Emerson ROSEMOUNT NGA2000 HFID- User Manual

Emerson ROSEMOUNT NGA2000 HFID

Emerson ROSEMOUNT NGA2000 HFID– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
86 Page 86
87 Page 87
88 Page 88
89 Page 89
90 Page 90
91 Page 91
92 Page 92
93 Page 93
94 Page 94
95 Page 95
96 Page 96
97 Page 97
98 Page 98
99 Page 99
100 Page 100
101 Page 101
102 Page 102
103 Page 103
104 Page 104
105 Page 105
106 Page 106
107 Page 107
108 Page 108
109 Page 109
110 Page 110
111 Page 111
112 Page 112
113 Page 113
114 Page 114
115 Page 115
116 Page 116
117 Page 117
118 Page 118
119 Page 119
120 Page 120
121 Page 121
122 Page 122
123 Page 123
124 Page 124
125 Page 125
126 Page 126
127 Page 127
128 Page 128
129 Page 129
130 Page 130
131 Page 131
132 Page 132
Page: / 132

Table of Contents:

  • Page 2 – OTICE
  • Page 3 – ONTENTS; REFACE; Glossary; ECTION
  • Page 6 – Warranty
  • Page 7 – IGURES
  • Page 8 – ABLES
  • Page 9 – personal injury or property damage if the warning is ignored.; NOTE; WARNING: ELECTRICAL SHOCK HAZARD
  • Page 10 – WARNING: POSSIBLE EXPLOSION HAZARD; Consult the factory if flammable samples will be measured.; WARNING: HIGH TEMPERATURE; burner can reach this temperature level.; WARNING: PARTS INTEGRITY
  • Page 11 – CAUTION: PURGE AIR REQUIREMENT; Area classification for the protected enclosure:
  • Page 12 – The Operator Interface plus the Controller Board.
  • Page 13 – Power Supply
  • Page 15 – filtered to <2 microns; WARNING: EXPLOSION HAZARD
  • Page 17 – See Caution below; CAUTION: PRESSURE RELIEF VALVE; F). Severe burns could result from touching
  • Page 18 – Current Operator and Service Training Schedule
  • Page 19 – 48414 Instruction Manual (this document); OMPLIANCES; NAMUR; FM
  • Page 21 – F). The concentration is expressed in ppm or
  • Page 22 – NTRODUCTION
  • Page 23 – IGURE
  • Page 25 – NSTALLATION; WARNING: INSTALLATION RESTRICTIONS; Operating ambient temperature is 15
  • Page 26 – VERVIEW; Purge air and burner air should be supplied from separate sources.
  • Page 27 – WARNING: HIGH TEMPERATURES; C. Make connections to these fittings when; CAUTION: POSSIBLE INSTRUMENT DAMAGE; WARNING
  • Page 28 – CAUTION: PURGE AIR REQUIREMENTS; PECIFICATIONS; He mixed fuel is recommended over H
  • Page 29 – CAUTION: OVER PRESSURE DAMAGE
  • Page 30 – Leak Test
  • Page 31 – FUEL; HFID
  • Page 32 – FRONT VIEW; SIDE VIEW
  • Page 35 – All external gas connections have been leak checked.
  • Page 37 – TARTUP AND; WARNING: PRESSURIZED ENCLOSURE
  • Page 41 – Check and re-adjust the internal pressures if required.; INDING; Calibration gas setup is as follows:
  • Page 42 – select the proper preamp sense resistor.
  • Page 43 – OUTINE
  • Page 45 – RESPONSE; psig
  • Page 47 – AINTENANCE AND; WARNING: QUALIFIED PERSONNEL; OVERVIEW
  • Page 48 – OMPONENT REPLACEMENT
  • Page 50 – VEN; Remove the nuts and ferrules from sample in and sample bypass out.; CAUTION: PREAMP CONNECTORS; connectors on the inner oven front panel.
  • Page 52 – Remove the temperature sensor.
  • Page 53 – Do not
  • Page 54 – WARNING: BURNER CONTAMINATION; Remove screw securing thermal block to burner.
  • Page 56 – Remove the sample jet and gasket from the bottom of the burner base.
  • Page 57 – Installation; new
  • Page 58 – RTD; Disconnect the sample RTD wiring connector, note location.
  • Page 59 – ARTRIDGE; Install replacement cartridge heater, snug down set screw.; HERMOSTAT; Install oven into analyzer module.; AMPLE; Install replacement capillary.
  • Page 62 – Mount replacement board to electronics assembly.
  • Page 63 – Disconnect case temperature sensor cable.
  • Page 64 – Disconnect the two electrical terminals, note location.
  • Page 65 – Disconnect and note location of cables.
  • Page 67 – Disconnect the all tubing and wiring connectors, note locations.
  • Page 69 – Remove the two hex nuts securing module to chassis, remove module.
  • Page 71 – Remove the purge air regulator mounting bracket screws.
  • Page 72 – Install replacement module in reverse order.; LED I; Pull the switch and o-ring out from inside the front panel.
  • Page 78 – AFETY
  • Page 79 – RIFT
  • Page 80 – OISE
  • Page 81 – EPLACEMENT; ENERAL
  • Page 83 – HFID I; DENTIFICATION
  • Page 87 – Rosemount Analytical; ARRANTY
  • Page 89 – Field service and repair facilities are located worldwide.; National Response Center; IELD
  • Page 91 – ADDENDUM; NSTRUCTION; Read this information and note the conflicts.; ENU
  • Page 107 – MENU: 49 CALFACTORSI1
  • Page 110 – MENU: 56 LIGHTFLAMEI1
  • Page 113 – MENU: 66 AMHELPINDEX2
  • Page 132 – OTES
Loading the manual

H

EATED

F

LAME

I

ONIZATION

D

ETECTOR

A

NALYZER

M

ODULE

NGA2000

R

OSEMOUNT

A

NALYTICAL

748414-A

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - OTICE

The information contained in this document is subject to change without notice. This manual is based on the production version of the Heated Flame Ionization Detector Analyzer Module. Hardware and/or software changes may have occurred since this printing. Rosemount Analytical's NGA 2000 system of Mo...

Page 3 - ONTENTS; REFACE; Glossary; ECTION

C ONTENTS 748414-AAugust 1999 i Heated Flame Ionization Detector Analyzer Module Rosemount Analytical NGA 2000 P REFACE Purpose/Safety Summary................................................................................. P1 Glossary ...................................................................

Page 6 - Warranty

C ONTENTS 748414-A August 1999 iv Heated Flame Ionization Detector Analyzer ModuleRosemount Analytical NGA 2000 S ECTION 5. R EPLACEMENT P ARTS 5.1 Replacement Parts ................................................................................... 61 5.1.1 General ....................................

Other Emerson Models