Electrolux EHGT326X Manual - Free PDF Download

Page 2 - ENGLISH; For Your Safety

2 These instructions are only for the countries stated by the symbol printed on the front cover of this instruction book. During Operation • This appliance has been designed to be operated by adults and children under supervision. Young children MUST NOT be allowed to tamper with the controls or pla...

Page 3 - Guide to Use the instructions; Contents

3 The following symbols will be found in the text toguide you throughout the Instructions: Safety Instructions Step by step instructions for an operation Hints and Tips Environmental information Guide to Use the instructions 1 Rapid Burner - 3,0 kW 2 Auxiliary Burner - 1,0 kW 3 Burner Control Knobs ...

Page 4 - Cleaning and Maintenance

4 If you cannot light the flame even after severalattempts, check the "cap" (Fig. 1 lett. A) and the"crown" (Fig. 1 lett. B) are in the correct position. To put the flame out, turn the knob to the symbol . In the absence of electricity, ignition can occurwithout the electrical device...

Page 5 - Guarantee - After Sales Service

5 Guarantee - After Sales Service Original spare parts This appliance, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. F o ...

Page 6 - Instruction for the Installer; Technical Data

6 Instruction for the Installer The following instructions about installationand maintenance must be carried out byqualified personnel in compliance with theregulation in force. T h e a p p l i a n c e m u s t b e e l e c t r i c a l l ydisconnected before all interventions. If anyelectric supply to...

Page 7 - Electrical Connection

7 The appliance is designed to be connected to 230 Vmonophase electricity supply. The connection must be carried out in compliance withthe laws and regulations in force. Before the appliance is connected: 1. check that the main fuse and the domestic installation can support the load (see the rating ...

Page 8 - Adaptation to different types of gas

8 Replacing the burner injectors 1. Remove the pan supports. 2. Remove the burner's caps and crowns. 3. With a socket spanner 7 unscrew and remove the injectors (Fig. 6), and replace them with the onesrequired for the type of gas in use (see Table 2 ). 4. Reassemble the parts, following the same pro...

Page 9 - Building In

9 Building In These hobs can be inserted in a built-in kitchen unitwhose depth is between 550 and 600 mm. The hobsdimensions are shown in Fig. 8. Fig. 10 F O 0 1 9 9 a a) sealing Fig. 9 550 MIN 591 140 240 490 55 270 40÷50 30 650 MIN. Installation and assembly These hobs can be installed in a kitche...

Page 10 - Possibilities for insertion

10 Kitchen unit with door Proper arrangements must be taken in designing theforniture unit, in order to avoid any contact with thebottom of the hob which can be heated when it isoperated. The recommended solution is shown inFig.11.The panel fitted under the hob should be easilyremovable to allow an ...