Directed Electronics 5101 - Manual

1 © 2009 Directed Electronics. All rights reserved. What’s included Two five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control Center with integrated status LED and Control button • A remote start defeat toggle switch • Window decals • Your warranty registration ...

2 © 2009 Directed Electronics. All rights reserved. ➢ System maintenance The system requires no specific maintenance. Your remote is powered by a small coin cell lightweight 3-volt lithium battery that lasts approximately one year under normal use. The remote uses one CR2032 cell battery. When the b...

3 © 2009 Directed Electronics. All rights reserved. Turn both the unit 2. front and circuit board over, remove battery from clip and replace. Note: Verify that the bat- tery polarity is correct when replacing. Reposition all parts and snap together. 3. ➢ Two car operation You can use the remote cont...

4 © 2009 Directed Electronics. All rights reserved. 1-way remote 1 3456 2 A U X Feature Description 1 Transmit indicator 2 Lock button Press for one second to lock. 3 Unlock button Press for one second to unlock. 4 Remote start button Press for one second to activate remote start. 5 Auxiliary button...

5 © 2009 Directed Electronics. All rights reserved. ➢ Transmitter configuration Basic Commands Advanced Commands Function Level 1 Function Level 2 Function Level 3 Function Level 4 Button Level Direct Access A U X x 1 A U X x 2 A U X x 3 A U X x 4 A U X Lock Silent Lock A U X Unlock Silent Unlock Va...

6 © 2009 Directed Electronics. All rights reserved. Control Center The Control Center, typically located on the upper part of the front windshield sends and receives commands or messages to and from your system. It consists of: The In-vehicle system antenna, for 1-way communication to the system. • ...

7 © 2009 Directed Electronics. All rights reserved. Basic commands ➢ Lock A U X Command : Press one time to Lock. Notes: Press/hold for 1.5 seconds to lock the system and then activate the Panic output. For Panic to work, the optional horn honk feature must be connected. ➢ Unlock A U X Command : Pre...

8 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 1 ➢ Silent lock Command : Press A U X one- time and then press A U X Notes : Locks the system without horn honks* ➢ Silent unlock Command : Press A U X one- time and then press A U X . Notes : Unlocks the system wi...

9 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 2 ➢ Valet mode Command : Press A U X two-times and then A U X . Notes: Prevents the system from automatically activating the Failsafe Starter Kill and locking the door passively. ➢ Timer mode Command : Press A U X ...

10 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 3 ➢ Car finder Command : Press A U X three-times and then A U X . Notes : The vehicle emits 1 long horn honk and the parking lights flash 10 times. Lock/Unlock cancels the parking light flashes. ➢ Smart start Comm...

11 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 4 ➢ Rear defogger* Command : Press A U X four times, and then A U X . (after remote start is on.) Notes : Manually turns on the defogger when remote start is on. ➢ Aux 4 Command : Press A U X four times and then p...

12 © 2009 Directed Electronics. All rights reserved. Using the system ➢ Locking the vehicle To lock the vehicle, press the button on the remote control. The horn in the vehicle honks one-time, and the parking lights flash one-time. If the power door locks are connected, the doors lock and the option...

13 © 2009 Directed Electronics. All rights reserved. ➢ Valet mode You can prevent your system from automatically activating the Failsafe® Starter Kill. When the system is in Valet mode, the feature is disabled. The doors do not automatically lock. This is useful when washing or having the vehicle se...

14 © 2009 Directed Electronics. All rights reserved. ➢ Configuring your remote The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See Button Auto Lock ) To configure the remote user features: Press and hold the 1. A U X button on the remo...

15 © 2009 Directed Electronics. All rights reserved. ➢ Programming To enter: hold the A U X button for 8 seconds, the transmit LED turns on, the pro- gramming main menu has been accessed. To exit: press and release the A U X button to go back and repeat to exit. The transmit LED turns off when progr...

16 © 2009 Directed Electronics. All rights reserved. Placing the remote into the remote pair mode: Press and hold the 1. button for 8 seconds. If the transmit LED flashes at 3 seconds, disregard and continue to hold.Wait for the Transmit LED to light solid. Release the 2. button. Press the 3. AUX AU...

17 © 2009 Directed Electronics. All rights reserved. Using the remote start Read this user guide, including the Warnings section at the beginning of this guide before using the remote start . Ensure that the vehicle is parked in an open area, not in a garage. To use your remote start to pre-warm or ...

18 © 2009 Directed Electronics. All rights reserved. ➢ Manual transmission vehicles When installed into a manual transmission vehicle, the system requires that the MTS mode is properly set when parking. If MTS mode is not properly set or is defeated after being properly set the system will not start...

21 © 2009 Directed Electronics. All rights reserved. After exiting the vehicle, lock the system. The vehicle remains running for the programmed runtime. (The remote start feature is still enabled).You can still remote start the vehicle after the turbo timer has timed out and shut Off the vehicle. Fo...

22 © 2009 Directed Electronics. All rights reserved. Use one of the below methods to exit Smart Start mode: Perform the same steps you followed to activate Smart Start mode • Turn the ignition On • Press the brake pedal • The parking lights flash 5 times slowly to confirm the remote has exited Smart...

23 © 2009 Directed Electronics. All rights reserved. ➢ Pit Stop mode The Pit Stop mode feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you want to exit and lock the vehicle for short periods of time, but would l...

24 © 2009 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. ➢ Optional starter anti-grind circuitry Whenever the vehicle is remote started...

25 © 2009 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit. ➢ Locking If the system is locked at the same time that the door input is active, you will hear one horn honk to i...

26 © 2009 Directed Electronics. All rights reserved. Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user. This feature is only available to authori...

27 © 2009 Directed Electronics. All rights reserved. Programming options Your system has many custom programmable options. Some may require instal- lation labor. Ask your authorized dealer for details. The following is a list of the programmable options, with the factory settings in Bold . Active • ...

28 © 2009 Directed Electronics. All rights reserved. Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Power Trunk Release: The accessory output of the system can operate a facto...

29 © 2009 Directed Electronics. All rights reserved. Glossary of terms Control Center: The Control Center contains the system’s radio-frequency antenna, the Control button, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windshield, cente...

31 © 2009 Directed Electronics. All rights reserved. Quick reference guide Locking • To lock press for one second. The doors lock. The LED on the Control Center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking. Unlocking • To unlock press 1 3456 2...

33 © 2009 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding withou...

G4102V 2009-08 Vista, CA 92081 www.directed.com © 2009 Directed Electronics—All rights reserved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and acce...