Extron MATRIX 50 - Manual

Extron MATRIX 50 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – Firmware Upgrade Procedure, cont’d; Remove Power; Disconnect the power cord from the switcher.; Partially Remove the Switcher from a Rack; Remove the machine screws that secure the switcher to the rack.; CAUTION; Firmware Upgrade Procedure
Page 3 – Remove the front panel; Power must be disconnected the cord from the switcher.; Lay the front panel down in front of the switcher.; Replace the Firmware IC; Replace the firmware IC as follows:; Figure 2 — Location of IC U7 on the front panel board
Page 4 – Figure 3 — Key and pin 1 mark; Reinstall the Front Panel and Initialize the Switcher

Loading the manual

Matrix Switchers

CrossPoint Plus, CrossPoint, MAV, Matrix 50

Firmware Upgrade Procedure

68-353-06

Rev. B

03 05

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Firmware Upgrade Procedure, cont’d; Remove Power; Disconnect the power cord from the switcher.; Partially Remove the Switcher from a Rack; Remove the machine screws that secure the switcher to the rack.; CAUTION; Firmware Upgrade Procedure

Firmware Upgrade Procedure, cont’d CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure 2 This procedure details how to replace a CrossPoint Plus, CrossPoint, MAV, orMatrix 50 firmware IC chip without disconnecting all of the input and outputconnections. The IC that contains the fir...

Page 3 - Remove the front panel; Power must be disconnected the cord from the switcher.; Lay the front panel down in front of the switcher.; Replace the Firmware IC; Replace the firmware IC as follows:; Figure 2 — Location of IC U7 on the front panel board

3 CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure Remove the front panel Before you can replace the firmware IC, you must remove the matrix switcher ’sfront panel as follows: Power must be disconnected the cord from the switcher. 1 . If the switcher has screws on its top and bo...

Page 4 - Figure 3 — Key and pin 1 mark; Reinstall the Front Panel and Initialize the Switcher

Firmware Upgrade Procedure, cont’d CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure 4 3 . Note the key (angled corner) of the replacement firmware IC and the dot onthe underside that indicates pin 1 (figure 3). Orient the IC to match the keyand pin 1 (indicated by arrow) on the ...