Edelbrock 7798 - Manual
Edelbrock 7798 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Catalog #7798, 7799
Rev. 12/07 - AJ/mc
©2007 Edelbrock Corporation
Brochure #63-0487
BIG BLOCK CHRYSLER VALLEY COVER PLATES
For B and RB Chrysler Engine Blocks
Catalog #7798 & 7799
INSTALLATION INSTRUCTIONS
®
PLEASE
study these instructions carefully before beginning this installation. Most installations can be accomplished with
common tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do
not feel comfortable performing this installation, it is recommended to have the installation completed by a qualified
mechanic. If you have any questions, please call our
Technical Hotline at: 1-800-416-8628
, 7:00 am - 5:00 pm, Pacific
Standard Time, Monday through Friday or e-mail us at
.
IMPORTANT NOTE: Proper installation is the responsibility of the installer.
Improper installation may result in poor performance and engine or vehicle damage.
DESCRIPTION:
These steel Valley Cover Plates are designed to cover the lifter valley of Chrysler big block V8 engines
when Edelbrock Victor Big Block Chrysler cylinder heads #77919 or 77929 are used. A stock sheet-metal valley cover
may not be used with Edelbrock Victor cylinder heads. Part #7798 fits Chyrsler RB (413-426 Wedge-440) engine blocks
and #7799 fits Chrysler B (361-383-400) engines.
KIT CONTENTS:
❑
1
Valley Cover Plate
❑
14 1/4-20 x 1/2” bolts
INSTALLATION PROCEDURE
(
NOTE:
Install the valley cover only AFTER your Edelbrock cylinder heads have been installed.)
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628
E-Mail: [email protected]
1. Be sure that the mating surfaces of the block and the surface of the cylinder heads that will meet the valley
cover are thoroughly clean and free of any oils or debris before installation. Use alcohol or lacquer thinner
on a lint-free rag to clean.
2. Apply a continuous, 1/8” bead of automotive RTV silicone sealer to the end sealing surfaces on block and
along bottom of intake flange on the cylinder head where it will meet the valley cover.
3. Pay special attention to the corners of the cylinder heads where they meet the end seal surfaces (Use a
bit more silicone here).
4. Position the valley cover in place on the engine and install the supplied bolts.
5. Tighten bolts to 10-12 ft./lbs., starting in the center and working your way to the ends.
6. Place the intake manifold in position and torque manifold bolts to 25 ft. lbs., following the factory torque
sequence.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
