Edelbrock 72000 - Manual

Catalog #s 72000, 72001, 72002, 72050, 72051, 72052, 72054
Rev. 6/07 - DC/mc

©2007 Edelbrock Corporation

Brochure #63-0453

PERFORMER, PERFORMER RPM, & VICTOR PRO SOLENOIDS

Catalog #s 72000, 72001, 72002, 72050, 72051, 72052, & 72054

INSTALLATION AND MAINTENANCE INSTRUCTIONS

Please study these instructions carefully before installing your new Edelbrock Performer, Performer RPM, & Victor Pro Solenoids. If
you have any questions, contact our

Technical Hotline at: 1-800-416-8628

, 7 am to 5 pm, Monday-Friday, Pacific Standard Time

or e-mail us at

[email protected]

. Please fill out and mail your warranty card.

Solenoid Description

Part Number

HP Level

Performer Fuel

#72050

Up to 200 hp

Performer Nitrous

#72000

Up to 150 hp

Performer RPM Fuel

#72051

Up to 400+ hp

Performer RPM Nitrous

#72001

Up to 300+ hp

Victor Pro Fuel

#72052

Up to 400+ hp

Victor Pro Nitrous

#72002

Up to 500+ hp

Alcohol Fuel Solenoid

#72054

Up to 600 hp

Solenoids are used to control nitrous and fuel flow into the engine. They each contain seals specifically made for compatibility with
nitrous oxide or fuel. The sealing materials for nitrous oxide and fuel are not interchangeable. Each solenoid has been tested to
ensure superior sealing traits, while enhancing flow through proper matching of the orifice to seal relationship.

Edelbrock Performer and Performer RPM systems offer a filter fitting for

nitrous oxide

. It is integral to the inlet fitting. Check this

filter often for foreign objects and contaminants, and clean when necessesary.

Edelbrock Performer systems include a canister

fuel

filter that is the inlet fitting. Check this filter often, and change it on at least a

yearly basis. Performer RPM systems rely on a customer supplied fuel filter capable of filtering fuel with high pressure and high flow.

NOTE:

Remember to use thread sealing paste ONLY on pipe threads. DO NOT use thread sealing tape.

Solenoid Safety Information

1.

Keep solenoid and fuel/nitrous lines away from exhaust components.

2.

Trial fit the solenoids with all lines attached to ensure a proper fit. Solenoids may be mounted sideways or upside-down if
necessary.

Nitrous/Fuel Solenoid Installation

1.

Remove old solenoid, paying close attention to wiring locations.

2.

Hold the solenoid securely (such as in a bench vise), being careful not to damage the solenoid or block the inlet or outlet of the
solenoid.

3.

Install the inlet fitting (blue for nitrous, red for fuel) using thread sealing paste in the “in” port of the solenoid.

4.

Install the outlet fitting (blue for nitrous, red for fuel) using thread sealing paste in the “out” port of the solenoid.

5.

Remove the solenoid assembly from the vise.

6.

Attach the solenoid mounting bracket to the bottom of the solenoid

7.

Verify desired mounting location and install the solenoid. If the solenoid mounting location is difficult to access, leave the
solenoid loose to provide access to the inlet and outlet ports.

8.

Re-attach fuel and nitrous supply lines and reconnect wires from the electrical system.

10. Check for leaks.

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 1-800-416-8628

Tech Fax: (310) 972-2730

E-Mail: [email protected]