EverFocus ECD230 - Manual
EverFocus ECD230 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PREFACE; and Auto White Balance functions.; FEATURES; CCD; STANDARD ACCESSORIES; Camera Unit
- Page 3 – Remove the plastic dome cover.
- Page 4 – Put the plastic cover back on the Dome Camera.
- Page 5 – SPECIFICATIONS
- Page 6 – EverFocus Electronics Corp.; 15 Oser Avenue Unit S
EVERFOCUS
Color Dome Camera
Operation Instructions
Model:
ECD230
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1.
Do not have camera immersed in water.
2.
Do not disassemble it or place it on an unstable base.
3.
Do not touch the surface of CCD sensor by hand directly.
4.
Never face the camera toward the sun.
5.
Use proper power source otherwise the camera will not function correctly.
6.
Use the camera at temperatures within 0
℃
~ 50
℃
/32
℉
~122
℉
and humidity between 20%~
80%. The input power sources is 12VDC only.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 PREFACE These cameras are compact, full functioned CCD cameras. Their stylish appearance can be applied as per installer's ideal locations. These dome cameras can be mounted either on the ceiling or on the wall easily. The camera uses high sensitive 1/3" color interline transfer CCD sensor wit...
2 LENS AVAILABLE * Standard board lens f=3.6 mm, F=2.0 mm. * Other available lens : 4 Lens f=4.3 mm, F=2.0 mm 6 Lens f=6.0 mm, F=2.0 mm 8 Lens f=8.0 mm, F=2.0 mm INSTALLATION 1. Remove the plastic dome cover. 2. Loosen the two screws of the supporting bracket to remove the camera body. 3. Using four...
3 5. Connect the BNC connector of the camera to a color monitor, or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension. 6. Connect the DC +12V regulated power source of the camera (DC Jack) to the DC 12V Power-in jack with 2 mm, center+, outer- plug. ...
