Everdure NBUDLPC-12 - User Manual

Page 2 - NEO BUDDY OUTDOOR BARBECUES; CONTENTS

2 ASSEMBLY, OPERATION AND MAINTENANCE INSTRUCTIONS FOR EVERDURE NEO BUDDY GAS BARBECUE NEO BUDDY OUTDOOR BARBECUES CONTENTS SECTION PAGE NO. General Safety Instructions 3 Appliance Details 4 Gas Connections 4 Outdoor Installation Guide 5 Operating Instructions for Barbecue 6 Lighting Procedure 7 Coo...

Page 4 - APPLIANCE DETAILS; GAS CONNECTIONS; LOCAL AUTHORITY REQUIREMENTS; Do not connect gas to a barbecue that is not secured in a trolley.; LEAK TESTING; Make sure gas control is Off and turn the cylinder valve On.

4 APPLIANCE DETAILS Gas Type: ULPG Burner Pressure: 2.75 kPa Injector Diameter: Ø0.87 mm Heat Input: 9.5 MJ/ hr Note: The size of the injector diameter is stamped on one of the hexagon faces (e.g. ‘165’ for Ø1.65mm injector). Air is admitted at the underside of the combustion chamber (a 200mm x 20mm...

Page 5 - OUTDOOR INSTALLATION GUIDE; at least 25% of the total wall area is completely open: and

5 OUTDOOR INSTALLATION GUIDE This Appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. This appliance must not be used indoors. Do not us...

Page 6 - OPERATING INSTRUCTIONS

6 OPERATING INSTRUCTIONS THIS BARBECUE IS INTENDED FOR USE WITH THE SUPPLIED TROLLEY ONLY. RUNNING THE BARBECUE WITHOUT THE TROLLEY WILL VOID ALL WARRANTIES. ASSEMBLE THE TROLLEY BEFORE UNPACKING THE BARBECUE. GAS TYPE AND CONSUMPTION The barbecue is designed to operate on Universal LP Gas (Propane ...

Page 7 - LIGHTING PROCEDURE; MANUAL IGNITION; When finished, make sure burner control knobs are turned OFF.

7 LIGHTING PROCEDURE READ ALL OPERATING INSTRUCTIONS BEFORE LIGHTING THE APPLIANCE. OPEN THE HOOD BEFORE LIGHTING. MAKE SURE ALL GAS CONTROL KNOBS ARE IN THE ‘OFF’ POSITION AND OPEN CYLINDER VALVE. MAKE SURE THE PLATE IS IN ITS CORRECT COOKING POSITION WITH A GAP AT THE FRONT. LIGHTING THE BARBECUE ...

Page 8 - CLEANING AND STORAGE; EXTERNAL CLEANING; STORE CYLINDER IN A WELL VENTILATED AREA OUT OF REACH OF CHILDREN; GAS SUPPLY; Wipe over barbecue trolley with a clean cloth.

8 CLEANING AND STORAGE EXTERNAL CLEANING Before cleaning the barbecue exterior, ensure the appliance has cooled and is safe to touch. Painted and plastic surfaces can be cleaned using a mild household detergent or cleaner and a clean cloth (do not use scourers or harsh detergents). It is advisable t...

Page 9 - TROUBLESHOOTING; Burner will not ignite when using the igniter:; MAINTENANCE

9 TROUBLESHOOTING Burner will not ignite when using the igniter: Cylinder valve is not on Turn cylinder valve on. Cylinder is empty Replace with a full cylinder. Igniter is not sparking Remove plate and visually check ignition box for a spark. If there is no spark contact, check connections. Injecto...

Page 10 - TROLLEY ASSEMBLY; PROTECTIVE FOAM AND FIX TO TROLLEY IMEDIATELY.; NEO Buddy Trolley Stand

10 TROLLEY ASSEMBLY REMOVE THE BBQ IN FOAM ENDS FROM THE CARTON FIRST. TAKE CARE THAT HOSE IS NOT DAMAGED. ASSEMBLE THE TROLLEY BEFORE REMOVING THE BARBECUE FROM ITS PROTECTIVE FOAM AND FIX TO TROLLEY IMEDIATELY. NEO Buddy Trolley Stand PARTS REQUIRED / INVENTORY Make sure you thoroughly inspect par...

Page 11 - STEP 2: Fitting the castor to the right leg assembly.

11 Take the axle and thread on one wheel and one wheel spacer (wide end towards the wheel). Note some models have the spacer built into the wheel. Thread the axle fully through the right leg assembly from the front and thread the second wheel spacer and wheel on. Tighten the M8 lock nut and tighten....

Page 15 - COLLAPSING THE TROLLEY; STEP A: Remove the barbecue and undo the handle lock.

15 COLLAPSING THE TROLLEY The trolley can be collapsed down in size for easier storage or for transporting the barbecue. After removing the barbecue (take care that it is correctly supported so no damage can be done to the hose), go to the left hand side of the trolley. Rotate the handle lock outwar...

Page 16 - COLLAPSING THE TROLLEY – 5 EASY STEPS FOR CONVERSION; all

16 COLLAPSING THE TROLLEY – 5 EASY STEPS FOR CONVERSION The castor must be fitted before collapsing the trolley. Do not use the trolley in the collapsed form over rough ground, as damage to the trolley may occur. Take care to restrain the handle at all times. When adjusting the trolley configuration...

Page 17 - Fully Assembled Product