indicates power is applied to the MTP.; Select button; — This recessed button selects the red, green, or blue video signal to
- Page 15 – Watch the displayed image to observe the steps of delay.; Level control; Peaking and Level Adjustment; Set the gain adjustment so that a white field video signal is +0.7
- Page 16 – Skew Delay Compensation; ed with test equipment or identified by viewing; SEt the skew delay to zero for red, green, and blue as follows:
- Page 17 – This section provides information about:; Video; Gain; Video input — see MTP Series transmitters specifications; composite video; Sync; MTP 1500RL 15HD RS SEQ • Reference Information
- Page 18 – General; Regulatory compliance
- Page 19 – Part Numbers and Accessories; Included Parts; mm, 3-pole captive screw connector for RS 232 connections; Optional Parts and Accessories; Description; Accessories; AV cable
- Page 20 – Tabletop Placement; Elevated operating ambient temperature —; adequate air flow for safe operation.; Mechanical loading —
- Page 21 – Rack Mounting Procedure; To mount the device on a rack shelf; DO NOT; Mounting the MTP on a Standard Shelf; Through-desk Mounting
- Page 22 – Extron Warranty; The Netherlands; USA; xtron
User Guide
MTP 1500RL 15HD RS SEQ
Twisted Pair
Extended Distance Twisted Pair Receiver
68-1555-01 Rev. B
01 12
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Precautions/Safety Instructions Precautions This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the p...
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interferen...
Conventions Used in this Guide In this user guide, the following are used: CAUTION: A caution indicates a potential hazard to equipment or data. NOTE: A note draws attention to important information. TIP: A tip provides a suggestion to make working with the application easier. WARNING: A warning war...