Page 2 - IMPORTANT - READ CAREFULLY
2 IMPORTANT - READ CAREFULLY The Dixon ® ZTR ® mower is both easy and fun to operate. However, any power mowermust be operated properly to be safe. It isnot a toy or a recreational vehicle. Beforeyou start to use the mower, read thisOperator’s Manual carefully. It containsvaluable information that i...
Page 3 - TABLE OF CONTENTS; Page
3 TABLE OF CONTENTS Page SAFETY & WARNING....................................4-15 WARRANTY........................................................16 SPECIFICATIONS.............................................17 SEAT ADJUSTMENT.........................................18 CONTROLS.....................
Page 4 - SAFETY; Blade Contact; RIDING LAWN MOWERS,
SAFETY 4 Blade Contact Tip Over Run Over Back Over RIDING LAWN MOWERS, IF IMPROPERLY OPERATED CAN CAUSE SERIOUS INJURY OR DEATH Pictured below are the most common causes of injury tothe operator or bystander. Please read and understandthis manual to prevent injuries.
Page 5 - Safety Alert Symbol; When you see this symbol, BE ALERT; DANGER
SAFETY 5 Safety Alert Symbol When you see this symbol, BE ALERT to the potential for injury. Follow the recommended safety precautions and safe operating practices. DANGER (highlighted in red) indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. ...
Page 6 - WARNING; Failure to observe the following safety instructions
WARNING 6 Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: Read, understand, and follow all instructions in thismanual and on the mower before starting. Only allow responsible adults, who are familiar with theinstructions, to operate th...
Page 7 - Mow only in daylight or good artificial light.
WARNING 7 GENERAL OPERATION (continued): Never leave a running mower unattended. Always turn offblades, set parking brake, stop engine and remove keybefore dismounting. Turn off blades when not mowing. Injury could occur fromcontact with moving parts. Under no circumstances should you place hands or...
Page 11 - DO NOT
WARNING 11 SLOPE OPERATION (continued): DO NOT Do not turn on slopes unless necessary, and then,turn slowly and gradually downhill, if possible. Rapiduphill turns may cause tip-over. Do not mow near drop-offs, ditches, or embank-ments. The mower could suddenly turn over if awheel is over the edge of...
Page 12 - Do not smoke while refueling or operating the mower.
WARNING 12 FIRE HAZARDS: Use extra care when handling gasoline and otherfuels. They are flammable and vapors are explosive. Store all fuel in approved containers specificallydesigned for that purpose. Allow engine to cool before refueling. Never removefuel cap or add fuel with engine running. Do not...
Page 14 - Be alert and turn mower off if a child enters the area.
WARNING 14 CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. Keep children out of the mowing area and un...
Page 17 - SPECIFICATIONS
SPECIFICATIONS 17 SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Additional information may be provided elsewhere in this manual. KODIAK ® CHASSIS: 11 GA - rectangular tube SEAT: Designed for operator comfort by use of high-densityclosed cell foam padded back and arm rests, upholsteredwith Cordura ...
Page 18 - SEAT ADJUSTMENT INSTRUCTIONS; Grasp seat slide adjuster and move it
18 SEAT ADJUSTMENT INSTRUCTIONS 1. Grasp seat slide adjuster and move it into adjustment position. 2. Slide seat forward or backward. 3. Release seat slide adjuster.
Page 19 - CONTROLS; CONTROL LEVERS; Note: For access to the seat, move control levers to neutral
CONTROLS 19 CONTROL LEVERS Note: For access to the seat, move control levers to neutral position and swing them outward. TO GO FORWARD•From neutral position, gently push control levers for- ward. •To increase speed, move levers further forward. TO GO BACKWARDS•From neutral position, gently pull cont...
Page 20 - CAUTION
CONTROLS 20 CAUTION MOWER DECK CUT HEIGHT LIFT LEVER: • Located to the right and front of the operator. • Controls the cutting height. • Fifteen positions of adjustment • Depress trigger and move lever forward to lower deck. • Depress trigger and pull lever back to raise deck. Note: Always use high ...
Page 21 - CHOKE AND THROTTLE CONTROL LEVERS:
CONTROLS 21 BLADE DRIVE: •Located on the control panel, on operator’s right.•To engage the mower blade, pull up on the switch.•To disengage mower blade, push down. CHOKE AND THROTTLE CONTROL LEVERS: •Located on control panel to operator’s right.•Throttle control for engine speed.•Choke for engine st...
Page 22 - OPERATION INSTRUCTIONS; BEFORE OPERATING MOWER:; Read engine manufacturer’s operating and
OPERATION INSTRUCTIONS 22 The safe and successful operation of the KODIAK™will depend upon the operator having the correctknowledge of all controls used on the mower andmaking good judgements about the terrain to bemowed. NEVER allow anyone to operate the mower withoutcomplete knowledge of all contr...
