Emerson TG-0807 - Manual

Table of Contents:

• Page 3 – Technical Guide; TABLE OF CONTENTS; Daniel Series 1500 Liquid Turbine Flow Meter; FOREWORD; for modern liquid measurement requirements.
• Page 4 – TURBINE METER PARAMETERS; thus further improvements in measurement accuracy is possible.
• Page 5 – THE DANIEL; UMBs are also 90o electrically out of phase.; Flow Computer
• Page 6 – Daniel; TURBINE METER THEORY; of the volume measured.; FLOW RATE IS PROPORTIONAL TO ANGULAR VELOCITY; proportional to flow rate.; Figure 3 - Liquid Turbine Flow Meter Cross Section
• Page 7 – PATENTED* FLOATING ROTOR; reverse flow direction is reduced.; Figure 4 - Rotor Assembly Cross Section
• Page 8 – Surge And Pressure Relief Valves; MAGNETIC PICKOFF OF ROTOR VELOCITY; permanent magnet in the pickoff coil.; Figure 5 - Assembly of Daniel
• Page 9 – TURBINE METER ROTOR AND BEARING DESIGN; are both upstream and downstream hangers.
• Page 10 – RIMMED ROTORS FOR HIGHER RESOLUTION; The Daniel
• Page 11 – DANIEL; space at a load rack.; Liquid Turbine Flow Meter
• Page 12 – USGPM
• Page 13 – Standard; ” and 1.5” Stainless Steel; Viscosity and Specific Gravity
• Page 14 – suited to those applications where downtime is unacceptable.; Deflector Ring
• Page 15 – minimum to extended maximum flowrange.; Low specific gravities or high viscosities will reduce
• Page 16 – Size
• Page 17 – RANGEABILITY OF LIQUID TURBINE FLOW METERS; range will be affected.
• Page 19 – METER PERFORMANCE IN HIGH VISCOSITY LIQUIDS; Nominal Line Sizes; Sizing Ratio; may increase the wear rate of the turbine.
• Page 20 – INSTALLATION AND OPERATING RECOMMENDATIONS; Manual of Petroleum Measurement Standards, Chapter 5, Section 3.; Figure 11 - Small Diameter; ready access to the straightening vanes is afforded. (See Figure 13)
• Page 21 – where space is at a premium.; BACK PRESSURE; The necessary back pressure required is given by the equation:
• Page 22 – The turbine pickoff coil has a high impedance and