Epson UB-E02- User Manual
Epson UB-E02– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Part Names; The following view shows the part names of the UB-E02.; Switches; please ask the dealer where you purchased your product.; Connecting the Cables; Make sure both the printer and the host computer are turned off.
- Page 3 – How to Set Up the UB-E02; Preparation; Printing a Status Sheet; and configure only one printer at a time.; Resetting the UB-E02 to Factory Defaults; Setup; Reference Guide
- Page 4 – EMC Standards Applied; WARNING; CE Marking; For Canadian Users
1
UB-E02 User’s Manual
Copyright © Seiko Epson Corporation 2004
Printed in China 2004.01
Introduction
The UB-E02, designed for EPSON
®
TM printers, is a 10BASE-T/100BASE-TX
Ethernet interface board.
This manual provides instructions, including a simple setup for operators of
POS systems in which the UB-E02 is installed so that the operators can use the
UB-E02 safely and correctly.
Key to Symbols
The symbols in this manual are identified by their level of importance, as
defined below. Read the following carefully before handling the product.
CAUTION:
Cautions must be observed to avoid minor injury to yourself, damage to
your equipment, or loss of data.
Note:
Notes have important information and useful tips on the operation of your equipment.
Caution Label
The following caution label is visible near the display module connector.
The label has the following meaning:
“The display module connector and the drawer kick-out connector use the
same type of the Ethernet connector; therefore, be sure not to connect the
Ethernet connector cable or the telephone line to the display module connector
or the drawer kick-out connector.”
Features and Functions
❏
Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for
OPOS)
❏
Communication standard: 10Base-T/100Base-TX, Full duplex/half
duplex
❏
OPOS, JavaPOS, APD support
405223601
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Part Names The following view shows the part names of the UB-E02. Note: This photograph shows the TM-H6000II printer with the UB-E02 installed. Switches When using this interface board, the DIP switches of the TM printer must be set to “parallel” with the appropriate settings. Set the reset signal...
3 How to Set Up the UB-E02 Preparation Printing a Status Sheet Power on the printer. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-E02. You can check all setting values necessary (IP address, Subnet mask, Gateway address) ...
4 ❏ Obtaining the TMNetWinConfig and the UB-E02 Technical Reference Guide For customers from North, Central, or South America, go to the following web site: http://pos.epson.com/ For customers from other countries, go to the following web site: http://www.epson-pos.com/Select the product name from t...
