Electrolux EFLW317TIW - Manual

5 Important Safety Information Prevent injury and damage to the washer To prevent serious personal injury and damage to the washer:• All repairs and servicing must be performed by an authorized service technician unless specifically recommended in this Use & Care Guide. Use only authorized facto...

6 Features drum light door r eversibility 3 compartment dispenser Adaptive Dispenser™ detergent pack option sanitize stain tr eatment perfect steam wrinkle r elease fast wash 300 Series no no yes no no no no no no no 400 Series no yes no yes no no yes no yes 20 min 500 Series yes yes no yes yes yes ...

7 Pre-Installation Requirements Tools and materials needed for installation: Adjustable pliers Adjustable wrench OR OR AND AND Carpenter’s level Ratchet and socket set 3/8" or 10 mm box wrench Shipping Hardware ˆ Foam shipping support (under wash tub) removed and stored ˆ Shipping bolts and spac...

8 Pre-Installation Requirements Water supply requirements Grounding requirements Drain system requirements Grounding type wall receptacle Power cord with 3-prong grounded plug Do not, under any circumstances, cut, remove, or bypass the grounding prong. 1. The washer MUST be grounded. In the event of...

9 Pre-Installation Requirements Installation in a recess or closet If washer and dryer are installed in the same closet, door ventilation is required: A minimum of 120 square inches (774.2 cm²) of opening, equally divided at the top and bottom of the door, is required. Louvered openings should be lo...

11 Pre-Installation Requirements Washer dimensions * Connection of water inlet hose on steam dryer adds 3/4 in. (2 cm) to installation depth. 1 Power supply cord length on washer approximately 60 inches (152.5 cm). 2 Drain hose length on washer approximately 59 inches (150 cm). 3 Power supply cord l...

12 Installation Unpacking the washer CAUTION EXCESSIVE WEIGHT HAZARD To avoid back or other injury, have more than one person move or lift the washer. IMPORTANT Save styrofoam base and shipping plug for use to help prevent washer damage during any future moves. IMPORTANT DO NOT tip washer upside dow...

13 Installation HOT Water Hose CALIENTE CHAUDE COLD Water Hose FRIA FROIDE x7 Removing shipping hardware Installing hole plugs For 300 Series: Remove all of the following: 4 SHIMS 4 BLACK SPACERS 3 P CLAMPS 4 BOLTS For 400, 500, and 600 Series: Remove all of the following: 4 P CLAMPS 1 SHIPPING FORK...

14 Rubber Washers Must Be Present USE ONLY NEW HOSES Leveling the washer Connecting the water 1. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog the water valve screens and to determine which faucet is hot and which is cold supply. 2. Check ...

16 Installation Removing door assembly 1. Completely open the door to expose all four hinge screws. 2. Remove all four hinge screws with #2 square bit driver. Save for reinstalling later. 3. Hold the door with one hand supporting the handle area and one hand supporting the hinge. While supporting th...

17 Installation 2 1 180 Reinstalling door lock and hole cover 1. Move the plastic cover to the other side of the front panel. Position the cover so the “hook” is at the bottom. Insert hook into lower slot, slide the cover down, and press upper retention tabs into opening until they snap into place. ...

18 Installation Fine Thread x4 2 1 3 4 Connect to Notches 3. Make sure the alignment tabs reengage. Reinstalling door assembly 1. Insert the wiring harness terminal into the terminal cap and wrap the harness into the harness retainer. Verify reversed door operation 1. Test door for free, smooth swin...

19 Controls and Settings This manual covers many models and not all cycles, options, or features listed are available on every model. Consoles shown above for reference only. Your model may differ. 400 SERIES 2 7 1 6 3 9 5 4 10 8 300 SERIES 600 SERIES 500 SERIES 2 7 1 6 9 5 4 10 8 11 2 7 1 6 3 8 5 4...

20 These temperature, spin speeds, soil levels and options are available with the following cycles: heavy duty normal delicates rinse & spin clean washer temp hot   NO OPTIONS A VAILABLE WITH THIS CYCLE. DO NOT LOAD ANY ITEMS IN DRUM DURING SYSTEM CLEAN CYCLE. warm    cold     soil heav...

21 These temperature, spin speeds, soil levels and options are available with the following cycles: heavy duty whitest whites normal delicates 20 min fast wash rinse & spin clean washer temp hot    NO OPTIONS A VAILABLE WITH THIS CYCLE. DO NOT LOAD ANY ITEMS IN DRUM DURING SYSTEM CLEAN CYCLE....

22 These temperature, spin speeds, soil levels and options are available with the following cycles: heavy duty whitest whites normal activewear colors delicates 18 min fast wash rinse & spin clean washer temp sanitize    NO OPTIONS A VAILABLE WITH THIS CYCLE. DO NOT LOAD ANY ITEMS IN DRUM DUR...

23 Settings chart - 600 series washer Controls and Settings These temperature, spin speeds, soil levels and options are available with the following cycles: heavy duty whitest whites normal activewear colors delicates 15 min fast wash rinse & spin clean washer temp sanitize    NO OPTIONS A VA...

24 Controls and Settings Cycle selection Press the power button to turn on the unit. Then, turn the cycle selector in either direction or press the cycles button (dependent on model) to scroll to the desired cycle. The indicator light for that cycle will be illuminated. The estimated cycle time will...

25 Controls and Settings The appropriate washing temperature will automatically be indicated for the cycle selected. To change the preset temperature, press the temp button to scroll to the desired setting. Select a wash water temperature according to fiber content, colorfastness and soil level.To p...

