Epson L90P - TM Two-color Thermal Line Printer - User Manual

TM-L90 with Peeler User’s Manual 1 English English TM-L90 with Peeler User’s Manual All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the...

2 TM-L90 with Peeler User’s Manual English WARNING The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to...

TM-L90 with Peeler User’s Manual 3 English CAUTION: Do not connect cables in ways other than those mentioned in this manual. Different connections may cause equipment damage and burning.Be sure to set this equipment on a firm, stable, horizontal surface. The product may break or cause injury if it f...

4 TM-L90 with Peeler User’s Manual English Power Switch and Power Switch Cover The power switch is on the top left of the printer. Press it to turn on the printer, and press and hold it for more than 3 seconds to turn off the printer. Power Switch Cover You can use the enclosed power switch cover to...

TM-L90 with Peeler User’s Manual 5 English CAUTION: Never install the printer in locations that receive direct sunlight. The diffuse reflection from the roll paper may cause the label peeler detector to malfunction. When a malfunction occurs, the PAPER OUT LED starts flashing. Press the FEED button ...

6 TM-L90 with Peeler User’s Manual English 5. Make sure that the mode switch is set to the mode you are going to use. (To the right for the label peeler issuing mode, or to the left for the label continuous issuing mode.) 6. Pull out the paper until the end exactly reaches the guideline (indicated w...

TM-L90 with Peeler User’s Manual 7 English 8. When using the label continuous issuing mode (not using the peeler), close the peeler cover now. When using the peeler (the label peeler issuing mode), pass the paper through the peeler, and close the peeler cover. 9. Press the PAPER FEED button. The pap...

8 TM-L90 with Peeler User’s Manual English CAUTION: When installing roll paper, be careful not to injure your hands on the manual cutter. Troubleshooting ERROR LED is on or flashing ❏ Make sure that the roll paper cover is closed and the PAPER OUT LED is not on. Close the cover or replace the paper ...

TM-L90 with Peeler User’s Manual 9 English Cleaning the Platen Roller/Roll Paper End Sensor When paper dust accumulates on the platen roller or the roll paper end sensor, follow the steps below to clean them. To maintain good functional capabilities, clean them regularly (every 6 months).1. Turn off...

10 TM-L90 with Peeler User’s Manual English Using Different Paper Widths Be sure to set the paper width with the memory switch to match printing to the print width. (For detailed information on the memory switch, see the TM-L90 with Peeler Technical Reference Guide .) Also, do not increase the paper...

TM-L90 with Peeler User’s Manual 11 English 3. Slide the roll paper spacer to the appropriate width, as shown above. You can use the measurement printed inside the printer, aligning the inside edge of the spacer with the desired measurement. Width note: When you want to set the roll paper width from...

12 TM-L90 with Peeler User’s Manual English To place cables, first break off by hand any of the three portions indicated by circles in the illustration (the other portion is on the right). Then put the cables through the holes and replace the bottom of the cover. Cover Operation Label If you use the...