Edelbrock 207-2 - Manual
Edelbrock 207-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©2007 Edelbrock Corporation
Rev. 4/07 - BC/FA/mc
Catalog #207-2
Brochure #63-207-2
Catalog #207-2
Russell ProClassic Hose & Full Flow Hose Ends
ASSEMBLY PROCEDURE
1.
Cut hose to length, as straight and square as possible, with razorblade-type hose cutter or shears
(See Fig. 1)
.
2.
Unscrew socket from hose end. Push hose into socket, turning counter-clockwise, until hose is seated against step in socket
(See Fig. 2).
Make sure rubber part of hose does not protrude into socket threads.
3.
Apply Russell assembly lube to threads on nipple assembly and in socket
(See Fig. 3)
. Insert nipple into socket/hose and
start threads by hand (clockwise). Hold socket/hose in vise. Turn nipple with wrench until there is less than 1/16” between
nipple hex and socket
(See Fig. 4)
.
4.
Repeat Steps 1-3 for other end of hose.
5.
Flush hose assembly with solvent or soapy water and blow clean with compressed air or let air dry.
Please study this procedure carefully before assembling your new Russell ProClassic Hose and Full Flow Hose Ends. If you have any
questions, please call our
Technical Hotline at: 1-800-416-8628
, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through
Friday or e-mail us at
.
ASSEMBLY PROCEDURE
Fig. 2
Fig. 1
Fig. 3
Edelbrock Corporation, 2700 California Street, Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Tech E-Mail: [email protected]
Fig. 4
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