Page 23 - STARTING INSTRUCTIONS:
OPERATION INSTRUCTIONS 23 CAUTION Failure to follow these instructions mayresult in personal injury. STARTING INSTRUCTIONS: 1. Parking brake must be on, control levers in outward position and blade drive disengaged. 2. Position throttle to 1/2 speed setting. If engine is cold, position choke lever t...
Page 24 - PARKING BRAKE SWITCH TEST:; TESTING OF SAFETY INTERLOCK SYSTEMS:
OPERATION INSTRUCTIONS 24 PARKING BRAKE SWITCH TEST: a) Swing control levers to outward positionb) Disengage blade drive switchc) Put parking brake in OFF positiond) Turn ignition switch to START Engine should not turn over or attempt to start. CONTROL LEVER SWITCH TEST: a) Disengage blade drive swi...
Page 25 - BLADE DRIVE SWITCH TEST:
OPERATION INSTRUCTIONS 25 TESTING OF SAFETY INTERLOCK SYSTEMS: BLADE DRIVE SWITCH TEST: a) Put parking brake in ON position.b) Swing control levers to outward position.c) Engage blade drive switch.d) Turn ignition switch to START. Engine should not turn over or attempt to start. SEAT SWITCH TEST: a)...
Page 26 - MOWING WITH A MULCHING ATTACHMENT:
OPERATION INSTRUCTIONS 26 MOWING WITH A MULCHING ATTACHMENT: Mulching or recycling the grass clippings requires atotally different mowing approach than would be normalwhen side discharging or bagging the grass. Theremay be instances or conditions where it is not possibleto hide all the recycled or m...
Page 27 - MOWING WITH A MULCHING ATTACHMENT
OPERATION INSTRUCTIONS 27 MOWING WITH A MULCHING ATTACHMENT (continued): 7. Keep the underside of the mower deck clean. Remove all grass and dirt build-up from theunderside of the pan, the baffles and deflectorsafter each use. Never, under any circumstances,should you place hands or feet under themo...
Page 28 - MOWING WITH A GRASS CATCHER
OPERATION INSTRUCTIONS 28 MOWING WITH A GRASS CATCHER ATTACHMENT: In order to achieve optimum performance whenmowing with a grass catching attachment, pleaseread and follow the tips listed below. 1. Read and follow the installation instructions that areincluded with your grass catcher. 2. Set engine...
Page 30 - SIDE DISCHARGE OF THE CLIPPINGS:; Set engine speed control to the wide open or full
OPERATION INSTRUCTIONS 30 SIDE DISCHARGE OF THE CLIPPINGS: In order to achieve optimum performance when sidedischarging the grass clippings, please read and followthe tips listed below. Additional information can befound in the Troubleshooting guide. CAUTION To avoid personal injury, be sure that th...
Page 32 - TOWING TRAILERS AND OTHER ATTACHMENTS:; Towing a trailer or other attachment is not recommended.
OPERATION INSTRUCTIONS 32 TOWING TRAILERS AND OTHER ATTACHMENTS: Towing a trailer or other attachment is not recommended. TO FREE WHEEL MACHINE (Unlock Transmission): Always turn off engine before engaging or disengaging thehydro release (free wheel) lever. Never attempt to move thelever with the en...
Page 33 - Before performing any maintenance, turn off engine,; MAINTENANCE SCHEDULE
CARE AND MAINTENANCE 33 WARNING Failure to observe the following instructions may result in personal injury. Before performing any maintenance, turn off engine, allow to cool & remove key. Use extreme care when working on machinery. Do not wear watch or jewelry. Do not wear loose fitting clothes...
Page 34 - CARE AND MAINTENANCE; CUTTER BLADE MAINTENANCE:; Hold or block blade from
CARE AND MAINTENANCE 34 CUTTER BLADE MAINTENANCE: CAUTION Stop engine and remove ignition keyfor safety. Wear heavy, thick gloveswhen holding onto cutter blade, avoidthe sharp edge of the blade. Blades should be discarded when worn excessively. D A N G E R O U S !DO NOT USEBLADE IN THISCONDITION! W ...
Page 35 - •Charge battery if required.
CARE AND MAINTENANCE 35 ENGINE: For complete maintenance and operating information ofthe engine, please refer to the maintenance instructionsfurnished by the engine manufacturer included in yourZero Turn Radius mower information packet. BATTERY: This is a maintenance-free battery and the fluid level...
Page 36 - Front tires; RECOMMENDED
CARE AND MAINTENANCE 36 TIRES: Correct tire pressure is essential for efficient operationof the mower. Check tire pressure periodically. Inflatetires to the pressure listed below. Front tires 15 lbs. Rear tires 15 lbs. Lug nuts or lug bolts should be checked regularly for tightness. LUBRICATION: CHA...
Page 38 - CHANGING THE ENGINE OIL:; The oil drain valve is located on either side of the
CARE AND MAINTENANCE 38 CAUTION HOT oil may cause burns. Allowengine to cool before draining oil. Hex Head Valve Stem CHANGING THE ENGINE OIL: 1. The oil drain valve is located on either side of the engine crankcase (depending on the type of engineinstalled on your ZTR®). 2. Place a suitable contain...
