Edelbrock 5220 - Manual
Edelbrock 5220 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©2007 Edelbrock Corporation
Brochure #63-0420
Rev. 9/07 - DA/mc
EDELBROCK ADJUSTABLE PANHARD ROD
for 2005-2008 Ford Mustang
Catalog #5220
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Panhard Rod. If you have any questions or problems,
please contact our
Technical Hotline at: 1-800-416-8628
, 7:00 am to 5:00 pm, Monday through Friday, Pacific
Standard Time or e-mail us at
.
Application:
Designed for 2005-2008 Ford Mustang to re-center the rear axle after changing the ride height.
Suggested Tools for Installation:
❑
Jack and proper load rated jackstands
❑
18mm and 21mm combination wrenches
❑
18mm and 21mm 1/2” drive sockets and ratchets
❑
Large screw driver
1.
Raise vehicle and support with jackstands on a stable surface.
Note:
Vehicle must be supported with vehicle’s normal weight on rear axle.
2.
Remove bolts at each end of the stock panhard rod and remove stock panhard rod. Inspect hardware, and
replace, if needed.
3.
Clean hardware and panhard rod mounting brackets, as needed.
4.
Using supplied teflon grease coat the sides of the polyurethane bushings.
5.
Install the Edelbrock panhard rod using the stock hardware. Use one drop of blue locktite on clean bolt threads
and torque to 50 ft.lbs.
Note:
Your new adjustable panhard rod is to be installed with the adjuster sleeve on the driver’s side of the
vehicle.
6.
Edelbrock panhard rod are greased during assembly, but it is a good idea to grease the bushings after installation
and during normal service.
7.
Your new adjustable panhard rod comes adjusted to stock length. To adjust, simply loosen the two jam nuts and
turn the adjuster sleeve until the rear-end is centered. To check, measure from the tire sidewall to the fender lip.
Both sides should be the same.
Kit Contents
Qty.
Part #
Description
❑
1
25-4079
Panhard Rod Assembly
❑
1
40-5032
Tube Teflon Grease
INSTALLATION INSTRUCTIONS
Edelbrock Corporation, 2700 California Street, Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Tech E-Mail: [email protected]
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
