Edelbrock 5711 - Manual

Brochure #63-5711

Rev. 8/07 - DA/mc

Page 1 of 2

©2007 Edelbrock Corporation
Catalog #5711

Edelbrock Cat-back Exhaust System

Catalog #5711

for 2007-2008 1500 Standard, Extended, & Crew Cab with

Short Bed (New Body Style)

Pick-Up, 4.8L & 5.3L V8, 2 & 4 W/D

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Cat-back Exhaust System. If you have any questions,
contact our

Technical Hotline at: 1-800-416-8628

, 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at

[email protected].

Suggested Tools for Installation:

❑

3/8" ratchet set with SAE and metric sockets

❑

9/16” & 15mm wrench

❑

Jackstands and jack

❑

Liquid penetrant and rubber lubricant

DISASSEMBLY

1. Raise vehicle and support with proper jackstands for

the weight, leaving the suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts and bolts.

Note:

Some GM Trucks have a brace bar attached to

the left and right side frame rails. Remove bolt and
swing bar out of the way during installation.

4. Remove the bolts and clamps from the system and

lubricate the rubber hangers.

5. Use a pry bar to pull the rubber isolators off of the

pipe hangers.

6. Remove the old system. In some cases, you will find

it easier to cut the overaxle pipe to remove it.

ASSEMBLY

1. Bolt I-Pipe to factory outlet flange (behind catalytic

converters). Install hanger clamp assembly #23-
4099 onto I-pipe and engage hanger bar into OE
isolator and snug the clamp.

Note:

Do not tighten

flange bolts at this time, (snug only).

2. Slip the muffler onto the intermediate pipe with a

3" band clamp on the front.

Note:

Inlet end of

muffler is marked. Snug the clamp so you can adjust
the system later.

3. Install a 3” band clamp onto the outlet of the muffler.

Slip the overaxle pipe into outlet of muffler.

4. Install hanger clamp assembly #23-4100 behind

band clamp and engage into OE isolator.

Install

hanger clamp assembly #23-4042 onto outlet end of
overaxle pipe and engage into OE isolator. Snug
clamps for adjustments later.

5. Slip tailpipe onto overaxle pipe, and install 3” band

clamp.

6. Working from the front of the system, align and

tighten each pipe from the cat-back.

7. Check for clearance to body, frame, suspension and

driveline as you tighten the system from front to rear.

8. Re-attach the brace bar to frame rail (if equipped).

9. Check for leaks and correct, if any are found.

WARNING!!!

Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.