Extron MATRIX 50 - Manuals

Extron MATRIX 50 – Manual in PDF format online.

Manuals:

Manual

Manual Extron MATRIX 50

Summary

Page 2 - Firmware Upgrade Procedure, cont’d; Remove Power; Disconnect the power cord from the switcher.; Partially Remove the Switcher from a Rack; Remove the machine screws that secure the switcher to the rack.; CAUTION; Firmware Upgrade Procedure

Firmware Upgrade Procedure, cont’d CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure 2 This procedure details how to replace a CrossPoint Plus, CrossPoint, MAV, orMatrix 50 firmware IC chip without disconnecting all of the input and outputconnections. The IC that contains the fir...

Page 3 - Remove the front panel; Power must be disconnected the cord from the switcher.; Lay the front panel down in front of the switcher.; Replace the Firmware IC; Replace the firmware IC as follows:; Figure 2 — Location of IC U7 on the front panel board

3 CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure Remove the front panel Before you can replace the firmware IC, you must remove the matrix switcher ’sfront panel as follows: Power must be disconnected the cord from the switcher. 1 . If the switcher has screws on its top and bo...

Page 4 - Figure 3 — Key and pin 1 mark; Reinstall the Front Panel and Initialize the Switcher

Firmware Upgrade Procedure, cont’d CrossPoint Plus/CrossPoint/MAV/Matrix 50 • Firmware Upgrade Procedure 4 3 . Note the key (angled corner) of the replacement firmware IC and the dot onthe underside that indicates pin 1 (figure 3). Orient the IC to match the keyand pin 1 (indicated by arrow) on the ...