26 Controls and Settings Cycle options Max (on select models), high , medium and low (on some models) spin speeds are available for each cycle. The spin speed and/or duration of final spin vary from model to model and cycle to cycle.Increasing the spin speed will extract more water, decrease drying ...

27 Controls and Settings extra rinse Use this option when additional rinsing is desired to remove excess dirt and detergent. It is recommended for heavily soiled loads or if household members have sensitive skin. wrinkle release (on select models) After the final spin, the washer will perform a “dry...

29 Operating Instructions STEPS TIPS IMPORTANT 1. Sort laundry into loads that can be washed together. • Sort by recommended cycle and water temperature. • Separate white, light, and colorfast items from dark and non-colorfast items. • Separate items that shed lint from items that attract lint. Casu...

30 Operating Instructions STEPS TIPS IMPORTANT 5. Add wash products to dispenser. • Water conditioners, detergent boosters and enzyme products may be added with detergent. • See Adding Laundry Products for detailed information on the use of the product dispensers. • See Adding Laundry Products for d...

31 Operating Instructions Use a low-sudsing, high efficiency detergent to prevent oversudsing in front load washers. Look for this symbol on the detergent label: For best results Detergent, stain treatment (on select models), liquid chlorine bleach and liquid fabric softener will be dispensed at the...

32 Operating Instructions Adding laundry detergent to the three compartment dispenser Liquid or powder detergent • Use the cap or scoop provided by the detergent to add recommended amount of detergent. • Amount of detergent may need to be adjusted for water temperature, water hardness, load size, an...

33 Operating Instructions NOTE From time to time you may see water in the dispenser. This is part of the normal operation of the washer. Adding other wash products • Color-safe bleach, water conditioner, detergent booster and enzyme products may be added with detergent. IMPORTANT DO NOT mix liquids ...

34 Normal Operating Sounds Normal operating sounds You may or may not hear the following sounds from your new washer: A. DRAIN HOSE The washer has a flexible drain hose to carry water from the washer to the stand pipe of your home. You will hear water flowing into your stand pipe. This is a normal p...

35 Stain Removal Guide To reduce the risk of fire or serious injury to persons or property, comply with the basic warnings listed below: • Read and comply with all instructions on stain removal products. • Keep stain removal products in their original labeled containers and out of children’s reach. ...

36 Stain Removal Guide Stain removal suggestions STAIN TREATMENT Adhesive tape, gum, rubber cement Apply ice. Scrape off excess. Place stain down on paper towels. Saturate with prewash stain remover or nonflammable dry cleaning fluid. Baby formula, dairy products, egg Use product containing enzymes ...

37 Care and Cleaning To help prevent odors or humidity accumulation leave the door open with the door stand ventilation feature (on select models) for a few hours after use or whenever the washer is not in use. Inside routine cleaning (preventative) To refresh or clean inside of washer To clean and ...

38 Care and Cleaning 4. Rinse the drawer and inserts with hot tap water to remove traces of accumulated powders and liquids. Large amounts of fabric softener residue may indicate improper dilution or more frequent cleaning is required. 5. To clean the drawer opening, use a small brush to clean the r...

39 Care and Cleaning Inside cleaning (aggressive) In cases where clean washer cycle along with care and cleaning of rubber gasket folds isn’t done, and severe odor or residue buildup have developed, follow the below cleaning procedure to help alleviate the problem. Cleaning procedure-washer drum Ens...

40 Care and Cleaning RV ANTIFREEZE Follow WINTERIZING INSTRUCTIONS for cold weather storage and care. • When washing is completed, wipe top and sides of washer with a damp cloth. • Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers • If the cabinet becomes stai...

41 Rubber Washers Must Be Present Replace Hoses Every 5 Years Care and Cleaning 1. Turn off the water supply to washer to avoid water leaks due to water pressure surges and unforeseen occurrences in the water supply. 2. Disconnect or unplug the electrical power to the washer. 3. Remove excess water ...

42 Troubleshooting PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Blue stains • Undiluted liquid detergent or fabric softener dispensed directly onto fabric. • If caused by detergent, mix 1 cup (240 ml) white vinegar with 1 qt (.95 L) water in plastic container. Soak 1 hour. Rinse. • If cause...

43 Troubleshooting PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Pilling(Fibers ball up and cling to fabric.) • Pilling is normal with synthetic and permanent press fabrics. This is due to abrasion from normal wear. • Use a lint brush or shaver to remove pills. • Use fabric softener in washe...

44 Troubleshooting PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Residue stain buildup in gasket • Moisture in washer.• Use of non-HE detergent. • Overdosing detergent.• Overloading wash drum. • Leaving a wet load set in washer. • Cold water washes which may not completely dissolve and remov...

45 Troubleshooting PROBLEM POSSIBLE CAUSES SOLUTIONS NOISE (Please refer to Normal Operating Sounds) High pitch “jet engine” noise • A certain amount of motor whine is normal during the spin cycle. Rattling and clanking noise • Foreign objects such as coins or safety pins may be in drum or pump. • B...

46 Troubleshooting PROBLEM POSSIBLE CAUSES SOLUTIONS Washer does not start • Electrical power cord may not be plugged in or con- nection may be loose. • House fuse blown, circuit breaker tripped, or a power outage has occurred. • Action of pressing start/ pause button on “touch screen” style console...

48 Limited Warranty For the applicable warranty period as set forth below, as measured from your original date of pur- chase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materi- als or workmanship when such appliance is installed, used and maintained i...