Epson WP-4530- Quick Guide

Start Here

4

Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.

5

Gently insert the paper cassette at the bottom of the
printer.

Note:

The paper may slide forward slightly as you insert the

cassette. This is normal.

6

Extend the output tray and raise the paper stopper as
shown. (Do not raise the paper stopper for legal-size
paper.)

6

Connect the fax line

To fax, connect the included phone cord to a telephone wall
jack and to the LINE port on the back of your product. To
connect a telephone or answering machine, use the EXT. port
on your product. See the

Quick Guide

for more details.

Note:

If you’re connecting to a DSL phone line, you must use a DSL

filter or you won’t be able to fax. Contact your DSL provider for the
necessary filter.

Read these instructions before using your product.

1

Unpack

French

control panel

sticker

Caution:

Do not open ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all tape and protective materials, including the foam and
plastic inside the printer.

2

Turn on

1

Connect the power cord to the back of the printer and to an
electrical outlet.

Caution:

Do not connect to your computer yet.

2

Press the

power button.

3

Select settings

1

To select

English

as your language, press

OK

.

If you want to change the language, select it and
press

OK

.

2

Select your country and press

OK

.

3

Select

Summer

if Daylight Saving Time is in effect

(spring through summer); otherwise, select

Winter

.

Press

OK

.

4

Select the date format and press

OK

.

5

Use the numeric keypad to set the date and press

OK

.

6

Select

12h

(

AM

/

PM

) or

24h

and press

OK

.

7

Use the numeric keypad to set the time and press

OK

.

Note:

You can change the date and time settings by pressing

Setup,

selecting

Printer Setup

, then selecting

Date/Time

.

4

Install ink cartridges

1

Open the front cover.

2

Unpack the four ink cartridges.

3

Shake each cartridge as shown for about 5 seconds.

4

Install each cartridge in the correct slot for its color. Push
each cartridge in until it clicks.

5

Close the front cover.

The printer starts priming the ink. This takes about
12 minutes. When the green

power light stops

flashing, priming is complete.

Note:

The included cartridges prime the printer and print about

1000 black pages/900 color pages. Actual page count will vary.

Caution:

Don’t turn off the printer or open the cover while it is

priming or you’ll waste ink.

6

When you see this menu on your product’s LCD screen,
do not press the

OK

button yet. Continue with the

instructions in the following sections to load paper in
your product and install software.

5

Load paper in the cassette

You can load letter-, A4-, or legal-size plain paper in the
cassette. For instructions on loading envelopes and special
paper in the rear MP tray, see the online

User’s Guide

.

1

Pull out the paper cassette.

2

Slide the edge guides outward.

Note:

If loading legal-size paper, extend the cassette as shown.

3

Insert the paper with the printable side facedown.

Note:

Make sure the paper is loaded against the edge guide

and not sticking out from the end of the cassette.

*412178400*

*412178400*

WorkForce

®

Pro WP-4530