Edelbrock 5282 - Manual
Edelbrock 5282 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©2005 Edelbrock Corporation
Brochure No. 63-0482
Page 1 of 3
Catalog #5282
Rev. 12/05 - DA/mc
ADJUSTABLE TORQUE ARM
for 1984-2002 Camaro / Firebird
Catalog #5282
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new adjustable torque arm. If you have any questions,
please contact our
Technical Hotline at: 1-800-416-8628
, 7:00 am to 5:00 pm, Monday through Friday, Pacific
Standard Time or e-mail us at
. Please fill out and mail your warranty card.
IMPORTANT NOTE: Proper installation is the responsibility of the installer.
Improper installation may result in poor performance and engine or vehicle damage.
Application:
This torque arm is designed to fit 1984-2002 Camaro and Firebird with 1) US built, GM corporate 10 bolt
rear ends that have 7 ½" or 7 5/8" ring gear and, 2) with front torque arm locator lips facing away from driveshaft
(
See Fig. 1).
Fig. 1
PREPARATION CHECKLIST, TOOLS, AND EQUIPMENT REQUIRED:
❑
4 Post drive on vehicle lift recommended, or
❑
Drill with &/32 drill bit or grinder (to remove
❑
Floor jack and 4 properly rated jackstands
rivets)
❑
13mm, 15mm, 21mm, & 15/16” sockets and wrenches
❑
1-1/8” crows foot wrench (to properly
❑
Torque wrench
re-torque adjuster sleeve jam nuts)
❑
Magnetic angle finder gauge
❑
Thread locking compound
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