Page 39 - Clean any spilled oil from engine and chassis.
CARE AND MAINTENANCE 39 HOT oil may cause burns. Allowengine to cool before draining oil. OIL FILL: 1. Clean any spilled oil from engine and chassis. 2. Refill engine with type, and quantity of oil recom- mended by the engine manufacturer in engineliterature. NOTE: Engine oil changes on the KODIAK™ ...
Page 40 - HYDROSTATIC TRANSMISSION FLUID &
CARE AND MAINTENANCE 40 HYDROSTATIC TRANSMISSION FLUID & FILTER SERVICE: Dirt or water in fluid can ruin the hydrostatic transmissions. SERVICE INTERVALS: 1. Initial filter service - 100 hours 2. Every 500 hours or once a year thereafter. RECOMMENDED FLUID: All temperatures - 15W-50 Synthetic Hy...
Page 41 - HYDROSTAT FLUID MAINTENANCE
CARE AND MAINTENANCE 41 HYDROSTAT FLUID MAINTENANCE PROCEDURE: Check the fluid level in hydrostatic transmission fluidreservoir after every 25 hours of usage. Clean the fluidreservoir cap and the area around it prior to removal.Check the fluid level. Fluid should be approximately1/4” below top of fl...
Page 42 - NEUTRAL ADJUSTMENT
CARE AND MAINTENANCE 42 NEUTRAL ADJUSTMENT 1. Lift seat. 2. Block up the unit so that the drive wheels are off the ground. 3. Loosen ball joint jam nuts on control rod. Note: The front jam nuts are left hand threads. 4. With steering control arms in the “out” neutral position, start the engine and r...
Page 43 - Keep all connections clean and tight.
CARE AND MAINTENANCE 43 ELECTRICAL SYSTEMS: Keep all connections clean and tight. CLEANING THE MOWER: Wash mower periodically. Clean above and belowdeck. High pressure washing and alkaline based soaps cancause damage to bearings and other parts of themower. After washing your mower, start the engine...
Page 44 - MOWER DECK LEVELING PROCEDURE:; Turn ignition switch to “OFF” position and remove
CARE AND MAINTENANCE 44 MOWER DECK LEVELING PROCEDURE: Before performing any service or adjustment check list:1. Engage parking brake. 2. Place blade-switch in the disengaged position. 3. Turn ignition switch to “OFF” position and remove key. 4. Make sure blades and all moving parts have com- pletel...
Page 45 - MOWER DECK LEVELING PROCEDURE; If deck leveling cannot be achieved call Technical
CARE AND MAINTENANCE 45 MOWER DECK LEVELING PROCEDURE (continued): 6. Check rear blade measurement, should be 4 1/4” from ground, if not turn locknut on top of rear eyelbolt toachieve measurement. Repeat procedure on oppositeside. 8. If deck leveling cannot be achieved call Technical Support at toll...
Page 46 - TROUBLESHOOTING
46 1. ENGINE WON’T TURN OVER Mower blades engaged- - - - - - - - - - - - - - - - - - - disengage bladesParking brake not on- - - - - - - - - - - - - - - - - - engage parking brakeCircuit breaker trips- - - - - - - - - - - - - - - - - - - - - - - - -reset breakerDead battery- - - - - - - - - - - - - ...
Page 47 - MOWER LOSES POWER OR TRANSMISSION OVERHEATS
47 TROUBLESHOOTING 6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD Drive belt broken or slipping- - - - - - - - - - - - - - - - replace drive beltTransmission oil low- - - - - - - - - - - - - - - - - - - - - - - - - - - - add oilDamaged transmission- - - - - - - - - - - - - - - - - - - - - -consult deal...
Page 48 - ENGINE AIR AND OIL FILTERS; STANDARD SERVICE PARTS LIST; Blades
48 ENGINE AIR AND OIL FILTERS Refer to Engine Operator’s Manual for correct service intervals for engine oil changes and air filter maintenance. Protect your engine investment, use only original equipment filters. Refer to the Engine Operator’s Manual or ask your dealer for correct replacement parts...
Page 49 - OWNER’S INFORMATION; Date of Purchase
OWNER’S INFORMATION Date of Purchase Mower Model Number Mower Serial Number Purchased From Name Address DATE OIL CHANGED DATE ENGINE TUNED Dixon~401 N. Commerce St. Beatrice, NE 68310
Page 50 - Dixon® and ZTR® are registered trademarks of Dixon
Dixon® and ZTR® are registered trademarks of Dixon DIXON401 N. Commerce St..Beatrice, NE 68310 KODIAK ® Part No. 114518Rir - 11/07/06 The engine exhaust from this product containschemicals known to the State of California to causecancer, birth defects or other reproductive harm. WARNING:
