Emerson 3500 Transmitter - Manual
Emerson 3500 Transmitter – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Hazardous voltage can cause severe injury or death.; CAUTION
- Page 3 – European installations; ATEX Installation Drawings and Instructions; Installation kit; One plug-in connector for power supply wiring; Choosing a location; Install the transmitter where ambient temperature is between
- Page 6 – neighboring unit or from the edge of the rack.
- Page 7 – Positions of guide rails and wiring connectors; Slide the Model 3300/3500 into the rack. Make sure the pins on the
- Page 8 – Connecting input and output wiring; Ground the shields at a single point only.; Input/output wiring terminal card
- Page 10 – Cable Preparation and Installation Guide; Connecting power supply wiring; Connect the ground wire to the middle terminal.
- Page 11 – Power supply wiring terminals
- Page 12 – Micro Motion; Micro Motion Europe; Worldwide Headquarters
Micro Motion
TM
Model 3500 Transmitter
(9-wire) or
Model 3300 Peripheral
Installation Instructions for
Rack-Mount
Quick Reference Guide
P/N 3300995, Rev. C
April 2003
For online technical support, use the EXPERT
2
™ system
at www.expert2.com. To speak to a customer service
representative, call the support center nearest you:
•
In the U.S.A., phone 1-800-522-MASS
(1-800-522-6277)
•
In Canada and Latin America, phone
(303) 530-8400
•
In Asia, phone (65) 6770-8155
•
In the U.K., phone 0800 - 966 180 (toll-free)
•
Outside the U.K., phone +31 (0) 318 495 67
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 BEFORE YOU BEGIN This quick reference guide explains basic installation guidelines for mounting the Micro Motion ® Model 3300/3500 applications platform in a 19-inch (486,2 mm) rack. For information on I.S. applications, refer to Micro Motion ATEX, UL, or CSA installation instructions. For complet...
2 European installations This Micro Motion product complies with all applicable European directives when properly installed in accordance with the instructions in this quick reference guide. Refer to the EC declaration of conformity for directives that apply to this product. The EC declaration of co...
5 STEP 2. Installing guide rails and wiring connectors Guide rails Positions of guide rails and wiring connectors are indicated in Figure 3, page 6. Centers of guide rails should be 27 HP (27 TE) apart, for example, at 1 HP (TE) and 28 HP (TE). Wiring connectors The applications platform is shipped ...
