Edelbrock 3565 - Manual

Edelbrock 3565

Edelbrock 3565 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – MANIFOLD ASSEMBLY CONTENTS; hose; PERFORMER MULTI-POINT EFI; Description; SUGGESTED TOOLS AND MATERIALS FOR INSTALLATION
  • Page 3 – You must use; When filling out your information card, please print clearly.; SERVICE NUMBER; Typical ECM Label; AWHF
  • Page 4 – INSTALLATION INSTRUCTIONS; • APPLICATION; pico injectors. These are half the size of conventional style
  • Page 5 – INSTALLATION PROCEDURE; Coolant; Alternator
  • Page 6 – DISTRIBUTOR REMOVAL; Remove plug wires from top of distributor cap. Make; note; of; MANIFOLD REMOVAL
  • Page 7 – INTAKE PREPARATIONS; If any of the holes in the manifold are not used, plug them; MANIFOLD INSTALLATION; Some grinding on the bracket ears and on the rear of the; New EGR
  • Page 8 – THERMOSTAT AND HOSES
  • Page 9 – HEATER HOSE SUPPLY LINE; Place fuel rail with pressure; FUEL LINE CONNECTION; Be careful
  • Page 10 – FUEL RETURN LINE INSTALLATION; This may be left or right side, depending on year and; NOTE: Carefully flush out all debris after cutting lines!; From Regulator on; THROTTLE BRACKET; Usually the cut will be above the
  • Page 11 – ELECTRICAL CONNECTION
  • Page 12 – Route hose and cut as necessary to; THROTTLE BODY CONVERSION; Install and; ACCESS FUEL TANK; On trucks with dual tank set-; Dual Tanks Require Kit #3580; Ground
  • Page 13 – FUEL PUMP ASSEMBLY; Now disconnect; ALTERNATE PROCEDURE: LOWERING FUEL TANK; You may want to replace the fuel sock at this time with a
  • Page 14 – Some; New Hose; Make electronic
  • Page 15 – INITIAL START UP
  • Page 16 – Edelbrock Corporation • 2700 California St. • Torrance, CA 90503; Stroker motors are not supported.
Loading the manual

Catalog #3562, 3563, 3564, 3565
Rev. 3/06

Page 1 of 16

©2006 Edelbrock Corporation

Brochure #63-0047

PERFORMER MULTI-POINT EFI SYSTEMS

for TBI-Equipped Chevrolet/GMC Trucks & Suburbans

Catalog #s 3562, 3563, 3564, and 3565

INSTALLATION INSTRUCTIONS

®

STOP!

BEFORE BEGINNING INSTALLATION,

READ THESE IMPORTANT NOTES…

You must purchase a separate Edelbrock Fuel Pump Kit for this installation; single fuel tank
vehicles use Edelbrock #3581, dual-tank vehicles use #3580.

Check the Kit Contents and Suggested Tools lists on page 2 to be sure that you have all
items necessary to finish installation.

Make sure this kit is for your vehicle.

The kits are designed to work with stock engines with stock compression ratios. The
#3564 and #3565 are designed to work with the GM #12371054 502 c.i.d. crate engine.

You must change your computer chip for this kit to function on your vehicle and be
emissions legal. Complete the Chip Information Card and return to Edelbrock. We will send
the computer chip within the continental U.S., free of charge via UPS second day air. Orders
outside of the continental U.S. will be shipped via the best method at the same costs as
continental UPS second day air. If requested, customers may pay for expedited shipping
by providing a current Visa or Master Card.

Your vehicle’s wiring harness and electronics must be in good shape or you may not get
maximum performance and/or may experience problems. The TBI will work with less
adequate connections, but the Performer Multi-Point EFI System is much more sensitive
than a stock TBI.

Read all instructions before beginning installation.

Note that fuel tank or bed of pick-up must be removed.

1987-1991 vehicles with cruise control MUST use Edelbrock throttle/cruise/kickdown
cable bracket #8031. Order from your Edelbrock dealer before beginning installation.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - MANIFOLD ASSEMBLY CONTENTS; hose; PERFORMER MULTI-POINT EFI; Description; SUGGESTED TOOLS AND MATERIALS FOR INSTALLATION

MANIFOLD ASSEMBLY CONTENTS Catalog #3562, 3563, 3564, 3565Rev. 3/06 Page 2 of 16 ©2006 Edelbrock Corporation Brochure #63-0047 Qty. Description ❑ 1 Manifold assembly (see detail below) ❑ 1 Installation instructions ❑ 1 EPROM adapter circuit board (#3562 only) ❑ 1 Fuel injector wiring harness ❑ 1 Fue...

Page 3 - You must use; When filling out your information card, please print clearly.; SERVICE NUMBER; Typical ECM Label; AWHF

Catalog #3562, 3563, 3564, 3565Rev. 3/06 Page 3 of 16 ©2006 Edelbrock Corporation Brochure #63-0047 IMPORTANT INSTRUCTIONSFor ordering your FREE Edelbrock computer chip. You must use an Edelbrock chip with the Performer Multi-Point EFI conversion ® You must change the computer chip in your stock com...

Page 4 - INSTALLATION INSTRUCTIONS; • APPLICATION; pico injectors. These are half the size of conventional style

Catalog #3562, 3563, 3564, 3565Rev. 3/06 Page 4 of 16 ©2006 Edelbrock Corporation Brochure #63-0047 ® INSTALLATION INSTRUCTIONS for Performer Multi-Point EFI System for 7.4L TBI-Equipped Chevrolet/GMC Vehicles Catalog #3562 and #3564 for 1987-1990 Model Years Catalog #3563 and #3565 for 1991-1995 Mo...

Other Edelbrock Models

All Edelbrock Other