Emerson MA 1200- User Manual
Emerson MA 1200– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ProLink; WARNING
- Page 4 – Install the ProLink II software; To install ProLink II software:
- Page 5 – Connect the PC to the transmitter; Connect the two leads of the signal converter to the appropriate; Transmitter terminals for ProLink II connections
- Page 6 – Transmitter terminals for ProLink II connections (Continued)
- Page 7 – Add resistance if required. Many HART connections require added; Added resistance for ProLink II connections
- Page 8 – Configure the connection and connect; resistors in; Added resistance for ProLink II connections (Continued)
- Page 10 – For all other connection types:; MVD Direct Connect auto-detection limits
- Page 11 – Model 2400S service port auto-detection limits; with output option codes 1 or 3.
- Page 12 – Connect; button. ProLink II will attempt to make the; here are always in effect.
- Page 13 – Converter; in the ProLink II
- Page 16 – Worldwide Headquarters
ProLink
®
II
Installation and Startup
Quick Reference Guide
P/N 20001908, Rev. GA
August 2009
For customer service, phone the support center nearest you:
•
In the U.S.A., phone
800-522-MASS
(800-522-6277)
(toll-free)
•
In Canada and Latin America, phone +1 303-527-5200
•
In Asia:
-
In Japan, phone 3 5769-6803
-
In other locations, phone +65 6777-8211 (Singapore)
•
In Europe:
-
In the U.K., phone 0870 240 1978 (toll-free)
-
In other locations, phone +31 (0) 318 495 555
(The Netherlands)
Customers outside the U.S.A. can also send an email to
Micro Motion customer service at:
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 ©2009, Micro Motion, Inc. All rights reserved. ELITE, ProLink, and the Micro Motion logo are registered trademarks of Micro Motion, Inc., Boulder, Colorado. MVD and MVD Direct Connect are trademarks of Micro Motion., Inc., Boulder, Colorado. Micro Motion is a registered trade name of Micro Motion,...
3 STEP 1. Install the ProLink II software To install ProLink II software: 1. Insert the ProLink II CD-ROM into the PC’s CD-ROM drive. 2. If the setup program does not start automatically, locate and run the SETUP.EXE file. The file is located in the root directory on the CD-ROM (e.g., D:\setup.exe, ...
4 STEP 2. Connect the PC to the transmitter 1. Connect the appropriate signal converter to your PC’s serial or USB port, using adapters as required. • For connections using the Bell 202 physical layer, use the Bell 202–RS-232 signal converter. • For connections using the RS-485 physical layer, use t...
