Edelbrock 5255 - Manual
Edelbrock 5255 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©
2005 Edelbrock Corporation
Catalog #5255
Brochure #63-0470
Rev. 11/05
Page 1 of 2
Edelbrock Adjustable Trailing Arms
Catalog #5255
1979-2004 Mustang
Installation Instructions
Please
study these instructions carefully before installing your new Adjustble Trailing Arms. If you have any questions,
contact our
Technical Hotline at: 1-800-416-8628
, 7 am to 5 pm, Monday-Friday, Pacific Standard Time or
e-mail us at [email protected].
Tools and Supplies Required:
❑
Floorjack
❑
Jackstands
❑
Tire chocks
❑
Lug wrench
❑
18mm socket, combination wrench, and torque wrench
❑
Blue Loctite™
❑
Grease gun
REMOVAL OF STOCK TRAILING ARMS
1. Place car on level surface and place tire chocks in front of and
behind front tires
(Figure 1).
2. Support rear of the car on jackstands and remove the rear
wheels.
3. Place a floor jack under the differential and lift up slightly to
remove tension from the trailing arm bolts - make sure not to lift
the car off the jackstands
(Figure 2).
KEEP FLOOR JACK UNDER CAR DURING THE COMPLETE
REMOVAL AND INSTALLATION PROCEDURE.
CAUTION
- DO NOT REMOVE BOTH TRAILING ARMS AT THE
SAME TIME OR THE AXLE WILL ROTATE AND THE TRAILING
ARM INSTALLATION WILL BE MUCH MORE DIFFICULT.
4. Start with either trailing arm and remove the rear bolt.
Note:
Re-install the bolts in same direction as original.
5. Remove the front trailing arm bolt.
6. Remove the trailing arm.
7. Clean frame at trailing arm pivot area with a wire brush.
Fig. 1
Fig. 2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
