Empava EPA-30RH03 - User Manual

Page 2 - Important Safety Notice; To reduce the risk of fire, electric shock, or injury to persons:; DO NOT; To reduce the risk of a stove top grease fire:

Page 1 Important Safety Notice Read all Instructions before Installing and operating this appliance The installation in this manual is intended for qualified installers, service technicians or persons with • similar qualified background. Installation and electrical wiring must be done by qualified p...

Page 3 - To reduce the risk of injury to persons in the event of a gas leaks:; WARNING; what can happen if the instructions are not followed.

Page 2 Important Safety Notice Read all Instructions before Installing and operating this appliance The manufacturer and/or distributor/reseller declines all responsibility in the event of failure to ob- serve the instructions given here for installation, maintenance and suitable use of the product....

Page 4 - Table of Contents; INSTALLATION

Range hood operations............................12-13 Troubleshooting...........................................14 Cleaning...............................................15 Table of Contents INSTALLATION Tools needed....................................................3 Parts supplied..................

Page 6 - Venting Requirements; For the most efficient & quiet operation:

Page 5 Ceiling Height Venting Requirements Height & Clearance Under Cabinet Range hood 36” Counter Top Min: 28” Max: 31” Vent system must terminate to the outside • (roof or side wall). DO NOT terminate the vent system in an at - • tic or other enclosed area. DO NOT use 4” (10.2 cm) laundry-type...

Page 7 - Duct Run Calculation:; Calculating Vent System Length

Page 6 IMPORTANT: A minimum of 6 ” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate - • ly) must be used to maintain maximum airflow efficiency. Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided • duct. Ple...

Page 8 - Venting Methods; Vertical roof venting; Horizontal wall venting

Page 7 Venting Methods This range hood is factory set for venting through the roof or wall. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. • IMPORTANT: NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling...

Page 9 - Electrical Requirements; It is the customer’s responsibility:

Page 8 Electrical Requirements IMPORTANT: For Europe and Other Countries with 220~240V/50Hz, please observe your local governing codes and ordinances. It is the customer’s responsibility: To contact a qualified electrical installer. • To assure that the electrical installation is adequate and in con...

Page 10 - Preparation; Advanced Preparations:

Preparation Page 9 Advanced Preparations: Be familiar with the controls of the range hood by reading 1. through Range Hood Operations , Page 12. Place the range hood on a flat, stable surface. Connect the 2. range hood to a designated standard outlet, 110~120V/60Hz (220~240V/50Hz for Europe & ot...

Page 11 - Installations; directly; Installation

Installations (refer to page 4 & 11 for parts) : Measure the distance between stove top and the bottom 1. of range hood. A distance of 28” to 31” is required. Make sure the range hood is level and not tilted. Mark 2. the locations of the hanging bracket holes on the wall as shown in Figure 3A an...

Page 13 - Operation

5. Delay 4.Timing 3. Lighting Press [power], switch on, power key indicator light on, digital tube shows time. Press [power] again to turn off the 1. Switch machine Page 12 Operation The first time the power is on, the buzzer rings once, the switch enters the initialization state, the switch is full...

Page 15 - Troubleshooting

The range hood might not have been secured prop Page 14 Troubleshooting If the range hood does not operate after installa - 1. tion: Check if the range hood has been plugged in, make • sure that all power has been turned back on and all electrical wiring are properly connected. Swap out light assemb...

Page 17 - EMPAVA APPLIANCES INC.

TEL:888-682-8882 EMPAVA APPLIANCES INC. 15253 DON JULIAN RD CITY OF INDUSTRY,CA 91745 WWW.EMPAVA.COM