EverFocus EHD363 - Manual
EverFocus EHD363 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FEATURES; Vandal proof to withstand impact of a 10 pound sledgehammer.
- Page 5 – INSTALLATION INSTRUCTIONS; Remove the dome cover.; Conduit plug
- Page 6 – the matching color receptacles on the power board.; NOTE: the 2 pin blue connector goes into the; Failure to properly attach these connectors may; General Connection and Setup; Connect the power cord to DC 12V or AC 24V power supply
- Page 7 – If you move the camera module; , it is necessary to loosen the dome and liner and; reposition; , and the rubber seal presses onto the clear part of the; Lens adjustment
- Page 8 – EverFocus Electronics Corp.; Shangdi Information Industry Base,
EVERFOCUS
Dual Power High Resolution Vandal Proof
Weather Resistant 3-Axis IR Dome Camera
Operation Instructions
Model No.
EHD363
Please read this manual first for correct installation and operation. This manual should be retained for
future reference. The information in this manual was current when published. The manufacturer reserves
the right to revise and improve its products. All specifications are therefore subject to change without
notice.
PRECAUTIONS
1.
Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers and audio speakers
since the electromagnetic fields generated from these devices may distort the video image or otherwise interfere
with camera operation.
2.
Never disassemble the camera beyond the recommendations in this manual nor introduce materials
other than those recommended herein.
Improper disassembly or introduction of corrosive materials may result in equipment failure or other damage.
3.
Try to avoid facing the camera toward the sun.
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or internal circuits, as
well as creating unbalanced illumination beyond the capability of the camera to compensate.
4.
Keep the power cord away from water and other liquids and never touch the power cord with wet
hands.
Touching a wet power cord with your hands or touching the power cord with wet hands may result in electric
shock.
5.
Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.
6.
Cleaning
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with the hands. Use
lens tissue or a cotton tipped applicator and ethanol to clean the sensor and the camera lens. Use a damp soft
cloth to remove any dirt from the camera body. Please do not use complex solvents, corrosive or abrasive
agents for cleaning of any part of the camera.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 7. Do not operate the camera beyond the specified temperature, humidity or power source ratings. This camera is suitable for indoor and outdoor operation. Use the camera at temperatures within -10°C to +50°C (14°F to 122°F) and in an IP66 compliant environment; this device is not rated as submersi...
4 INSTALLATION INSTRUCTIONS Drill the Holes 1. Locate the desired mounting location; position housing with camera pointed generally in the desired direction and mark location. 2. Use template to fix hole locations. Drill 4 holes for mounting screws (or anchors and insert plastic anchors into holes a...
5 5. Disconnect the power and video wire from the camera board end of the wire (1x 4 pin white connector) and the 2 power wires from the power board attached to the base plate (1 x 2 pin connector with blue marking and 1 x 2 pin connector with white color). Gently pull the wires out from under the p...
