England's Stove Works 50-TRW20 - Manual

England's Stove Works 50-TRW20

England's Stove Works 50-TRW20 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
Page: / 11

Table of Contents:

  • Page 4 – the fire. Continue to leave the door cracked slightly.
  • Page 6 – A. Catalytic Maintenance and Replacement; Note; or
  • Page 7 – that hold in; SECTION VII: CHIMNEY MAINTENANCE; NOTE; : It is a good idea to thoroughly clean your stove and chimney in
  • Page 8 – REPLACEMENT PARTS LIST; CUSTOMER SERVICE DEPARTMENT
  • Page 9 – The manufacturer extends the following warranties:; Conditions and Exclusions:; NOTE: THIS WARRANTY IS NULL AND VOID IF YOU DO NOT RETURN; WARRANTY IS NOT TRANSFERABLE.
  • Page 11 – WARRANTY REGISTRATION for England’s Stove Works; DEALER INFORMATION; How did you first hear about our product? (please check one); IMPORTANT NOTICE; Customer Service Department
Loading the manual

INSTALLATION AND OPERATION MANUAL

Thank you for purchasing this product from a fine line of heating equipment.

We wish you many years of safe heating pleasure.

Visit our web page at

www.englandsstoveworks.com

for helpful information,

frequently asked questions, parts & accessory orders and more.

NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO

THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489.

CAUTIONS AND WARNINGS:

READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION

CAUTION:

This unit must be installed in accordance with these instructions and must

comply with local building and fire codes. Failure to do so could result in a chimney or
house fire, property damage, bodily injury or even death.. Keep children, furniture,
fixtures and all combustibles away from any heating appliance.

England’s Stove Works highly recommends the use of smoke detectors and Carbon

Monoxide detectors with any hearth product, including this unit. Follow all manufacturer’s

instructions when using smoke or Carbon Monoxide detectors.




DO NOT INSTALL THIS UNIT IN A MOBILE HOME OR DOUBLE WIDE!

DO NOT INSTALL THIS UNIT IN A PRE-MANUFACTURED FIREPLACE!

FOR MASONRY FIREPLACE INSTALLATION ONLY.

This product contains a catalytic combustor, which needs periodic inspection and
replacement for proper operation. It is against the law to operate this wood heater in a
manner inconsistent with the instructions in the manual or if the catalytic element is
deactivated or removed.

Our catalytic stoves are designed to burn seasoned, dry wood.

24-JC, 50-SHW20 and 50-TRW20


COMPLIANCE STATUS

TYPE OF FUEL

WOOD

EMISSION RATE

2.1 GRAMS PER HOUR

OVERALL EFFICIENCY

83.04%

HEAT OUTPUT TEST RANGE

7,200 TO 28,600 BTU/HR

EPA CERTIFICATE NUMBER

267

THIS UNIT IS CERTIFIED TO EPA PHASE II STANDARDS


Rev. 1/06

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - the fire. Continue to leave the door cracked slightly.

SECTION IV: ACCESSORY ITEMS AC-104 (SH-104) Brass Trim The AC-104 trim kit covers the two front edges of the stove and the three edges of the cover plate. The stove lip trim simply snaps over the edges of the stove. There are two angle clips that hold the three pieces of cover plate trim together – ...

Page 6 - A. Catalytic Maintenance and Replacement; Note; or

4. Allow the stove to burn for about 15 to 20 minutes with the door cracked one-half inch (½”). 5. You can close the door completely, but leave the draft controls open. Allow the stove to burn 10 to 15 minutes in this mode. 6. Close the by-pass damper and burn the unit for another 5 minutes. 7. Once...

Page 7 - that hold in; SECTION VII: CHIMNEY MAINTENANCE; NOTE; : It is a good idea to thoroughly clean your stove and chimney in

5. The combustor can be removed by dropping the flame impingement plate as described and then the four (4) 3/8” brass nuts (they take a 9/16” wrench) that hold in the combustor collar (Part #CA-1710). This will give you full access to the catalytic combustor. At this point the manufacturer’s cleanin...

Other England's Stove Works Models

All England's Stove Works Other