Page 2 - INTRODUCTION; OR
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 1 Edelbrock LLC, 2700 California Street, Torrance, CA 90503 Toll-Free Tech Line: 1-800-416-8628 Office/Sales Line: 310-...
Page 3 - result in poor performance and engine or vehicle damage.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 2 Due to the complexity of the Edelbrock E-Force Supercharging system, it is recommended that this system only beinstal...
Page 4 - Hex Flange Bolt; INSTALLATION HARDWARE IDENTIFICATION GUIDE
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 3 Bag #1 Bag #2 (2x) - M8 Washer (3x) - M8 x 1.25 x 20mm Hex Flange Bolt (1x) - M10 x 1.5 x 65mm Hex Flange Bolt (1x) -...
Page 5 - Drill Hole
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 4 Bag #3 (11x) - M8 x 1.25 x 25mm Countersunk Socket Head Bolt (8x) - M6 x 1 x 45mm Hex Flange Bolt (4x) - M6 x 1 x 12m...
Page 6 - Dipstick Grommet
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 5 Bag #5 (4x) - Coil Cover Bracket (1x) - Coil Cover Dipstick Grommet (4x) - Coil Cover Retainer Stud (4x) - Coil Cover...
Page 9 - Disconnect the Mass Airflow Sensor connector.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 8 11. Disconnect the Mass Airflow Sensor connector. 12. Use a flat head screwdriver to loosen the worm clampholding the...
Page 10 - Disconnect the PCV tube from the engine valley cover.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 9 22. Disconnect the two ignition harness connectors, theeight spark plug wires from the ignition coils and the eightfu...
Page 11 - Rotate each solenoid 90° and remove them.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 10 32. Use a pair of hose clamp pliers to loosen the clampretaining the vacuum hose to the brake booster fitting anddis...
Page 14 - Use a 13mm socket to remove the two starter bolts.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 13 63. Use pliers to loosen the hose clamps and disconnectthe two small upper radiator hoses. Use caution whenremoving ...
Page 15 - Reconnect the starter solenoid electrical connector.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 14 79. Use compressed air to clean out any metal flakesthen loosen the bolt and remove the drill guide. 80. Apply red L...
Page 16 - Slide the short section of the Intercooler Hose
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 15 94. Install the water pump to heat exchanger hose on thepassenger side inlet fitting of the heat exchanger andclock ...
Page 18 - Reattach the fuel injector electrical connectors.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 17 116. Use a 10mm universal socket to install the M6 x45mm intake manifold bolts supplied in Bag #3 andtorque them to ...
Page 20 - Replace the stock air filter with the one supplied.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 19 137. Use a 16mm wrench to install the coil coverstandoffs on the valve covers. 138. Use a 10mm socket, the four stoc...
Page 22 - Read disclaimer then press Select to continue.; DO NOT unplug the programmer until prompted.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 21 156. Reconnect the fog light electrical connectors and thefascia wiring harness connector on the passenger side. 157...
Page 23 - Repair any leaks before operating vehicle!; Return the dipstick to the dipstick tube.
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 22 177. Start the car and allow it to idle while closelyinspecting the engine bay for any fuel or coolant leaks. Repair...
Page 25 - Shorty Headers for 2010 Camaro SS:
©2011 Edelbrock LLCPart #1596, 1597, 1598 & 1599 Brochure #63-1598 Rev. 2/11 - AJ/mc Edelbrock E-Force Supercharger System for the 2010 Camaro SS Installation Instructions Page 24 Eibach produces springs with unparalleled precision andquality, using Hi-Ten spring steel produced to exactingtolera...