Equator EZ 5500 CV BL/BK - User Manual

Page 2 - Please read the Owner’s Manual carefully before using your

Introduction ................................................................. Warranty .................................................................... Technical Data .............................................................. Important Safety Instructions ......................................

Page 3 - Here are some of the best reasons for buying your Super Combo; Specialized Wash Programs; Vented Dry; Portability; portability kit

1 Congratulations on your new Super Combo! In addition to its contemporary design, this is a highly sophisticated engineered product that will give you many years of satisfaction. Lint Free Maintenance The Washer + Dryer’s sleek and compact size design makes it a perfect appliance for any kitchen or...

Page 4 - family or household use for 1 Year Parts & Labor and limited; WARRANTY; and you may also have other rights which vary; Q U E S T I O N S / S E R V I C E

2 Your appliance is protected by this warranty under normal, personal, family or household use for 1 Year Parts & Labor and limited commercial use (90 days) in USA and Canada. WARRANTY Consolidated Brands undertakes to the consumer/owner to repair or, at our option, to replace any part of this p...

Page 5 - THE FOLLOWING WORK ARE NOT COVERED UNDER WARRANTY:; EXCLUSIONS

3 Installation 1. Non-removal of shipping bolts, causing vibration / internal damage.2. Non-adjustment of feet to level machine, causing vibration / internal damage.3. Non-removal of exhaust vent plate at the back while using Venting Dry mode, causing excess heat and resulting in damage to internal ...

Page 7 - to protect you and your family.

5 To reduce the risk of fire due to contaminated loads, the final part of a tumble dryer cycle occurs without heat (cool down period). Avoid stopping a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. 16. Your Combo W...

Page 8 - Front Loading detergents

6 The unit must be installed on a strong leveled surface in a protected, dry and well-ventilated area, with a power and water supply of sufficient capacity and a sufficient outlet in close proximity. MODEL No: SERIAL No: By using High Efficiency (HE) detergent, Front Loading detergents 19 lbs. 1400 ...

Page 9 - Water Inlet Hoses

7 Venting Fan and Cover Drain Hose U-Connector Power Cord Shipping Bolts Drum Top Panel Control Panel Detergent Dispenser Drawer Door Leveling Feet Pump Filter Door ReleaseLever Drain Tube Tube Cap Cold Water Inlet Valve Hot Water Inlet Valve Blanking Cap s - 3 (To cover shipping bolts hole) Vent Ad...

Page 11 - NOTE

b o l t s b o l t s b o l t s NOTE Save the bolt assemblies for future use. To prevent damage to internal components, DO NOT transportthe washer-dryer combo without reinstalling the shipping bolts.Failure to remove shipping bolts and retainers may cause severe vibration and noise, which can lead to ...

Page 13 - , with screws provided for; Dryer can be used in Ventless or Vented mode

12 VENTLESS (CONDENSING) DRY VENTED (HOT AIR) DRY 1. ENSURE METAL VENT COVER (1) IS INSTALLED OVER EXHAUST FAN AS SHOWN IN FIG.82. Power on the machine3. Press "Dry Only" button to set the machine on drying cycle.4. Hold Vented/Ventless button for 5 seconds5. symbol will appear on the screen...

Page 14 - CONNECTING; white

Ring plate Guide plate Latch plate 1. Unscrew the adapter ring plate and the 4 adapter retaining screws. 2. Remove the guide plate if the tap is too large to fit the adapter. 3. Push the adapter onto the end of the tap so that the rubber seal forms a watertight connection. Tighten the adapter ring p...

Page 16 - MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALATION; Other installation must use the minimum dimension indicated.

14 BUILT-IN, RECESSED, CLOSET AND ALCOVE INSTALLATION MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALATION 2" 2" 3" 3" 3" 3" Maximum Length of Exhaust Duct is 10 feet Minimum clearances to combustible surfaces: 2" (5 cm) clearance both sides and 3" (7.5 cm) rear....

Page 17 - Refresh Dry; - 12 mins cycle blowing hot air onto the clothes before folding.; Winterize; - 9 mins cycle at 90 to clean the inner drum and tub of the machine; Wash Programs; Mixed Clothes

15 2. DRY CYCLES Refresh Dry - 12 mins cycle blowing hot air onto the clothes before folding. Time Dry 60 - 60 mins dry cycle. 3. OTHER CYCLES: Rinse/Spin - 12 mins Spin cycle at 1000 RPM. Winterize - 2 minute cycle to winterize your appliance. (follow procedure on page 18) o Self-Clean - 9 mins cyc...

Page 18 - Washing Net Bag; Use Front Load detergent,; reduces or eliminates suds and results in more efficient washing.; Pour 2 cups of RV type Antifreeze in soap dispenser.; and bleach

16 For small items such as socks, children’s garments and small towels please use a Washing Net Bag . Use Front Load detergent, . as per direction If you are using Wash Only cycle, you can fill the drum.If you are using Wash + Dry cycle, please do not load clothes more than 2/3 full. You can add fab...

Page 19 - P o w e r; Pause

17 Vented /Ventlessselectionbutton mode mode Vented dry mode. The default is Normal and you can select Extra, Low or Damp Dry. Press this button to select the dry level for a Sensor Dry cycle. Dry only and Dry level buttons for 5 seccods Vented Ventless Ventless mode. Ventless dry mode P o w e r Pre...

Page 20 - level options; B. How to run WASH Only Cycle; Only for wash settings

level options 18 A. How to run WASH + DRY Cycle 1. Press POWER button 2. Press START Default cycle is NORMAL - If required you can change to desired washing cycle based on type of clothes by rotating the Program Dial knob. 1. Press POWER button 2. Press WASH Only button 3. Press START 1. Press POWER...

Page 21 - Understanding the door lock function; How to stop the wash cycle; Breakage of the door handle is not; How to turn on the display in energy saving mode?; - Press POWER button for 3 seconds to turn off the machine

19 Understanding the door lock function How to stop the wash cycle How to stop the dry cycle - The wash program can be stopped at any time.- Press START/PAUSE for 5 seconds- Press POWER button for 3 seconds to turn off the machine Breakage of the door handle is not How to turn on the display in ener...

Page 22 - is

20 2 1 Fig.16 Fig.15 Fig.14 Fig.13 (Fig.14) (Fig.15) (Fig.16) (Fig.13) Fig.17 (Fig.17) (Fig.18, Fig.19) Fig.18 Fig.19 is - If Vent Dry mode is used, clean the exhaust fan and exhaust duct at least once a year to prevent lint build-up.

Page 25 - enough; Condensation at soap dispenser; Front Load detergent; bolts; Not drying; Does selected program incorporate water draining?

23 enough Is the dryer button correctly pressed for the drying cycle?Is drying cycle selected (Time Dry/Sensor Dry)? Condensation at soap dispenser Slight condensation can occur at soap dispenser and will evaporate. This is normal. Front Load detergent 4" Power Front loading bolts Not drying PED...

Page 26 - Code; DIAGNOSTIC MENU

24 DIAGNOSTIC MENU Door open Drain failure Water inlet failure Water overﬁll Motor failure Washing heater failure Dryer Malfunction Dryer Malfunction Water level failure Dryer Malfunction Dryer Malfunction Dryer Malfunction Communication betweendisplay & electronic module Door Switch Drain Pump ...

Equator EZ 5500 CV BL/BK - User Manual

Table of Contents:

Summary

Other Equator Washing Machines Models