Epson PixiePlus Control System for Projectors- Installation Manual
Epson PixiePlus Control System for Projectors– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – If it does not, be sure the PixiePlus is powered.; Note; : Reprogramming any button erases the code that is already in place.
- Page 4 – TIP; Using the Programming Wand to Set Schedule Events; Power Off; Important; without erasing
- Page 5 – Restoring the PixiePlus to its Default Preconfiguration
PixiePlus
TM
ELPSP10 Supplement
for the Epson
®
Projector Controller
Contents
1. Installation of the Epson Projector Controller with the Epson AP-60
Configuration 1 – Projector Volume Control
Configuration 2 – AP-60 IR Volume Control
2. Using the Programming Wand (PXE-PGM-TOOL) to Reprogram the PixiePlus
3. Using the Programming Wand to Set Schedule Events
4. Restoring the PixiePlus to its Default Preconfiguration
1. Installation of the Epson Projector Controller with the Epson AP-60
The PixiePlus may be easily set up to work with the Epson AP-60 Audio System in two
basic configurations.
Configuration 1 – Projector Volume Control
In this configuration, route the
audio for the various display
devices in your room through your
Epson projector. The PixiePlus will
control the audio switching and
volume level on the projector with
its preconfigured RS-232 codes.
Connect the audio output from the
projector to the audio input on the
AP-60.
A. Connect the audio outputs from
your display devices to your
projector as shown in the projector
documentation.
B. Connect the 3.5mm jack labeled
Audio Out
on your projector to the
AP-60 jack labeled
Line 1 LCP
.
Once this cable is connected the projector speakers will be inactive.
C. If you wish to control the power On/Off of the AP-60 connect the IR emitter output
from PixiePlus Ceiling Plate to the IR receiver of AP-60 to enable power control of AP-60
when the PixiePlus
Audio
button is pressed. The IR codes for AP-60 are preconfigured
in the PixiePlus.
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Configuration 2 – AP-60 IR Volume Control In this configuration the PixiePlus will control the volume level of the AP-60 directly withIR codes. If you have multiple audio sources, you should consider how to handle audioswitching before implementing this configuration. Connect audio devices to the AP...
G. Program PixiePlus: Place the wand so that it is linedup against the top of the PixiePlus bezel as shown. Besure the plastic window of the Wand which faces towardthe PixiePlus is lined up with the two small circularopenings on either side of the bezel, the one labeled“aim remote to be learned here...
A. Connect the Programming Wand to your PC and launch the Configuration Utility asdescribed in s ection 2, steps A-B above. B. Select the Wand Time tab and verify that the clock is set to the correct time. If the wand time is not correctly set, verify that your computer's clock is correct and select...
