Edelbrock 15015 - Manual
Edelbrock 15015 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Catalog #15015
Rev. 6/05
©2005 Edelbrock Corporation
Brochure #63-0413
TURBOCHARGER TO EXHAUST MANIFOLD GASKET
(For Turbocharger Kit #s 1500, 1501, 1502, 1503, 1504)
Catalog #15015
INSTALLATION INSTRUCTIONS
PLEASE
study these instructions carefully before beginning this installation. If you have any questions, do not hesitate to contact
our
Technical Hotline at: 1-800-416-8628
, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
DESCRIPTION:
Stainless steel gasket used to seal the turbocharger turbine inlet to the exhaust manifold. It can also be used with
any Garrett T25 or T28 Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: [email protected]
1. When attaching the turbocharger to the exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Catalog #15015
Rev. 6/05
©2005 Edelbrock Corporation
Brochure #63-0413
TURBOCHARGER TO EXHAUST MANIFOLD GASKET
(For Turbocharger Kit #s 1500, 1501, 1502, 1503, 1504)
Catalog #15015
INSTALLATION INSTRUCTIONS
PLEASE
study these instructions carefully before beginning this installation. If you have any questions, do not hesitate to contact
our
Technical Hotline at: 1-800-416-8628
, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
DESCRIPTION:
Stainless steel gasket used to seal the turbocharger turbine inlet to the exhaust manifold. It can also be used with
any Garrett T25 or T28 Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: [email protected]
1. When attaching the turbocharger to the exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
